- Practice
- About 22 min
- 5 practice questions
Standard solutions, solubility and Henry's law
Prepare and dilute standard solutions using CsVs = CwVw, explain how temperature and pressure affect solubility, and apply Henry's law and its limitations.
If something looks wrong, please tell us.
By the end of this lesson you can
- Describe how a standard (stock) solution is made and diluted to a working standard.
- Solve dilution and mixing problems.
- Explain how the nature of solute and solvent, temperature and pressure affect solubility.
- Use Henry's law, p = K_H x, and state its limitations.
Laboratory work needs solutions of accurately known strength. These are made once, carefully, and then diluted as needed.
Standard solutions and working standards
A standard (stock) solution is one whose concentration is accurately known. A weighed amount of solute is transferred into a standard flask, dissolved in a little water, made up to the mark with water, and then the stoppered flask is shaken so the concentration is uniform. At the time of an experiment, a known volume of stock is diluted to make a working standard. Moles of solute do not change on dilution, so:
Cs × Vs = Cw × Vw (stock concentration × stock volume = working concentration × working volume). For mixing two solutions: C₁V₁ + C₂V₂ = C₃V₃.
Advantages of a concentrated stock: a larger mass is weighed, so the weighing error is smaller; many working standards can be made consistently from one stock; and concentrated solutions are often more stable and less likely to support microbial growth.
Worked example 1: dilution
How much 6.0 M HCl stock is needed to make 250 mL of 0.30 M HCl? Working: Vs = Cw × Vw ÷ Cs = 0.30 × 250 ÷ 6.0 = 75 ÷ 6.0 = 12.5 mL. Measure 12.5 mL of stock into a 250 mL standard flask and make up to the mark with water.
Worked example 2: mixing two solutions
What volumes of 5.0 M and 1.0 M NaOH give 400 mL of 2.0 M NaOH? Working: let x mL of 5.0 M be used, so (400 − x) mL of 1.0 M. Then 5.0x + 1.0(400 − x) = 2.0 × 400, so 5.0x + 400 − x = 800, 4.0x = 400, x = 100 mL of 5.0 M and 300 mL of 1.0 M. Check: 500 + 300 = 800 mmol in 400 mL = 2.0 M ✓.
Solubility and the factors that affect it
Solubility is the maximum amount of solute that dissolves in a given amount of solvent at a stated temperature; the Tamil Nadu textbook expresses it as the mass dissolved in 100 g of solvent to give a saturated solution. Any extra solute stays undissolved. Solubility depends on:
- Nature of solute and solvent: ionic NaCl dissolves in polar water but not in non-polar benzene or toluene; many organic compounds dissolve in organic solvents but not in water; ammonia is far more soluble in water than oxygen.
- Temperature, solids: in a saturated solution, solid ⇌ dissolved solute. If dissolving is endothermic, heating shifts the equilibrium right and solubility rises (ammonium nitrate rises steeply). If it is exothermic, solubility falls on heating (cerium sulphate). NaCl changes little between 0 °C and 100 °C. Calcium chloride dissolves exothermically yet its solubility rises moderately, because entropy also matters.
- Temperature, gases: gases become less soluble on heating. Faster molecules break the weak attractions holding them in solution, and dissolving most gases is exothermic. Warm water discharged into rivers holds less dissolved oxygen, which harms aquatic life.
- Pressure: has little effect for solids and liquids, which are hardly compressible, but raising the pressure of a gas increases its solubility: gas ⇌ gas in solution shifts towards the dissolved side to relieve the pressure.
Henry's law
At low concentrations, the partial pressure of a gas above a solution is directly proportional to its mole fraction in the solution: p = K_H × x.
K_H is an empirical constant with the units of pressure; it depends on the gas and the solvent. A graph of p against x is a straight line through the origin with slope K_H. A larger K_H means a less soluble gas (more pressure needed for the same mole fraction). Soft drinks are bottled under high CO₂ pressure; on opening, the pressure falls to atmospheric and CO₂ escapes as bubbles. Divers breathing compressed air at depth dissolve extra nitrogen in their blood; rising too quickly lets it form bubbles (the painful 'bends'), so air diluted with helium, which is less soluble in blood, is used.
