• Practice
  • About 24 min
  • 5 practice questions

Leaching, roasting and calcination

Write balanced equations for cyanide, ammonia, alkali and acid leaching, recover gold by cementation, and convert ores into oxides by roasting or calcination.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Explain leaching as a chemical concentration method and write equations for its four types.
  • Show that cyanide leaching of gold or silver is a redox reaction.
  • Tell roasting from calcination and write equations for each.
  • Explain why sulphide and carbonate ores are converted to oxides before reduction.

Physical methods (lesson 1) cannot separate every ore. Leaching uses chemistry: the ore is dissolved in a solvent that takes up the metal and leaves the gangue. After concentration, the ore is changed into an oxide, because oxides are easier to reduce than sulphides or carbonates.

Leaching

In leaching, the crushed ore is treated with a suitable solvent. The metal forms a soluble salt or complex, while the gangue stays undissolved and is filtered off.

Cyanide leaching of gold

Crushed gold ore is leached with an aerated dilute solution of sodium cyanide. Gold forms the soluble dicyanidoaurate(I) ion; the aluminosilicate gangue does not dissolve.

4Au(s) + 8CN⁻(aq) + O₂(g) + 2H₂O(l) → 4[Au(CN)₂]⁻(aq) + 4OH⁻(aq)

Check the balance atom by atom: Au 4 = 4; C 8 = 8; N 8 = 8; O 2 + 2 = 4 on the left and 4 on the right; H 4 = 4. Charge: 8 × (−1) = −8 on the left; 4 × (−1) + 4 × (−1) = −8 on the right.

The gold is recovered from the solution (after removing dissolved oxygen) by adding zinc, which reduces gold back to the metal. This is called cementation:

Zn(s) + 2[Au(CN)₂]⁻(aq) → [Zn(CN)₄]²⁻(aq) + 2Au(s)

Worked example 1: is cyanide leaching a redox reaction?

Take silver, which is leached in the same way: 4Ag(s) + 8CN⁻(aq) + O₂(g) + 2H₂O(l) → 4[Ag(CN)₂]⁻(aq) + 4OH⁻(aq). Working: in Ag the oxidation state of silver is 0; in [Ag(CN)₂]⁻ it is x + 2(−1) = −1, so x = +1. Silver is oxidised (0 → +1). Oxygen goes from 0 in O₂ to −2 in OH⁻, so it is reduced. Each of 4 Ag atoms loses 1 electron (4 e⁻ lost); each of 2 O atoms gains 2 electrons (4 e⁻ gained). Electrons lost = electrons gained, so it is a redox reaction, with O₂ as the oxidising agent. In cementation, zinc (0 → +2) is oxidised and silver or gold (+1 → 0) is reduced.

Ammonia leaching

An ore containing nickel, copper and cobalt is treated with aqueous ammonia under pressure. These metals dissolve as the complexes [Ni(NH₃)₆]²⁺, [Cu(NH₃)₄]²⁺ and [Co(NH₃)₅H₂O]³⁺, leaving behind iron(III) oxides/hydroxides and aluminosilicate gangue.

Alkali leaching of bauxite

Bauxite is heated with sodium hydroxide (or sodium carbonate) solution at about 470–520 K and 35 atm (conditions as given in the Tamil Nadu textbook). Alumina dissolves as sodium meta-aluminate; iron oxide and titanium oxide do not dissolve.

Al₂O₃(s) + 2NaOH(aq) + 3H₂O(l) → 2Na[Al(OH)₄](aq)

Check: Al 2 = 2; Na 2 = 2; O 3 + 2 + 3 = 8 and 2 × 4 = 8; H 2 + 6 = 8 and 2 × 4 = 8. The hot solution is decanted, cooled, diluted and neutralised with CO₂, which precipitates hydrated alumina:

2Na[Al(OH)₄](aq) + 2CO₂(g) → Al₂O₃·3H₂O(s) + 2NaHCO₃(aq)

Check: Na 2 = 2; Al 2 = 2; C 2 = 2; H 8 = 6 + 2; O 8 + 4 = 12 and 3 + 3 + 6 = 12. Heating the precipitate to about 1670 K gives pure alumina, Al₂O₃, ready for electrolysis (lesson 5).

Acid leaching

Sulphide ores such as ZnS and PbS can be leached with hot aqueous sulphuric acid in the presence of oxygen; the insoluble sulphide becomes a soluble sulphate and elemental sulphur: 2ZnS(s) + 2H₂SO₄(aq) + O₂(g) → 2ZnSO₄(aq) + 2S(s) + 2H₂O(l). Check: Zn 2; S 2 + 2 = 4 and 2 + 2 = 4; H 4 = 4; O 8 + 2 = 10 and 8 + 2 = 10.

Types of leaching

  • Cyanide leaching
    • Gold and silver
    • Aerated dilute NaCN
    • Metal recovered by zinc (cementation)
  • Ammonia leaching
    • Nickel, copper, cobalt
    • Soluble ammine complexes
  • Alkali leaching
    • Bauxite with NaOH
    • Gives Na[Al(OH)₄]; Fe and Ti oxides left
  • Acid leaching
    • ZnS, PbS with hot H₂SO₄ and O₂
    • Soluble sulphate + sulphur

Converting the concentrated ore into an oxide

In the ore the metal is in a positive oxidation state and must be reduced. Thermodynamically, an oxide is easier to reduce than a sulphide or carbonate (carbon and hydrogen do not readily reduce sulphides, because CS₂ and H₂S are less stable than metal sulphides). So the ore is first turned into an oxide by roasting or calcination.

