• Practice
  • About 25 min
  • 5 practice questions

Vapour pressure, Raoult's law and ideal and non-ideal solutions

Explain vapour pressure, apply Raoult's law to solutions of two volatile liquids and of a non-volatile solute, compare it with Henry's law, and explain ideal solutions and positive and negative deviations.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Define vapour pressure and list what it depends on.
  • Use Raoult's law and Dalton's law to find partial and total vapour pressures of a binary liquid solution.
  • State Raoult's law as relative lowering of vapour pressure and compare it with Henry's law.
  • Tell ideal solutions from non-ideal ones and explain positive and negative deviations and their causes.

Molecules at the surface of a liquid with enough kinetic energy to overcome the attractions escape: evaporation. In a closed container the vapour molecules collide with each other and the walls, lose energy and return to the liquid: condensation. When the two rates become equal, liquid and vapour are in equilibrium. The pressure of the vapour then is the vapour pressure of the liquid at that temperature. It depends on the nature of the liquid and the temperature (the Tamil Nadu textbook also lists the surface area). It can be measured with a mercury manometer connected to a flask of the liquid.

Raoult's law for two volatile liquids

A binary solution has two components. If both are volatile, both evaporate. Raoult stated that the partial vapour pressure of each component is directly proportional to its mole fraction. When x_A = 1 the proportionality constant must be the vapour pressure of pure A, p°A.

p_A = p°A x_A and p_B = p°B x_B. By Dalton's law, P_total = p_A + p_B = p°A + x_B(p°B − p°A).

— Raoult's law with Dalton's law

The last form is a straight line, y = mx + c: plotting P_total against x_B gives slope (p°B − p°A) and intercept p°A. The Tamil Nadu textbook shows benzene-toluene, with p° values of 74.7 mmHg (benzene) and 22.3 mmHg (toluene): all three lines (two partial pressures and the total) are straight.

Worked example 1: total vapour pressure and vapour composition

Liquids A and B form an ideal solution; p°A = 80 mmHg and p°B = 30 mmHg (practice values); x_A = 0.40. Working: x_B = 1 − 0.40 = 0.60. p_A = 80 × 0.40 = 32 mmHg; p_B = 30 × 0.60 = 18 mmHg; P_total = 32 + 18 = 50 mmHg. Check with the line: 80 + 0.60 × (30 − 80) = 80 − 30 = 50 ✓. In the vapour, mole fraction of A = p_A/P_total = 32 ÷ 50 = 0.64, richer in A than the liquid (0.40), because A is more volatile.

A non-volatile solute lowers the vapour pressure

If the solute (B) does not evaporate, only solvent molecules (A) escape, and fewer of them are at the surface, so the vapour pressure falls: P_solution = p°A x_A. Dividing by p°A and subtracting from 1: (p°A − P_solution)/p°A = 1 − x_A = x_B.

Relative lowering of vapour pressure = (p° − p)/p° = x_B, the mole fraction of the solute.

— Raoult's law for a non-volatile solute

Worked example 2: vapour pressure of a sugar solution

A solution contains 1.0 mol of a non-volatile solute in 9.0 mol of water at 25 °C, where p° of water = 23.8 mmHg. Working: x_B = 1.0 ÷ 10.0 = 0.10, so x_A = 0.90. P_solution = 23.8 × 0.90 = 21.4 mmHg. Lowering = 23.8 − 21.4 = 2.4 mmHg; relative lowering = 2.38 ÷ 23.8 = 0.10 = x_B ✓.

Raoult's law and Henry's law compared

Both laws say a component's partial pressure is proportional to its mole fraction in the solution: p = p° x (Raoult) and p = K_H x (Henry). Only the constant differs. Henry's law is used for a gas dissolved in a liquid; Raoult's law for the solvent and for volatile liquid mixtures. When K_H equals p°, Henry's law becomes Raoult's law, so Raoult's law can be seen as a special case of Henry's law. In very dilute solutions the solvent obeys Raoult's law while the solute obeys Henry's law.

Ideal and non-ideal solutions

An ideal solution obeys Raoult's law for every component over the whole range of concentration. This needs components of similar size and structure with similar A-A, B-B and A-B attractions. Then ΔV_mixing = 0, ΔH_mixing = 0, and each component escapes as readily as when pure. Examples: benzene and toluene; n-hexane and n-heptane; ethyl bromide and ethyl iodide; chlorobenzene and bromobenzene. No solution is perfectly ideal, but very dilute solutions come close. Non-ideal solutions do not obey Raoult's law over the whole range; for them ΔH_mixing ≠ 0 and ΔV_mixing ≠ 0.

