- Practice
- About 22 min
- 5 practice questions
X-rays: production, spectra and uses
Describe the discovery, properties and production of X-rays, explain the continuous spectrum (Bremsstrahlung) and the Duane-Hunt cut-off λ₀ = 12400/V Å, explain characteristic K and L lines, and list the uses of X-rays.
If something looks wrong, please tell us.
By the end of this lesson you can
- State how X-rays were discovered and list their properties.
- Describe the X-ray tube and why targets have high melting points.
- Explain the continuous X-ray spectrum as braking radiation and derive λ₀ = hc/eV = 12400/V Å.
- Explain the characteristic spectrum (K and L series) from electron transitions.
- List the uses of X-rays in medicine, industry and research.
In the photoelectric effect a photon's energy becomes an electron's kinetic energy. Is the reverse possible: can the kinetic energy of an electron become a photon? The answer had already been found in 1895, before Planck's quantum theory: X-rays.
Discovery and properties
Wilhelm Roentgen found in 1895 that fast electrons falling on certain materials produce a highly penetrating radiation. Its nature being unknown, he called it X-rays. They are electromagnetic waves of short wavelength; according to the textbook the range is about 0.1 Å to 100 Å. They travel in straight lines at the speed of light, are not deflected by electric or magnetic fields, and, because their photons are very energetic, pass through materials opaque to visible light. The quality (penetrating power) of X-rays depends on the speed of the electrons striking the target and the atomic number of the target; their intensity depends on the number of electrons striking it.
Production in an X-ray tube
An X-ray tube is an evacuated tube. A tungsten filament heated by a low-tension battery emits electrons by thermionic emission. A high voltage between the filament and the anode accelerates them. The target, of a metal such as tungsten or molybdenum, is set in the face of a solid copper anode and inclined at 45° to the beam so that X-rays leave through the side of the tube. The electrons stop suddenly in the target and X-ray photons are produced. Most of the electrons' kinetic energy becomes heat, so targets of high melting point and a cooling system are used.
X-ray spectra
A graph of X-ray intensity against wavelength (the X-ray spectrum) has two parts: a continuous spectrum of all wavelengths above a minimum λ₀, and sharp peaks on top of it that depend on the target material (the characteristic spectrum). Classical electromagnetic theory could not explain two features: (i) for a given voltage, the shortest wavelength λ₀ is the same for every target; (ii) the intensity jumps at certain sharp wavelengths. The photon theory explains both.
Continuous spectrum (Bremsstrahlung). When a fast electron passes close to a nucleus in the target, the attraction changes its path and slows it down. The radiation from this decelerating electron is Bremsstrahlung ('braking radiation'). The photon carries the kinetic energy the electron loses, hν = E₁ − E₂. An electron may lose any part of its energy, so photons of all energies, a continuous spectrum, are produced. The highest frequency ν₀ (shortest wavelength λ₀) occurs when an electron gives up all its kinetic energy eV in one photon: hν₀ = eV, or hc/λ₀ = eV, so λ₀ = hc/eV. Putting in the values gives the Duane-Hunt formula λ₀ = 12400/V Å (V in volt). λ₀ depends only on the accelerating voltage, not on the target, exactly as observed.
Characteristic spectrum. A fast electron entering a target atom can knock out an electron from the innermost K shell. An electron from an outer shell then drops into the vacancy and the energy difference between the levels is emitted as an X-ray photon of a definite wavelength, characteristic of the target element. Transitions from the L, M, N ... shells to the K shell give the K series (Kα from L, Kβ from M, ...); vacancies in the L shell filled from M, N, O ... give the longer-wavelength L series. The two peaks Kα and Kβ appear clearly in the spectrum of molybdenum.
The two parts of an X-ray spectrum
-
Continuous spectrum
- Braking radiation of decelerated electrons
- All wavelengths above a cut-off λ₀
- λ₀ = 12400/V Å, same for all targets
- Changes with accelerating voltage
-
Characteristic spectrum
- Electron transitions into inner-shell vacancies
- Sharp peaks: Kα, Kβ, L lines
- Wavelengths fixed by the target element
- Appear only when the voltage is high enough to remove inner electrons
Cut-off: eV = hc/λ₀, so λ₀ = 12400/V Å (Duane-Hunt). Continuous = Bremsstrahlung; peaks = inner-shell transitions (K, L series).
