- Practice
- About 22 min
- 5 practice questions
Equation of continuity, Bernoulli's theorem and its applications
Derive the equation of continuity, identify the pressure, kinetic and potential energy of a flowing liquid, prove Bernoulli's theorem, and explain roofs, aerofoils, the Bunsen burner and the venturimeter.
If something looks wrong, please tell us.
By the end of this lesson you can
- Derive av = constant for steady flow of an incompressible liquid.
- Write the pressure, kinetic and potential energy of a liquid per unit mass and per unit volume.
- Prove Bernoulli's theorem from the conservation of energy and state its limits.
- Explain roofs in storms, aeroplane lift, the Bunsen burner and other applications.
- Use a venturimeter to find the speed and rate of flow in a pipe.
Put your thumb over the end of a garden hose and the water shoots out faster. Strong winds can lift a roof off a house without breaking its walls. Both follow from two rules for moving fluids: conservation of mass (continuity) and conservation of energy (Bernoulli's theorem).
Equation of continuity
Flow is steady when the velocity of the fluid passing any given point stays the same with time; particles then move along streamlines. Let a non-viscous, incompressible liquid of density ρ flow steadily through a pipe whose cross-section changes from a₁ (at A) to a₂ (at B), with speeds v₁ and v₂. In a time Δt, the mass entering at A is m₁ = ρa₁v₁Δt and the mass leaving at B is m₂ = ρa₂v₂Δt. Mass is conserved and the liquid cannot be squeezed, so m₁ = m₂, giving a₁v₁ = a₂v₂, or av = constant. The volume flow rate is the same everywhere along the pipe, so the liquid moves faster where the pipe is narrower.
Worked example 1: a narrowing pipe
Water flows at 0.50 m s⁻¹ in a pipe of diameter 4.0 cm, which narrows to 2.0 cm. Step 1: area ∝ diameter², so a₁/a₂ = (4.0/2.0)² = 4. Step 2: v₂ = v₁ × a₁/a₂ = 0.50 × 4 = 2.0 m s⁻¹. Step 3: flow rate = a₁v₁ = π(0.020)² × 0.50 = 1.257 × 10⁻³ × 0.50 = 6.3 × 10⁻⁴ m³ s⁻¹, about 0.63 litre per second, the same at both ends.
Energy of a flowing liquid
A liquid in steady flow has three kinds of energy. Kinetic energy ½mv²: per unit mass ½v², per unit volume ½ρv². Potential energy mgh at height h: per unit mass gh, per unit volume ρgh. Pressure energy: pushing liquid with pressure P through area A over a distance d needs work F × d = PA × d = PV, so the pressure energy is PV; per unit mass P/ρ, per unit volume P.
Bernoulli's theorem
In 1738 the Swiss scientist Daniel Bernoulli applied the conservation of energy to a liquid flowing through a pipe of varying cross-section. Bernoulli's theorem: for an incompressible, non-viscous liquid in streamlined flow, the sum of the pressure energy, kinetic energy and potential energy per unit mass is constant: P/ρ + ½v² + gh = constant. Multiplying by ρ gives the per-unit-volume form P + ½ρv² + ρgh = constant.
Proof. Let liquid of volume V and mass m = ρV enter the pipe at A (area a_A, speed v_A, pressure P_A, height h_A) in time t, and the same volume leave at B. The force at A is P_A a_A, and in time t the liquid moves v_A t, so the work done on it is P_A a_A v_A t = P_A V: its pressure energy at A is P_A V = mP_A/ρ. Its total energy at A is E_A = mP_A/ρ + ½mv_A² + mgh_A, and similarly at B. With no energy lost, E_A = E_B; dividing by m: P_A/ρ + ½v_A² + gh_A = P_B/ρ + ½v_B² + gh_B. In a real fluid some energy is lost as heat through friction between layers moving at different speeds, so the theorem is strictly true only for non-viscous liquids. For a horizontal pipe the gh terms are equal and cancel: where the speed is greater, the pressure is lower.
Narrow part of a horizontal pipe: why the pressure drops
- Pipe narrows Smaller area a.
- Continuity av = constant, so the speed v rises.
- More kinetic energy ½ρv² per unit volume increases.
- Bernoulli P + ½ρv² = constant, so the pressure P falls.
Worked example 2: pressure drop in a horizontal pipe
In the pipe of worked example 1 (horizontal), find the pressure difference between the wide and narrow parts. Step 1: P₁ + ½ρv₁² = P₂ + ½ρv₂². Step 2: P₁ − P₂ = ½ρ(v₂² − v₁²) = ½ × 1000 × (2.0² − 0.50²) = 500 × (4.0 − 0.25) = 500 × 3.75 = 1875 Pa ≈ 1.9 × 10³ Pa. The pressure is lower in the narrow part, where the water moves faster.
Applications of Bernoulli's theorem
- Roofs in a storm: fast wind over a roof lowers the pressure above it (P₁), while the still air inside stays at a higher pressure P₂. The difference P₂ − P₁ pushes upward and can blow the roof off while the walls stand.
- Aerofoil lift: an aircraft wing is more curved on top and thicker at the front than at the back. Air moves faster over the top, so the pressure above is lower than below, giving an upward dynamic lift.