Positive and negative deviation from Raoult's law

  • Positive deviation
    • A-B attractions weaker than A-A and B-B
    • Molecules escape more easily
    • p_A > p°A x_A, p_B > p°B x_B; vapour pressure higher than predicted
    • ΔH_mixing > 0 (endothermic), ΔV_mixing > 0
    • Ethanol + water, ethanol + cyclohexane, benzene + acetone, CCl₄ + chloroform, acetone + ethanol
  • Negative deviation
    • A-B attractions stronger than A-A and B-B
    • Molecules escape less easily
    • p_A < p°A x_A, p_B < p°B x_B; vapour pressure lower than predicted
    • ΔH_mixing < 0 (exothermic), ΔV_mixing < 0
    • Phenol + aniline, acetone + chloroform, chloroform + diethyl ether, acetone + aniline, chloroform + benzene

In ethanol-water, the Tamil Nadu textbook explains that the hydrogen bonds between ethanol and water are weaker than those within each pure liquid, so both escape more readily. In phenol-aniline, new phenol-aniline hydrogen bonds are stronger than those in the pure liquids, so escape is harder, heat is given out and the volume shrinks slightly.

Factors that cause deviation

  1. Solute-solvent interactions unlike A-A and B-B attractions.
  2. Dissociation of solute: e.g. KCl gives K⁺ and Cl⁻, which form strong ion-dipole attractions with water.
  3. Association of solute: e.g. acetic acid forms hydrogen-bonded dimers.
  4. Temperature: higher kinetic energy weakens attractions.
  5. Pressure: at high pressure molecules are pushed close and attract more.
  6. Concentration: in very dilute solutions solute-solvent interactions are negligible; as concentration rises they become significant.

Key takeaways: p_A = p°A x_A; P_total is a straight line in x_B for ideal solutions. With a non-volatile solute, (p° − p)/p° = x_B. Weaker A-B attractions give positive deviation (ΔH > 0, ΔV > 0); stronger A-B attractions give negative deviation (ΔH < 0, ΔV < 0).

Check your understanding

  1. 1. Liquids P and Q form an ideal solution; p°P = 120 mmHg and p°Q = 40 mmHg. What is the total vapour pressure when x_P = 0.25?

    1. 60 mmHg
    2. 80 mmHg
    3. 100 mmHg
    4. 160 mmHg
    Show answer

    Answer: A. p_P = 120 × 0.25 = 30 mmHg; p_Q = 40 × 0.75 = 30 mmHg; total = 30 + 30 = 60 mmHg.

  2. 2. The vapour pressure of pure water at a certain temperature is 30.0 mmHg. A solution of a non-volatile solute has a vapour pressure of 29.4 mmHg. What is the mole fraction of the solute?

    1. 0.98
    2. 0.60
    3. 0.020
    4. 0.20
    Show answer

    Answer: C. Relative lowering = (p° − p)/p° = (30.0 − 29.4) ÷ 30.0 = 0.6 ÷ 30.0 = 0.020 = x_B. (0.98 is the mole fraction of the solvent.)

  3. 3. Which pair forms a nearly ideal solution?

    1. Acetone and chloroform
    2. n-Hexane and n-heptane
    3. Ethanol and water
    4. Phenol and aniline
    Show answer

    Answer: B. n-Hexane and n-heptane are similar in size and structure with similar attractions, so they obey Raoult's law closely. The other pairs show strong positive or negative deviations.

  4. 4. For a solution showing negative deviation from Raoult's law, which is true?

    1. ΔH_mixing > 0 and ΔV_mixing > 0
    2. ΔH_mixing = 0 and ΔV_mixing = 0
    3. Vapour pressure is higher than Raoult's law predicts
    4. ΔH_mixing < 0 and ΔV_mixing < 0
    Show answer

    Answer: D. Stronger A-B attractions hold molecules in the liquid, so vapour pressure is lower than predicted; forming stronger attractions releases heat (ΔH < 0) and draws molecules closer (ΔV < 0).

  5. 5. Assertion (A): A mixture of ethanol and water shows positive deviation from Raoult's law. Reason (R): The attractions between ethanol and water molecules are stronger than those in the pure liquids.

    1. Both A and R are true, and R is the correct explanation of A.
    2. Both A and R are true, but R is not the correct explanation of A.
    3. A is true, but R is false.
    4. A is false, but R is true.
    Show answer

    Answer: C. A is true. R is false: positive deviation arises because the ethanol-water attractions are WEAKER than those in the pure liquids, so molecules escape more easily and the vapour pressure rises above the Raoult value.

Privacy · Terms · Refunds · Delivery