• Foundation
  • About 22 min
  • 5 practice questions

Uses of Bernoulli's principle, viscosity and Stokes' law

Apply Bernoulli's principle to the speed of efflux (Torricelli's law) and to dynamic lift, define the coefficient of viscosity, and use Stokes' law to find the terminal velocity of a falling sphere.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Derive Torricelli's law v = √(2gh) for the speed of efflux from an open tank.
  • Explain dynamic lift on a spinning ball (Magnus effect) and an aircraft wing.
  • Define the coefficient of viscosity, its unit and dimensions, and how it changes with temperature.
  • Use Stokes' law F = 6πηav to derive and apply the terminal velocity of a sphere.

Bernoulli's equation turns into some surprising results: water leaving a hole in a tank moves as fast as if it had fallen freely, a spinning ball curves, and a moving wing is pushed up. Real fluids, though, also have internal friction, called viscosity, which is why honey pours slowly and why a raindrop stops speeding up.

Speed of efflux: Torricelli's law

A wide tank holds liquid of density ρ with a small hole a depth h below the free surface. The pressure above the liquid is P and the hole opens to the atmosphere (Pa). Because the tank is much wider than the hole, continuity (A₁v₁ = A₂v₂) makes the speed of the top surface almost zero. Bernoulli between the surface and the hole: Pa + ½ρv² + ρg(0) = P + 0 + ρgh, so v = √[2gh + 2(P − Pa)/ρ]. If the tank is open to the air, P = Pa and

Torricelli's law: v = √(2gh), the same speed a body gains in falling freely through height h.

If instead the pressure P in a closed vessel is very large, the 2gh term can be ignored and the speed of efflux is set by the pressure, as in a rocket.

Worked example 1: water from a hole

An open water tank has a small hole 5.0 m below the water surface. v = √(2 × 9.8 × 5.0) = √98 = 9.9 m s⁻¹.

Dynamic lift

Dynamic lift is the force on a body because of its motion through a fluid. A ball moving without spin has symmetric streamlines above and below, so the air speed and pressure are the same on both sides and there is no sideways force. A spinning ball drags air round with it (more if its surface is rough). On one side the dragged air adds to the relative air flow, on the other side it opposes it, so the air moves faster on one side than the other. By Bernoulli the pressure is lower on the faster side and the ball is pushed towards it. This is the Magnus effect, which makes a spinning cricket or tennis ball swerve from a parabola. An aircraft wing (aerofoil) is shaped and tilted so that streamlines crowd together above it: the air moves faster over the top, the pressure there is lower, and the pressure difference ΔP times the wing area gives the lift that balances the plane's weight.

Worked example 2: lift on a wing (made-up data)

In a model test (made-up practice data), air flows at 80 m s⁻¹ over the top of a wing and 70 m s⁻¹ under it. Wing area 20 m², air density 1.2 kg m⁻³; ignore the small height difference. ΔP = ½ρ(v_top² − v_bottom²) = ½ × 1.2 × (6400 − 4900) = 0.6 × 1500 = 900 Pa. Lift = ΔP × A = 900 × 20 = 1.8 × 10⁴ N.

Viscosity

Put a layer of oil between two glass plates, fix the lower plate and slide the upper one at constant speed v. The layer touching each plate moves with that plate, so the speed of the layers rises steadily from 0 at the bottom to v at the top: this is laminar flow, with layers sliding like the pages of a book. Each layer is dragged forward by the one above and held back by the one below. This internal friction between layers in relative motion is viscosity. Honey needs a larger force than oil for the same speed, so it is more viscous. In a pipe the layer on the axis moves fastest and the layer at the wall is at rest.

In a solid, shear stress is proportional to shear strain; in a flowing fluid the strain keeps growing, and the stress is proportional to the rate of strain, v/l (l = thickness of the layer). The coefficient of viscosity is η = shear stress/strain rate = (F/A)/(v/l) = Fl/(Av). Its SI unit is the poiseuille (Pl), equal to N s m⁻² or Pa s; its dimensions are [ML⁻¹T⁻¹]. Thin liquids such as water and alcohol are less viscous than thick ones such as glycerine and honey, and blood is more viscous than water. The viscosity of a liquid falls as temperature rises, while that of a gas rises.

Worked example 3: finding η

A plate of area 0.050 m² slides at a steady 0.20 m s⁻¹ on a liquid film 1.0 mm thick when pulled by a force of 0.20 N. η = Fl/(Av) = (0.20 × 1.0 × 10⁻³)/(0.050 × 0.20) = (2.0 × 10⁻⁴)/(0.010) = 0.020 Pa s.

