- Foundation
- About 16 min
- 5 practice questions
Energy from water and the Earth: hydro, tidal and geothermal
Calculate hydroelectric power with P = ρgQhη, and explain how tidal and geothermal energy work.
If something looks wrong, please tell us.
Water that falls from a height carries energy, and so does water lifted and dropped by the tides. Deep below our feet, the Earth itself is hot. This lesson covers three renewable sources that use water or the Earth's heat: hydroelectricity, tidal energy and geothermal energy. Hydro is the one most often tested with a calculation, so we will spend most of our time on it.
How a hydroelectric plant works
A dam holds back a river and creates a reservoir. Water from high in the reservoir flows down a large pipe called a penstock and strikes the blades of a turbine at the bottom, making it spin. The turbine turns a generator, which produces electricity, and the water flows on downstream. The energy chain is simple: the water's stored energy of height (potential energy) becomes energy of motion (kinetic energy), then rotation, then electricity.
Not every plant has a big dam. A run-of-river plant uses the natural flow of a river with little or no storage, so its output follows the river's flow. A storage plant has a reservoir and can release water when electricity is needed. Hydro is renewable because the Sun keeps evaporating water that falls again as rain on high ground.
The hydro power formula
Two things decide how much power a hydro plant can produce: how much water flows each second, and how far it falls. The vertical drop is called the head.
Hydro power P = ρ × g × Q × h × η, where ρ is the density of water (1,000 kg/m³), g is gravity (about 9.8 m/s²), Q is the flow in m³/s, h is the head in metres and η is the efficiency. The answer is in watts.
Worked example 1: a medium plant
A plant has a flow of 10 m³/s, a head of 50 m and an efficiency of 80%. Take g = 10 m/s² to keep the arithmetic easy. P = 1,000 × 10 × 10 × 50 × 0.8. Step by step: 1,000 × 10 = 10,000; × 10 = 100,000; × 50 = 5,000,000; × 0.8 = 4,000,000 W. So the plant produces 4,000,000 W = 4 MW.
Worked example 2: a small village plant
A small stream gives a flow of 0.5 m³/s with a head of 20 m, and the turbine and generator together are 75% efficient. Use g = 9.8 m/s². P = 1,000 × 9.8 × 0.5 × 20 × 0.75. Step by step: 1,000 × 9.8 = 9,800; × 0.5 = 4,900; × 20 = 98,000; × 0.75 = 73,500 W, which is 73.5 kW. Notice that doubling either the flow or the head would double the power: unlike wind, hydro power is simply proportional to each quantity.
Tidal energy
The gravitational pull of the Moon, and to a smaller extent the Sun, raises bulges of water in the oceans. As the Earth rotates, most coasts see the sea rise and fall about twice a day. A tidal barrage is a dam across a bay or estuary: water is trapped at high tide and released through turbines when the tide falls, or flows in through them as the tide rises. Underwater tidal stream turbines work like wind turbines but in moving water. Tides are highly predictable, which is a big advantage, but suitable sites with a large difference between high and low tide are few, and barrages change the habitat of the estuary.
Geothermal energy
The Earth's interior is hot, partly because of heat left from its formation and partly because of radioactive decay in rocks. In some places, often near volcanic regions or along plate boundaries, this heat comes close to the surface as hot springs, geysers or hot rocks. A geothermal plant brings up hot water or steam through wells and uses it to turn a turbine; the cooled water is usually pumped back underground. Geothermal energy can also heat buildings directly. Unlike solar and wind, it is available day and night, but good sites are limited.
Key takeaways
Hydro power comes from falling water: P = ρgQhη, so power is proportional to both flow and head. Run-of-river plants follow the river's flow, while storage plants can choose when to generate. Tidal energy comes from the gravity of the Moon and Sun and is very predictable. Geothermal energy is the Earth's internal heat and works round the clock.
Check your understanding
-
1. In the hydro formula P = ρgQhη, what does h stand for?
- The hours the plant runs each day
- The heat lost in the turbine
- The humidity of the air
- The head, the vertical height through which the water falls
Show answer
Answer: D. h is the head: the vertical drop of the water, in metres.
-
2. A plant has flow 2 m³/s, head 40 m and efficiency 90%. With g = 10 m/s², what power does it produce?
- 800 kW
- 72 kW
- 720 kW
- 7.2 MW
Show answer
Answer: C. P = 1,000 × 10 × 2 × 40 × 0.9 = 720,000 W = 720 kW.
-
3. What causes the tides that tidal power uses?
- Wind blowing across the ocean
- Heat from the Earth's core
- The gravitational pull of the Moon and the Sun
- Rivers flowing into the sea
Show answer
Answer: C. Tides are raised mainly by the Moon's gravity, with a smaller effect from the Sun, as the Earth rotates.
-
4. What is a major advantage of tidal energy over wind energy?
- Tidal sites are found on every coastline
- Tides can be predicted accurately well in advance
- Tidal barrages do not affect estuary habitats
- Tides are strongest at noon every day
Show answer
Answer: B. Tides follow the regular motion of the Moon and Sun, so their timing and size can be predicted. Wind is far less predictable.
-
5. A hydro plant's head is doubled while flow and efficiency stay the same. Its power becomes:
- 4 times as large
- 2 times as large
- 8 times as large
- unchanged
Show answer
Answer: B. P = ρgQhη is directly proportional to h, so doubling the head doubles the power.
Sign in to keep track of the lessons you finish.