- Bunsen burner: gas leaves the nozzle at high speed, so the pressure in the stem falls and outside air is drawn in through the air hole; the gas-air mixture burns with a blue flame.
- Carburettor, filter pumps, atomisers and sprayers: a fast stream through a narrow neck lowers the pressure and draws in fuel, air or liquid. In a car's carburettor, petrol is drawn into fast-moving air to make the right mixture for burning.
The venturimeter
A venturimeter measures the speed or rate of flow of an incompressible liquid in a pipe. It is a wide tube of area A joined to a narrow throat of area a, with a U-tube manometer connected between them. The liquid (density ρ) flows at v₁ in the wide part and v₂ in the throat, where the pressure is lower; the manometer shows the difference ΔP = P₁ − P₂. Step 1: continuity: Av₁ = av₂, so v₂ = (A/a)v₁. Step 2: Bernoulli for a horizontal tube: P₁ + ½ρv₁² = P₂ + ½ρv₂², so ΔP = ½ρv₁²(A²/a² − 1) = ½ρv₁²(A² − a²)/a². Step 3: v₁ = a √(2ΔP/(ρ(A² − a²))), and the volume flowing per second is Q = Av₁ = Aa √(2ΔP/(ρ(A² − a²))).
Worked example 3: reading a venturimeter
Water flows through a venturimeter whose wide part has area A = 5.0 × 10⁻³ m² and throat a = A/4. The manometer shows ΔP = 1200 Pa. Step 1: A/a = 4, so v₂ = 4v₁ and ΔP = ½ρ(v₂² − v₁²) = ½ × 1000 × (16 − 1)v₁² = 7500 v₁². Step 2: v₁² = 1200/7500 = 0.16, so v₁ = 0.40 m s⁻¹ and v₂ = 1.6 m s⁻¹. Step 3: Q = Av₁ = 5.0 × 10⁻³ × 0.40 = 2.0 × 10⁻³ m³ s⁻¹ = 2.0 litres per second.
Worked example 4: lift on a roof
During a cyclone, wind blows at 30 m s⁻¹ over a flat roof of area 50 m², while the air inside is still (air density 1.2 kg m⁻³). Step 1: pressure difference ΔP = ½ρv² = ½ × 1.2 × 30² = 0.6 × 900 = 540 Pa. Step 2: upward force = ΔP × area = 540 × 50 = 2.7 × 10⁴ N, the weight of about 2.8 tonnes, which is why light roofs must be tied down firmly.
Continuity: a₁v₁ = a₂v₂. Bernoulli: P/ρ + ½v² + gh = constant (P + ½ρv² + ρgh per unit volume); faster flow, lower pressure. Venturimeter: Q = Aa √(2ΔP/ρ(A² − a²)).
Key takeaways
- The equation of continuity is conservation of mass: narrow section, faster flow.
- A flowing liquid carries pressure, kinetic and potential energy.
- Bernoulli's theorem is conservation of energy for an ideal liquid in streamlined flow.
- Lower pressure in fast-moving fluid explains roofs blowing off, wing lift, the Bunsen burner and sprayers.
- A venturimeter turns a measured pressure difference into a flow rate.
Check your understanding
-
1. Water flows steadily through a pipe. Where the cross-sectional area is halved, the speed of the water:
- halves
- doubles
- becomes four times
- stays the same
Show answer
Answer: B. By continuity a₁v₁ = a₂v₂. If a₂ = a₁/2, then v₂ = 2v₁: the speed doubles.
-
2. For a liquid flowing steadily in a horizontal pipe of varying width, the pressure is:
- lowest where the speed is greatest
- highest where the speed is greatest
- the same everywhere
- highest where the pipe is narrowest
Show answer
Answer: A. For a horizontal pipe Bernoulli's theorem gives P + ½ρv² = constant. Where v is greatest (the narrowest part), P is lowest.
-
3. Water (ρ = 1000 kg m⁻³) flows in a horizontal pipe at 1.0 m s⁻¹ in a wide part and 3.0 m s⁻¹ in a narrow part. The pressure difference between them is:
- 1000 Pa
- 2000 Pa
- 4000 Pa
- 9000 Pa
Show answer
Answer: C. P₁ − P₂ = ½ρ(v₂² − v₁²) = ½ × 1000 × (9.0 − 1.0) = 500 × 8.0 = 4000 Pa.
-
4. An aeroplane wing gets an upward lift mainly because:
- air is heavier below the wing
- the wing pushes air downward by friction
- air moves more slowly over the top surface
- air moves faster over the top surface, so the pressure there is lower
Show answer
Answer: D. The wing's shape makes the air flow faster over its curved upper surface. By Bernoulli's theorem the pressure above is then lower than below, giving the dynamic lift.
-
5. A venturimeter is used to measure:
- the rate of flow of a liquid in a pipe
- the viscosity of a liquid
- the surface tension of a liquid
- atmospheric pressure
Show answer
Answer: A. A venturimeter measures the pressure difference between a wide part and a narrow throat; continuity and Bernoulli's theorem then give the speed and volume flow rate of the liquid.
Sign in to keep track of the lessons you finish.