- Practice
- About 15 min
- 5 practice questions
Regelation and the anomalous behaviour of water
Explain regelation, describe how water contracts between 0 °C and 4 °C, interpret Hope's apparatus, and use the anomalous behaviour of water to explain why lakes freeze from the top and pipes burst.
If something looks wrong, please tell us.
By the end of this lesson you can
- Explain regelation and how pressure lowers the melting point of ice.
- Describe the anomalous behaviour of water between 0 °C and 4 °C.
- Explain what Hope's apparatus shows, and why aquatic life survives in frozen lakes.
Water is the most familiar liquid, yet it behaves in two surprising ways. Ice can melt under pressure even below 0 °C, and water near its freezing point does the opposite of what most liquids do when cooled.
Regelation
Rest a slab of ice on a stand and hang a thin metal wire over it with equal weights on both ends. Slowly the wire cuts its way down through the ice and comes out at the bottom, yet the slab does not break into two pieces.
Why? Pressure lowers the melting point of ice below 0 °C. Under the wire, where the pressure is high, the ice melts even at 0 °C. The water flows above the wire, where the pressure is normal again, so the melting point returns to 0 °C and the water freezes again, giving out its latent heat. The phenomenon in which ice melts under pressure and refreezes when the pressure is removed is called regelation.
Regelation explains why two ice cubes pressed together stick to each other, and how shaved ice pressed hard around a stick forms a solid ice-gola.
Anomalous behaviour of water
Most liquids expand when heated and contract when cooled. Water does too, except between 0 °C and 4 °C. When water at 0 °C is heated, it contracts until 4 °C; above 4 °C it expands like other liquids. So the volume of a given mass of water is minimum at 4 °C, which means its density is maximum at 4 °C. This exceptional behaviour is called the anomalous behaviour of water.
Water has its minimum volume and maximum density at 4 °C. Cooling water below 4 °C makes it expand, not contract.
Hope's apparatus
Hope's apparatus is a tall metal cylinder of water with a bowl fixed around its middle. The bowl holds a freezing mixture of ice and salt. Thermometer T₁ reads the temperature near the bottom and T₂ near the top. Readings are taken every 30 seconds.
What happens in Hope's apparatus
- Water at the middle is cooled Above 4 °C, colder water is denser, so it sinks.
- T₁ (bottom) falls quickly to 4 °C T₂ (top) falls only slowly. T₁ then stays at about 4 °C.
- Water cooled below 4 °C becomes lighter It expands, its density falls, and it rises to the top.
- T₂ (top) falls quickly to 0 °C The top reaches 0 °C first; T₁ reaches 0 °C later.
Worked example 1: life under a frozen lake
In very cold regions the air may be well below 0 °C. The surface water of a lake cools and sinks while it is above 4 °C. Once the whole lake is at 4 °C, water at the surface cooled further becomes lighter and stays on top, where it finally freezes. Ice is lighter than water, so it floats and forms a layer on the surface. Ice is a poor conductor of heat, so it insulates the water below, which stays at about 4 °C. Fish and water plants survive in this water under the ice.
Worked example 2: burst pipes and cracked rocks
In cold regions in winter, water in pipes cools below 4 °C and then freezes. Both steps make it expand. The expanding water and ice push hard on the pipe walls, and the pipes can burst. Similarly, water trapped in cracks in rocks expands on freezing and slowly widens the cracks until the rocks break.
Key takeaways: pressure lowers the melting point of ice, so ice melts under pressure and refreezes when it is removed (regelation). Water contracts from 0 °C to 4 °C and is densest at 4 °C. Hope's apparatus shows this. This behaviour keeps aquatic life alive under ice and makes freezing water burst pipes and crack rocks.
Check your understanding
-
1. A loaded wire passes through a block of ice, but the block stays in one piece. This is due to:
- Anomalous expansion
- Regelation
- Evaporation
- Specific heat
Show answer
Answer: B. Under the wire the pressure lowers the melting point, so ice melts; above the wire the pressure is removed and the water refreezes. This is regelation.
-
2. What is the effect of increased pressure on the melting point of ice?
- It lowers the melting point
- It raises the melting point
- It has no effect
- It makes the melting point exactly 4 °C
Show answer
Answer: A. Pressure lowers the melting point of ice below 0 °C, which is why ice melts under the wire in the regelation experiment.
-
3. At what temperature does water have its maximum density?
- 0 °C
- 100 °C
- 4 °C
- -4 °C
Show answer
Answer: C. Water contracts as it is heated from 0 °C to 4 °C and expands after that, so its volume is least and density greatest at 4 °C.
-
4. In Hope's apparatus, which thermometer reaches 0 °C first?
- The lower thermometer T₁
- Both at the same time
- Neither ever reaches 0 °C
- The upper thermometer T₂
Show answer
Answer: D. Water cooled below 4 °C becomes less dense and rises. So the top of the cylinder cools to 0 °C first, while the bottom stays near 4 °C for a while.
-
5. Why do fish survive in a lake whose surface is frozen?
- The water below the ice stays at about 4 °C
- Ice is a good conductor of heat
- Fish produce heat that melts the ice
- The lake bottom is at 100 °C
Show answer
Answer: A. The densest water, at 4 °C, sinks to the bottom. Ice floats on top and, being a poor conductor, insulates the water below, which stays at about 4 °C.
Sign in to keep track of the lessons you finish.