• Foundation
  • About 22 min
  • 5 practice questions

AC through an inductor and through a capacitor

Show that in a pure inductor the current lags the voltage by π/2 with reactance X_L = ωL, and in a pure capacitor it leads by π/2 with X_C = 1/ωC, and that neither consumes average power.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Derive the current in a pure inductor and define the inductive reactance X_L = ωL.
  • Derive the current in a pure capacitor and define the capacitive reactance X_C = 1/ωC.
  • State the phase relations and draw the phasor diagrams.
  • Show that the average power in a pure inductor or capacitor is zero.

A resistor treats ac and dc alike. Inductors and capacitors do not: an inductor fights changes of current, and a capacitor blocks steady current but lets ac through. Both also shift the current out of step with the voltage.

AC voltage applied to a pure inductor

Connect an inductor L of negligible resistance to v = v_m sin ωt. The loop rule gives v − L di/dt = 0 (the second term is the self-induced emf), so di/dt = (v_m/L) sin ωt.

  1. Integrate: i = −(v_m/ωL) cos ωt + constant.
  2. The source oscillates symmetrically about zero, so the current has no steady part: the constant is zero.
  3. Since −cos ωt = sin (ωt − π/2): i = i_m sin (ωt − π/2), with i_m = v_m/(ωL).

Pure inductor: i = i_m sin (ωt − π/2), i_m = v_m/X_L, inductive reactance X_L = ωL = 2πνL (ohm). The current lags the voltage by π/2 (a quarter cycle).

X_L limits the current just as resistance does, but it grows with frequency: an inductor passes low-frequency current easily and opposes high-frequency current. Inserting an iron core raises L and hence X_L, so a lamp in series with the coil glows more dimly.

AC voltage applied to a capacitor

In a dc circuit a capacitor charges up and then the current stops. With ac it is charged and discharged alternately, so current keeps flowing in the circuit. With charge q and v = q/C = v_m sin ωt:

  1. q = Cv_m sin ωt.
  2. i = dq/dt = ωCv_m cos ωt.
  3. Since cos ωt = sin (ωt + π/2): i = i_m sin (ωt + π/2), with i_m = ωCv_m = v_m/(1/ωC).

Pure capacitor: i = i_m sin (ωt + π/2), i_m = v_m/X_C, capacitive reactance X_C = 1/(ωC) = 1/(2πνC) (ohm). The current leads the voltage by π/2.

X_C falls as frequency rises: a capacitor blocks dc (ω = 0 means infinite reactance) but passes high-frequency current easily. Reducing C raises X_C, so a lamp in series with a smaller capacitor glows more dimly on ac (and not at all on dc).

No average power

In the inductor, p = iv = i_m sin (ωt − π/2) × v_m sin ωt = −(i_m v_m/2) sin 2ωt. In the capacitor, p = (i_m v_m/2) sin 2ωt. Both average to zero over a cycle: energy taken from the source in one quarter-cycle (stored in the magnetic or electric field) is returned in the next.

The three circuit elements on ac
ElementOppositionPhase of currentEffect of raising νAverage power
Resistor RRIn phase with vNo changeI²R
Inductor LX_L = ωLLags v by π/2X_L rises, I fallsZero
Capacitor CX_C = 1/ωCLeads v by π/2X_C falls, I risesZero

Inductor and capacitor on ac

  • Inductor
    • X_L = ωL ∝ ν
    • Current lags voltage by 90°
    • Blocks high frequencies
    • Stores energy in its magnetic field
  • Capacitor
    • X_C = 1/ωC ∝ 1/ν
    • Current leads voltage by 90°
    • Blocks dc and low frequencies
    • Stores energy in its electric field

Worked example 1: an inductor on the mains

A pure inductor of 0.2 H is connected to 230 V, 50 Hz. X_L = 2πνL = 2 × 3.14 × 50 × 0.2 ≈ 62.8 Ω. I = V/X_L = 230 ÷ 62.8 ≈ 3.66 A rms, lagging the voltage by 90°. At 100 Hz X_L would double to 125.6 Ω and the current would halve.

Worked example 2: a capacitor on the mains

A 20 μF capacitor is connected to 230 V, 50 Hz. X_C = 1/(2πνC) = 1 ÷ (2 × 3.14 × 50 × 20 × 10⁻⁶) = 1 ÷ 6.28 × 10⁻³ ≈ 159 Ω. I = 230 ÷ 159 ≈ 1.45 A rms (peak ≈ 2.05 A), leading the voltage by 90°. Doubling the frequency would halve X_C and double the current.

Worked example 3: equal reactances

At what frequency does a 0.1 H inductor have the same reactance as a 10 μF capacitor? 2πνL = 1/(2πνC) gives ν = 1/(2π√(LC)) = 1 ÷ (2π × √(10⁻⁶)) = 1 ÷ (2π × 10⁻³) ≈ 159 Hz. (This frequency becomes important in the next lessons.)

Key takeaways

  • Inductor: X_L = ωL; current lags voltage by π/2.
  • Capacitor: X_C = 1/ωC; current leads voltage by π/2; dc is blocked.
  • Reactances are measured in ohms; X_L rises and X_C falls with frequency.
  • Pure L or C: average power over a cycle is zero.

Check your understanding

  1. 1. A 70 mH inductor is connected to a 220 V, 50 Hz supply. What is the rms current? (π ≈ 3.14)

    1. 3.1 A
    2. 10 A
    3. 0.1 A
    4. 31.4 A
    Show answer

    Answer: B. X_L = 2πνL = 2 × 3.14 × 50 × 0.07 ≈ 22 Ω. I = 220 ÷ 22 = 10 A.

  2. 2. In a purely capacitive ac circuit, the current

    1. lags the voltage by π/2
    2. is in phase with the voltage
    3. leads the voltage by π
    4. leads the voltage by π/2
    Show answer

    Answer: D. For a capacitor i = ωCv_m cos ωt = i_m sin (ωt + π/2): the current reaches its peak a quarter cycle before the voltage, so it leads by π/2.

  3. 3. If the frequency of the supply is doubled, the reactance of a capacitor

    1. is halved
    2. is doubled
    3. is unchanged
    4. becomes four times
    Show answer

    Answer: A. X_C = 1/(2πνC) ∝ 1/ν, so doubling ν halves X_C.

  4. 4. A 50 μF capacitor is connected to a 100 V, 50 Hz supply. What is the rms current? (π ≈ 3.14)

    1. 0.64 A
    2. 15.7 A
    3. 1.57 A
    4. 6.4 A
    Show answer

    Answer: C. X_C = 1/(2πνC) = 1 ÷ (2 × 3.14 × 50 × 50 × 10⁻⁶) = 1 ÷ 0.0157 ≈ 63.7 Ω. I = 100 ÷ 63.7 ≈ 1.57 A.

  5. 5. Assertion (A): A pure inductor connected to an ac source draws current but consumes no average power. Reason (R): The current in a pure inductor lags the voltage by π/2, so the instantaneous power averages to zero over a cycle.

    1. Both A and R are true, and R is the correct explanation of A
    2. Both A and R are true, but R is not the correct explanation of A
    3. A is true, but R is false
    4. A is false, but R is true
    Show answer

    Answer: A. Both are true. With a 90° phase difference, p = −(i_m v_m/2) sin 2ωt, which is positive and negative for equal times; energy stored in the field is returned to the source. R explains A.

Privacy · Terms · Refunds · Delivery