• Practice
  • About 16 min
  • 5 practice questions

Osmotic pressure and the van't Hoff factor

Calculate osmotic pressure, identify isotonic solutions, and use the van't Hoff factor for electrolytes that dissociate or solutes that associate.

If something looks wrong, please tell us.

Osmosis keeps plant cells firm and decides whether a red blood cell swells or shrinks in a drip. Its measure, osmotic pressure, is the fourth colligative property and the most sensitive one, so it is used for large molecules such as proteins. This lesson also fixes the formulas of the previous lesson for salts, which break into ions and so produce more particles than their moles suggest.

Osmosis and osmotic pressure

When a solution and the pure solvent are separated by a semipermeable membrane, which lets solvent molecules pass but not solute particles, solvent flows into the solution. This flow is osmosis. The extra pressure that must be applied to the solution to stop it is the osmotic pressure, π. For dilute solutions it behaves like a gas law.

π = CRT, where C is molarity, R = 0.0821 L atm K⁻¹ mol⁻¹ and T is in kelvin. For electrolytes, π = iCRT.

Worked example 1: osmotic pressure

Find the osmotic pressure of 0.1 M glucose at 300 K. π = 0.1 × 0.0821 × 300 = 2.463 atm. Note that this is a large pressure for a fairly dilute solution, which is why osmotic pressure can detect very small amounts of solute.

Isotonic, hypertonic, hypotonic

Two solutions with the same osmotic pressure at the same temperature are isotonic; no net osmosis occurs between them. A solution with higher osmotic pressure is hypertonic and one with lower is hypotonic. A cell placed in a hypertonic solution loses water and shrinks; in a hypotonic solution it gains water and swells. Applying a pressure larger than the osmotic pressure pushes solvent the other way, out of the solution: this is reverse osmosis, used to purify water.

The van't Hoff factor

Colligative properties count particles. One mole of NaCl in water gives about 2 mol of ions, so it lowers the freezing point about twice as much as 1 mol of glucose. The van't Hoff factor i corrects for this: i = (number of particles actually present) ÷ (number expected from the formula). Every colligative formula is multiplied by i: ΔTf = iKfm, ΔTb = iKbm, π = iCRT.

Ideal values of i
Solute (complete dissociation)Particles per formula uniti
Glucose, urea11
NaCl, KCl22
CaCl₂, K₂SO₄33
AlCl₃44
Al₂(SO₄)₃55

If dissociation is partial, with degree α into n particles, i = 1 + (n − 1)α. If molecules associate, as ethanoic acid molecules pair up into dimers in benzene, there are fewer particles: for complete dimerisation i = 0.5, and in general i = 1 − α(1 − 1/n). The molar mass calculated from a colligative property then appears 'abnormal': observed molar mass = normal molar mass ÷ i.

Worked example 2: freezing point of a salt solution

Find the freezing point of 0.1 m NaCl (Kf = 1.86), assuming complete dissociation. ΔTf = 2 × 1.86 × 0.1 = 0.372 K, so it freezes at −0.372 °C, twice the depression of 0.1 m glucose.

Worked example 3: degree of dissociation

A 0.1 m solution of a salt AB, which dissociates into A⁺ and B⁻, freezes at −0.3348 °C. Expected ΔTf without dissociation = 1.86 × 0.1 = 0.186 K. i = 0.3348 ÷ 0.186 = 1.8. With n = 2, i = 1 + α, so α = 0.8: the salt is 80% dissociated.

Worked example 4: isotonic solutions

Which is isotonic with 0.1 M glucose: 0.1 M NaCl or 0.05 M NaCl? Compare i × C. Glucose: 1 × 0.1 = 0.1. 0.05 M NaCl: 2 × 0.05 = 0.1. So 0.05 M NaCl is isotonic with 0.1 M glucose (assuming complete dissociation).

Key takeaways. Osmotic pressure π = iCRT uses molarity. Isotonic solutions have equal iC at the same temperature. The van't Hoff factor multiplies every colligative property: greater than 1 for dissociation, less than 1 for association, and observed molar mass = normal molar mass ÷ i.

Check your understanding

  1. 1. What is the osmotic pressure of 0.2 M glucose solution at 300 K (R = 0.0821 L atm K⁻¹ mol⁻¹)?

    1. 2.46 atm
    2. 4.93 atm
    3. 9.85 atm
    4. 0.49 atm
    Show answer

    Answer: B. π = CRT = 0.2 × 0.0821 × 300 = 4.926 atm ≈ 4.93 atm.

  2. 2. What is the van't Hoff factor of K₂SO₄ assuming complete dissociation?

    1. 2
    2. 1
    3. 3
    4. 4
    Show answer

    Answer: C. K₂SO₄ → 2K⁺ + SO₄²⁻, giving 3 ions, so i = 3.

  3. 3. Which 0.1 m aqueous solution has the lowest freezing point, assuming complete dissociation of salts?

    1. Glucose
    2. NaCl
    3. CaCl₂
    4. Al₂(SO₄)₃
    Show answer

    Answer: D. ΔTf = iKfm. i values: glucose 1, NaCl 2, CaCl₂ 3, Al₂(SO₄)₃ 5. The largest i gives the largest depression, so the lowest freezing point.

  4. 4. A solute of formula mass 60 dimerises completely in benzene. What molar mass would a freezing-point measurement give?

    1. 120 g/mol
    2. 30 g/mol
    3. 60 g/mol
    4. 240 g/mol
    Show answer

    Answer: A. Complete dimerisation gives i = 0.5. Observed molar mass = 60 ÷ 0.5 = 120 g/mol.

  5. 5. Which solution is isotonic with 0.3 M glucose at the same temperature (assume complete dissociation)?

    1. 0.3 M NaCl
    2. 0.1 M CaCl₂
    3. 0.15 M CaCl₂
    4. 0.6 M urea
    Show answer

    Answer: B. Isotonic means equal iC. Glucose: 0.3. 0.1 M CaCl₂: 3 × 0.1 = 0.3. The others give 0.6, 0.45 and 0.6.

Privacy · Terms · Refunds · Delivery