Revision notes

Unit 3 Fluids: Foundation

The key points, rules to remember, tables and diagrams from all 5 lessons, on one page for quick revision. To keep a copy, use your browser's Print and choose "Save as PDF".

Lesson 1

Thrust and pressure

Same force, different areas

  • Small area: high pressure
    • Point of a pin or nail
    • Sharp edge of a knife or axe
    • Narrow heel sinks into soft ground
    • Needle of a syringe
  • Large area: low pressure
    • Wide tyres of trucks and buses
    • Broad feet of a camel on sand
    • Wide foundations of tall buildings
    • School bag with broad straps

Thrust = force normal to a surface (N). Pressure = thrust ÷ area, P = F/A (Pa). 1 Pa = 1 N m⁻². Smaller area, greater pressure.

Key takeaways: thrust is the perpendicular force; pressure is thrust per unit area, measured in pascal. Cutting tools have thin edges to raise pressure; heavy vehicles, buildings and camels spread their weight over large areas to lower it.

Read the full lesson

Lesson 2

Pressure in liquids and the formula P = hρg

Steps to P = hρg

  1. Thrust = weight F = mg
  2. Mass from density m = ρV
  3. Volume of column V = Ah, so m = ρAh
  4. Thrust F = ρAhg
  5. Divide by area P = F/A = hρg

Pressure in a liquid: P = hρg. It increases with depth and density, is the same in all directions at one depth, and does not depend on the container's shape.

Key takeaways: fluids press in all directions, perpendicular to every surface. Liquid pressure depends on depth, density and g, and is given by P = hρg. That is why dams are built thicker at the base and why deep-sea divers need protective suits.

Read the full lesson

Lesson 3

Atmospheric pressure, the barometer, gauge and absolute pressure

How a mercury barometer balances the air

  1. Air presses on the dish Atmospheric pressure on the open mercury surface
  2. Mercury pushed up the tube Vacuum above the column gives no push down
  3. Column stops rising hρg of the column equals air pressure
  4. Read the height About 760 mm at sea level on a typical day
Units of pressure
UnitValue in pascal
1 atm1.013 × 10⁵ Pa = 101.3 kPa
1 bar1 × 10⁵ Pa
So 1 atm≈ 1.013 bar

1 atm = 760 mm of mercury = 1.013 × 10⁵ Pa = 1.013 bar. Absolute pressure = atmospheric pressure + gauge pressure (above atmospheric).

Key takeaways: atmospheric pressure comes from the weight of the air above us and falls as we go higher. A mercury barometer balances a mercury column against the air; 760 mm of mercury is one atmosphere. Gauges read pressure above atmospheric; add atmospheric pressure to get the absolute value.

Read the full lesson

Lesson 4

Pascal's law, the hydraulic press, density and relative density

How a hydraulic lift multiplies force

  1. Small force F₁ Pushes the small piston (area A₁)
  2. Pressure P = F₁/A₁ Created in the liquid
  3. Pascal's law Same P reaches the large piston
  4. Large force F₂ = P × A₂ Lifts the heavy load

Pascal's law: F₁/A₁ = F₂/A₂. Density ρ = m/V (kg/m³; 1 g/cm³ = 1000 kg/m³). Relative density = density of substance ÷ density of water at 4 °C (no unit).

Key takeaways: pressure applied to an enclosed liquid spreads equally everywhere, so a small force on a small piston gives a large force on a large piston. Density is mass per unit volume; relative density compares it with water and has no unit.

Read the full lesson

Lesson 5

Floating, sinking, buoyancy and Archimedes' principle

Floats or sinks

  • Floats
    • Density less than the liquid
    • Upthrust can equal its weight
    • Positively buoyant
    • Wood, ice, a ship, a helium balloon in air
  • Sinks
    • Density greater than the liquid
    • Upthrust is less than its weight
    • Negatively buoyant
    • Stone, an iron nail, a pebble

Archimedes' principle: upthrust = weight of fluid displaced = apparent loss of weight. A floating body displaces its own weight of fluid.

Key takeaways: less dense than the liquid floats; denser sinks. Upthrust comes from the greater pressure below an object and equals the weight of fluid displaced. Hydrometers and lactometers use flotation to measure density.

Read the full lesson

Privacy · Terms · Refunds · Delivery