Worked example 1: cut-off wavelength and frequency
An X-ray tube runs at 30 kV. λ₀ = 12400/30000 Å = 0.413 Å = 4.13 × 10⁻¹¹ m. Cut-off frequency ν₀ = c/λ₀ = 3 × 10⁸/(4.13 × 10⁻¹¹) = 7.3 × 10¹⁸ Hz. Raising the voltage to 50 kV shortens the cut-off to 12400/50000 = 0.248 Å; the characteristic peaks of the target do not move.
Worked example 2: voltage for a required wavelength, and photon energy
(a) To obtain X-rays as short as 0.50 Å, the least voltage is V = 12400/0.50 = 24800 V ≈ 24.8 kV. (b) The most energetic photon from a 24.8 kV tube has energy eV = 24.8 keV = 24800 × 1.602 × 10⁻¹⁹ = 3.97 × 10⁻¹⁵ J, the full kinetic energy of one electron. (c) By comparison, a visible photon of 500 nm carries only about 2.5 eV, roughly ten thousand times less, which is why X-rays penetrate matter so well.
Applications of X-rays
- Medical diagnosis: X-rays pass through flesh more easily than through bone, so a radiograph shows bones as deep shadows. It reveals fractures, foreign bodies and diseased organs.
- Medical therapy: X-rays can destroy diseased tissue and are used to treat skin diseases and malignant tumours.
- Industry: finding flaws in welded joints, tyres, tennis balls and wood; at customs posts, detecting hidden goods.
- Scientific research: X-ray diffraction by crystals reveals the arrangement of atoms and molecules.
Key takeaways
- X-rays (Roentgen, 1895) are short-wavelength electromagnetic waves, undeflected by fields and highly penetrating.
- They are produced when fast electrons are stopped by a high-melting-point target; most energy becomes heat.
- The continuous spectrum is Bremsstrahlung with cut-off λ₀ = 12400/V Å, independent of the target.
- Characteristic lines (K, L series) come from electrons filling inner-shell vacancies and identify the target.
- Uses: radiographs, therapy, industrial flaw detection, crystal structure studies.
Check your understanding
-
1. The cut-off wavelength of X-rays from a tube operated at 40 kV is:
- 0.62 Å
- 0.31 Å
- 3.1 Å
- 0.031 Å
Show answer
Answer: B. λ₀ = 12400/V Å = 12400/40000 = 0.31 Å.
-
2. Which feature of the X-ray spectrum depends on the target material?
- The sharp characteristic peaks
- The cut-off wavelength
- The existence of a continuous spectrum
- The speed of the X-rays
Show answer
Answer: A. The characteristic lines come from transitions between the inner shells of the target atoms, so their wavelengths identify the element. The cut-off depends only on the voltage.
-
3. Bremsstrahlung means:
- radiation from electrons filling inner-shell vacancies
- radiation emitted by electrons as they are decelerated
- the photoelectric emission of electrons by X-rays
- secondary emission of electrons from the target
Show answer
Answer: B. Bremsstrahlung ('braking radiation') is emitted when fast electrons are slowed by the nuclei of the target; it forms the continuous spectrum.
-
4. The target of an X-ray tube is made of a metal with a high melting point because:
- such metals emit more electrons
- they reflect X-rays
- most of the electrons' kinetic energy becomes heat in the target
- they absorb ultraviolet light
Show answer
Answer: C. Only a small part of the electrons' energy becomes X-rays; most becomes heat, so tungsten or molybdenum targets in a copper anode with cooling are used.
-
5. The Kα line of an element's X-ray spectrum is produced when an electron:
- moves from the K shell to the L shell
- is knocked out of the L shell
- is slowed down by a nucleus
- moves from the L shell into a vacancy in the K shell
Show answer
Answer: D. The K series arises from transitions into a K-shell vacancy; Kα is the transition from the L shell (n = 2) to the K shell (n = 1).
Sign in to keep track of the lessons you finish.