Roasting

Roasting heats the concentrated ore in excess oxygen (air), below the melting point of the metal. It is used for sulphide ores: 2PbS + 3O₂ → 2PbO + 2SO₂; 2ZnS + 3O₂ → 2ZnO + 2SO₂; 2Cu₂S + 3O₂ → 2Cu₂O + 2SO₂. It also removes impurities as volatile oxides: 4As + 3O₂ → 2As₂O₃; S₈ + 8O₂ → 8SO₂; P₄ + 5O₂ → P₄O₁₀. The SO₂ formed is harmful, so modern plants trap it and turn it into sulphuric acid.

Calcination

Calcination heats the ore strongly in the absence of air (or a limited supply). It drives out CO₂ from carbonates, water from hydrated oxides and any organic matter, leaving a porous ore: PbCO₃ → PbO + CO₂; CaCO₃ → CaO + CO₂; ZnCO₃ → ZnO + CO₂; MgCO₃·CaCO₃ → MgO + CaO + 2CO₂ (dolomite); Fe₂O₃·3H₂O → Fe₂O₃ + 3H₂O; Al₂O₃·2H₂O → Al₂O₃ + 2H₂O.

Roasting and calcination

  • Roasting
    • Heated in excess air
    • Mainly sulphide ores
    • Gas given off: SO₂ (and volatile oxides of As, P)
    • Example: 2ZnS + 3O₂ → 2ZnO + 2SO₂
  • Calcination
    • Heated without air or with little air
    • Carbonate and hydrated ores
    • Gas given off: CO₂ or water vapour
    • Example: ZnCO₃ → ZnO + CO₂

Worked example 2: mass after calcination

How much zinc oxide is obtained from 1.00 kg of pure calamine, and how much mass is lost? Use Zn = 65.38, C = 12.01, O = 16.00. Working: ZnCO₃ → ZnO + CO₂. M(ZnCO₃) = 65.38 + 12.01 + 48.00 = 125.39 g mol⁻¹; M(ZnO) = 65.38 + 16.00 = 81.38 g mol⁻¹. Moles of ZnCO₃ = 1000 ÷ 125.39 = 7.975 mol, giving 7.975 mol ZnO = 7.975 × 81.38 = 649 g ZnO. Mass lost as CO₂ = 1000 − 649 = 351 g (check: 7.975 × 44.01 = 351 g).

Worked example 3: magnesia from magnesite

Magnesite is calcined to give magnesia for refractory bricks. Equation: MgCO₃(s) → MgO(s) + CO₂(g). Check: Mg 1 = 1; C 1 = 1; O 3 = 1 + 2. Using Mg = 24.31: 84.32 g of MgCO₃ (1 mol) gives 40.31 g of MgO and 44.01 g of CO₂.

Key takeaways: leaching dissolves the metal as a soluble complex or salt; cyanide leaching is a redox process and zinc recovers the gold. Roasting (excess air) suits sulphides; calcination (no air) suits carbonates and hydrated ores; both give oxides ready for reduction.

Check your understanding

  1. 1. In the cyanide process for gold, what is the role of oxygen (air)?

    1. It oxidises gold so that it can form [Au(CN)₂]⁻.
    2. It reduces gold to the metal.
    3. It precipitates the gangue.
    4. It forms the froth.
    Show answer

    Answer: A. Gold goes from 0 to +1 in [Au(CN)₂]⁻, which is oxidation, and O₂ (0 → −2 in OH⁻) is the oxidising agent. Zinc, not oxygen, later reduces the gold back to the metal.

  2. 2. Which reaction represents calcination?

    1. 2ZnS + 3O₂ → 2ZnO + 2SO₂
    2. MgCO₃ → MgO + CO₂
    3. Fe₂O₃ + 3CO → 2Fe + 3CO₂
    4. 2Zn + O₂ → 2ZnO
    Show answer

    Answer: B. Calcination heats a carbonate or hydrated ore without air and drives out CO₂ or water: MgCO₃ → MgO + CO₂. Heating ZnS in oxygen is roasting; the CO reaction is reduction; burning zinc is just oxidation.

  3. 3. Roasting of a sulphide ore gives a colourless gas whose aqueous solution is acidic. The gas is

    1. CO₂
    2. H₂S
    3. SO₃
    4. SO₂
    Show answer

    Answer: D. Roasting a sulphide in air, for example 2PbS + 3O₂ → 2PbO + 2SO₂, gives sulphur dioxide, a colourless gas that dissolves in water to form an acidic solution (sulphurous acid).

  4. 4. In alkali leaching of bauxite, which impurities are left undissolved?

    1. Alumina and silica
    2. Iron oxide and titanium oxide
    3. Sodium meta-aluminate
    4. Aluminium hydroxide
    Show answer

    Answer: B. Alumina dissolves in hot NaOH as Na[Al(OH)₄]; iron oxide and titanium oxide do not, and are filtered off. Aluminium hydroxide is precipitated only later, by CO₂.

  5. 5. How many moles of CO₂ are given off when 1 mol of dolomite, MgCO₃·CaCO₃, is calcined completely?

    1. 1 mol
    2. 3 mol
    3. 2 mol
    4. 0.5 mol
    Show answer

    Answer: C. MgCO₃·CaCO₃ → MgO + CaO + 2CO₂. Each carbonate unit gives one CO₂, so 2 mol. Check carbon: 2 on the left, 2 in 2CO₂; oxygen: 6 = 1 + 1 + 4.

Privacy · Terms · Refunds · Delivery