• Practice
  • About 14 min
  • 5 practice questions

Thrust and pressure

Tell thrust from pressure, calculate pressure as thrust per unit area in pascal, and explain everyday examples such as sharp knives, wide tyres and camels on sand.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Define thrust and pressure and give their SI units.
  • Calculate pressure using P = F/A.
  • Explain why the same force can have very different effects.
  • Give everyday examples of increasing and reducing pressure.

An iron nail sinks in water while a huge ship floats; a drawing pin goes into a board easily by its point but not by its head. Unit 3 of the Tamil Nadu textbook for Std 9 Science explains such facts using pressure. Solids under pressure can deform or break, while fluids (liquids and gases) flow. Liquids are almost incompressible, while gases are easy to compress. We begin with pressure on solid surfaces.

Thrust

Stand on loose sand and your feet sink in; lie down and you hardly sink at all. In both cases the force pressing on the sand is your weight, the same each time. A force acting perpendicular (normal) to a surface is called thrust. Its SI unit is the newton (N). What changes when you lie down is the area over which the thrust is spread.

Pressure

Pressure is the thrust acting on unit area of a surface: pressure = thrust ÷ area, or P = F/A. Its SI unit is newton per square metre (N/m², N m⁻²), named the pascal (Pa) in honour of the French scientist Blaise Pascal: 1 Pa = 1 N m⁻². For the same force, a small area gives a high pressure and a large area gives a low pressure.

Same force, different areas

  • Small area: high pressure
    • Point of a pin or nail
    • Sharp edge of a knife or axe
    • Narrow heel sinks into soft ground
    • Needle of a syringe
  • Large area: low pressure
    • Wide tyres of trucks and buses
    • Broad feet of a camel on sand
    • Wide foundations of tall buildings
    • School bag with broad straps

A single nail pricking your skin hurts, yet performers can lie on a bed of hundreds of nails. Their weight is shared by many points, so the total area of contact is large and the pressure at each point is small.

Worked example 1: pressure of a person standing

Question: A boy of mass 60 kg stands on both feet. The total contact area is 0.03 m². Find the pressure on the floor (g = 10 m/s²). Working: Thrust = weight = mg = 60 × 10 = 600 N. P = F/A = 600 ÷ 0.03 = 20 000 Pa.

Worked example 2: standing on one foot

Question: The same boy now stands on one foot (area 0.015 m²). What happens to the pressure? Working: P = 600 ÷ 0.015 = 40 000 Pa. Halving the area doubles the pressure, though the thrust has not changed.

Worked example 3: a brick on its faces

Question: A brick weighing 30 N measures 0.2 m × 0.1 m × 0.05 m. Find the least and greatest pressure it can exert when resting on a face. Working: Largest face = 0.2 × 0.1 = 0.02 m², giving least pressure = 30 ÷ 0.02 = 1500 Pa. Smallest face = 0.1 × 0.05 = 0.005 m², giving greatest pressure = 30 ÷ 0.005 = 6000 Pa.

Thrust = force normal to a surface (N). Pressure = thrust ÷ area, P = F/A (Pa). 1 Pa = 1 N m⁻². Smaller area, greater pressure.

Key takeaways: thrust is the perpendicular force; pressure is thrust per unit area, measured in pascal. Cutting tools have thin edges to raise pressure; heavy vehicles, buildings and camels spread their weight over large areas to lower it.

Check your understanding

  1. 1. What is the SI unit of pressure?

    1. newton
    2. pascal
    3. joule
    4. newton metre
    Show answer

    Answer: B. Pressure is force per unit area, N/m², which is named the pascal (Pa). The newton is the unit of thrust (force) and the joule (newton metre) the unit of energy.

  2. 2. Why does a sharp knife cut vegetables more easily than a blunt one?

    1. It applies the force over a smaller area, giving greater pressure
    2. It is heavier
    3. It reduces the force needed to zero
    4. It increases the area of contact
    Show answer

    Answer: A. A sharp edge has a very small area of contact, so for the same force the pressure P = F/A is much greater, and the knife cuts easily.

  3. 3. A box of weight 500 N rests on a floor with a base area of 0.25 m². What pressure does it exert?

    1. 125 Pa
    2. 2000 Pa
    3. 500 Pa
    4. 0.0005 Pa
    Show answer

    Answer: B. P = F/A = 500 ÷ 0.25 = 2000 Pa. Multiplying instead (500 × 0.25 = 125) is the wrong way round.

  4. 4. Foundations of tall buildings are made wide so that

    1. they exert more pressure on the ground
    2. the building becomes lighter
    3. the weight is spread over a large area and the pressure on the ground is less
    4. the thrust becomes zero
    Show answer

    Answer: C. A wide foundation increases the area of contact, so the same weight produces less pressure, and the soil below is less likely to give way.

  5. 5. The force acting on a surface stays the same while the area is made three times larger. The pressure becomes

    1. three times larger
    2. nine times larger
    3. unchanged
    4. one-third as large
    Show answer

    Answer: D. P = F/A. With F fixed, multiplying A by 3 divides P by 3, so the pressure becomes one-third of its earlier value.

Privacy · Terms · Refunds · Delivery