Stokes' law and terminal velocity

A sphere of radius a moving at speed v through a fluid of viscosity η feels a viscous drag F = 6πηav (Stokes' law, stated here without derivation), opposite to its motion. A sphere dropped in a fluid first speeds up, but the drag grows with speed until drag plus buoyancy equals its weight. Then the net force is zero and it falls at a constant terminal velocity vt. With sphere density ρ and fluid density σ:

  1. Weight = (4/3)πa³ρg; buoyant force = (4/3)πa³σg.
  2. At terminal velocity: 6πηa vt + (4/3)πa³σg = (4/3)πa³ρg.
  3. So 6πηa vt = (4/3)πa³(ρ − σ)g.
  4. Hence vt = 2a²(ρ − σ)g/(9η).

A sphere falling through a viscous fluid

  1. Released from rest Weight exceeds buoyancy; it accelerates.
  2. Speed rises Viscous drag 6πηav grows with speed.
  3. Forces balance Drag + buoyancy = weight; acceleration becomes zero.
  4. Terminal velocity vt = 2a²(ρ − σ)g/(9η), constant from then on.

Example (made-up values): a ball of radius 1.0 mm and density 8.0 × 10³ kg m⁻³ falls through an oil of density 1.0 × 10³ kg m⁻³ and viscosity 0.50 Pa s. vt = 2 × (1.0 × 10⁻³)² × (7.0 × 10³) × 9.8/(9 × 0.50) = 0.137/4.5 ≈ 0.030 m s⁻¹ = 3.0 cm s⁻¹. Since vt ∝ a², a sphere of twice the radius would fall four times as fast.

Key takeaways

  • Torricelli: v = √(2gh) from an open tank.
  • Faster air on one side means lower pressure there: Magnus effect and wing lift.
  • η = (F/A)/(v/l), unit Pa s (poiseuille), dimensions [ML⁻¹T⁻¹]; falls with temperature for liquids, rises for gases.
  • Stokes: F = 6πηav; terminal velocity vt = 2a²(ρ − σ)g/(9η) ∝ a².

Check your understanding

  1. 1. Water flows out of a small hole 1.8 m below the surface of water in a large open tank. What is the speed of efflux? (g = 9.8 m s⁻²)

    1. 3.0 m s⁻¹
    2. 5.9 m s⁻¹
    3. 8.4 m s⁻¹
    4. 35 m s⁻¹
    Show answer

    Answer: B. Torricelli's law: v = √(2gh) = √(2 × 9.8 × 1.8) = √35.3 ≈ 5.9 m s⁻¹. Forgetting the square root gives about 35.

  2. 2. A spinning ball swerves sideways as it moves through air. The best explanation is that

    1. the spin makes the air move faster past one side, lowering the pressure on that side
    2. the spin increases the weight of the ball
    3. air pressure is the same all round a spinning ball
    4. the ball becomes lighter than air
    Show answer

    Answer: A. A spinning ball drags air with it, so relative to the ball the air moves faster on one side and slower on the other. By Bernoulli the faster side has lower pressure, and the pressure difference pushes the ball sideways: the Magnus effect.

  3. 3. What are the dimensions of the coefficient of viscosity?

    1. [ML⁻¹T⁻²]
    2. [ML⁻¹T⁻¹]
    3. [MLT⁻¹]
    4. [ML²T⁻¹]
    Show answer

    Answer: B. η = (F/A)/(v/l). F/A has dimensions [ML⁻¹T⁻²] and v/l has [T⁻¹], so η has [ML⁻¹T⁻²]/[T⁻¹] = [ML⁻¹T⁻¹]. Its SI unit is Pa s.

  4. 4. Two raindrops of the same material fall through still air; one has twice the radius of the other. If both obey Stokes' law, the ratio of their terminal velocities (large : small) is

    1. 2 : 1
    2. 1 : 2
    3. 8 : 1
    4. 4 : 1
    Show answer

    Answer: D. vt = 2a²(ρ − σ)g/(9η), so vt ∝ a². Doubling the radius gives 2² = 4 times the terminal velocity.

  5. 5. How does viscosity change when temperature rises?

    1. It increases for both liquids and gases
    2. It does not depend on temperature
    3. It increases for liquids and decreases for gases
    4. It decreases for liquids and increases for gases
    Show answer

    Answer: D. In a liquid, warmer molecules move more freely past one another, so η falls. In a gas, a higher temperature increases the random motion that carries momentum between layers, so η rises.

Privacy · Terms · Refunds · Delivery