Worked example 3: solubility at a new pressure
0.30 g of a gas dissolves in 1 L of water at 2.0 atm. How much dissolves at 5.0 atm, same temperature? Working: by Henry's law, the amount dissolved is proportional to pressure: m₂ = m₁ × p₂/p₁ = 0.30 × 5.0 ÷ 2.0 = 0.75 g L⁻¹.
Worked example 4: using K_H
A gas with K_H = 5.0 × 10⁴ atm (practice value) is above water at a partial pressure of 0.25 atm. Working: x = p ÷ K_H = 0.25 ÷ (5.0 × 10⁴) = 5.0 × 10⁻⁶. One litre of water is about 1000 ÷ 18 = 55.6 mol, so the gas dissolved ≈ 5.0 × 10⁻⁶ × 55.6 = 2.8 × 10⁻⁴ mol per litre (for very small x, n_gas ≈ x × n_water).
Limitations of Henry's law
-
Conditions
- Holds only at moderate temperature and pressure
-
Kind of gas
- Obeyed only by less soluble gases
-
No reaction
- Gases that react with the solvent do not obey it, e.g. NH₃ + H₂O ⇌ NH₄⁺ + OH⁻, and HCl in water
-
No association or dissociation
- The gas must not associate or dissociate on dissolving
Key takeaways: CsVs = CwVw for dilution. Solids usually dissolve more when hot; gases less when hot and more under pressure. Henry's law p = K_H x applies to sparingly soluble, non-reacting gases at moderate conditions.
Check your understanding
-
1. What volume of 2.0 M H₂SO₄ is needed to make 500 mL of 0.10 M H₂SO₄?
- 10 mL
- 100 mL
- 25 mL
- 50 mL
Show answer
Answer: C. Vs = Cw × Vw ÷ Cs = 0.10 × 500 ÷ 2.0 = 50 ÷ 2.0 = 25 mL, made up to 500 mL with water.
-
2. Why do fish find it harder to breathe in a river where hot water from a factory is discharged?
- Hot water dissolves more oxygen.
- The solubility of oxygen in water decreases as temperature rises.
- Hot water raises the pressure of oxygen above the river.
- Oxygen reacts with hot water.
Show answer
Answer: B. Gases are less soluble in warmer water: the faster molecules escape more easily and dissolving is exothermic, so heating shifts the equilibrium towards undissolved gas. Less dissolved oxygen is available.
-
3. 0.18 g of a gas dissolves in 1 L of water at 1.2 atm. How much dissolves at 4.0 atm at the same temperature?
- 0.054 g
- 0.72 g
- 0.40 g
- 0.60 g
Show answer
Answer: D. Mass dissolved ∝ pressure: m₂ = 0.18 × 4.0 ÷ 1.2 = 0.72 ÷ 1.2 = 0.60 g. (0.72 g forgets to divide by 1.2.)
-
4. Which gas would NOT be expected to obey Henry's law in water?
- Ammonia
- Nitrogen
- Oxygen
- Helium
Show answer
Answer: A. Ammonia is very soluble and reacts with water (NH₃ + H₂O ⇌ NH₄⁺ + OH⁻), so it does not obey Henry's law. The other three are sparingly soluble and do not react.
-
5. Two gases X and Y have K_H values of 2 × 10⁴ atm and 8 × 10⁴ atm in water at the same temperature. Which statement is correct?
- Y is more soluble than X at the same pressure.
- Both are equally soluble.
- X is more soluble than Y at the same pressure.
- Solubility does not depend on K_H.
Show answer
Answer: C. x = p ÷ K_H. At the same p, the smaller K_H (X) gives the larger mole fraction in solution, so X is more soluble, by a factor of 8 ÷ 2 = 4.
Sign in to keep track of the lessons you finish.