• Practice
  • About 14 min
  • 5 practice questions

Resistor networks: balance, symmetry and cutting tricks

Reduce difficult resistor networks quickly using balanced bridges, equal potentials, rings of wire, cut wires and the current divider.

If something looks wrong, please tell us.

Some resistor networks cannot be reduced by simply reading off series and parallel groups. Competitive exams love them because the right idea turns a page of algebra into two lines. This lesson gives you a small toolbox. All values are made up for practice.

Idea 1: equal potential means no current

If two points of a network are at the same potential, no current flows between them, so any resistor joined only between those two points can be removed (or replaced by a plain wire) without changing the rest. The best-known case is the balanced Wheatstone bridge: when P/Q = R/S, the middle arm carries no current, so it can be ignored whatever it contains. Similarly, if two points are joined by a wire of negligible resistance, any resistor connected across just those two points is short-circuited and carries no current.

Worked example 1: a balanced bridge

A bridge has P = 2 Ω and Q = 4 Ω in one branch, R = 3 Ω and S = 6 Ω in the other, and a 5 Ω resistor across the middle. Check balance: P/Q = 2/4 = 0.5 and R/S = 3/6 = 0.5, so the bridge is balanced and the 5 Ω resistor carries no current. The two branches are 2 + 4 = 6 Ω and 3 + 6 = 9 Ω in parallel: R = (6 × 9)/(6 + 9) = 54/15 = 3.6 Ω.

Idea 2: rings and wires

A uniform wire of resistance R bent into a circle can be treated as two arcs between any two chosen points. The arcs are in parallel, so you only need their lengths. Between diametrically opposite points each arc is R/2, and two R/2 in parallel give R/4.

Worked example 2: a ring of wire

A ring of wire has total resistance 12 Ω. Opposite points: the arcs are 6 Ω and 6 Ω, so R = 3 Ω, which is 12/4. Points a quarter of the circle apart: the arcs are 3 Ω and 9 Ω, so R = (3 × 9)/(3 + 9) = 27/12 = 2.25 Ω.

Idea 3: cutting a wire

A wire of resistance R cut into n equal pieces gives n pieces of R/n each. Joined in parallel, they give (R/n)/n = R/n². So cutting into 2 pieces and joining in parallel gives R/4, and cutting into 4 gives R/16.

Worked example 3: a cut wire

A 16 Ω wire is cut into 4 equal pieces which are then joined in parallel. Each piece is 16/4 = 4 Ω. Four 4 Ω resistors in parallel give 4/4 = 1 Ω, which agrees with 16/4² = 1 Ω.

Idea 4: the current divider

When a total current I enters two parallel resistors R1 and R2, the current in R1 is I × R2/(R1 + R2). The larger share goes through the smaller resistance. For three or more branches, share the current in proportion to the conductances (1/R).

Worked example 4: sharing a current

A current of 6 A enters 4 Ω and 12 Ω in parallel. Current in 4 Ω = 6 × 12/16 = 4.5 A. Current in 12 Ω = 6 × 4/16 = 1.5 A. The total is 4.5 + 1.5 = 6 A, and the voltages agree: 4.5 × 4 = 18 V and 1.5 × 12 = 18 V.

Equal potential, no current: remove it. Shorted resistor: remove it. Wire cut into n pieces and joined in parallel: R/n². Bigger current through smaller resistance.

— Rule to remember

Key takeaways

  • Redraw the circuit with the junctions marked by letters before you reduce it.
  • Look for balanced bridges, symmetry and shorts first.
  • Treat a ring as two parallel arcs.
  • Check any answer by confirming the voltages across parallel branches are equal.

Check your understanding

  1. 1. A uniform ring of wire has resistance 8 Ω. The resistance between two diametrically opposite points is:

    1. 4 Ω
    2. 1 Ω
    3. 2 Ω
    4. 16 Ω
    Show answer

    Answer: C. Each half is 4 Ω and the two halves are in parallel: (4 × 4)/8 = 2 Ω, which is 8/4.

  2. 2. Four 10 Ω resistors form a bridge, with a 50 Ω resistor across the middle. The resistance between the input points is:

    1. 20 Ω
    2. 10 Ω
    3. 40 Ω
    4. 30 Ω
    Show answer

    Answer: B. The bridge is balanced, so no current flows through the 50 Ω resistor. The two branches of 20 Ω are in parallel, giving 10 Ω.

  3. 3. A 36 Ω wire is cut into 3 equal pieces which are joined in parallel. The resistance becomes:

    1. 12 Ω
    2. 3 Ω
    3. 9 Ω
    4. 4 Ω
    Show answer

    Answer: D. Each piece is 12 Ω. Three in parallel give 12/3 = 4 Ω, which is 36/3².

  4. 4. A current of 3 A enters 2 Ω and 6 Ω in parallel. The current through the 6 Ω resistor is:

    1. 0.75 A
    2. 2.25 A
    3. 1.5 A
    4. 1 A
    Show answer

    Answer: A. Current in 6 Ω = 3 × 2/(2 + 6) = 0.75 A. The remaining 2.25 A goes through the 2 Ω resistor.

  5. 5. A 5 Ω resistor is connected across two points that are joined by a thick copper wire of negligible resistance. The current in the 5 Ω resistor is:

    1. zero
    2. one fifth of the total
    3. one half of the total
    4. equal to the total
    Show answer

    Answer: A. The wire short-circuits the resistor. Both ends are at the same potential, so no current flows through it.

Privacy · Terms · Refunds · Delivery