- Foundation
- About 12 min
- 5 practice questions
Wave and ocean thermal energy
Understand how the sea's waves and its warm surface and cold depths can be used for power, and how to estimate wave power per metre and the limit set by the temperature difference.
If something looks wrong, please tell us.
The sea holds energy in several forms. Tides, studied earlier, come from gravity. Two other forms come ultimately from the Sun: waves, which the wind raises, and the heat stored in the sunlit surface layer. Both are renewable, but both are hard to harness and are still at the pilot stage in most places. Exams ask how each works and what the limits are.
Wave energy
Wind blowing across the sea raises waves. The stronger the wind, the longer it blows and the greater the stretch of sea it crosses, the bigger the waves. A wave carries energy that depends mainly on its height and on its period, the time between two successive crests. For deep water, a common rule of thumb for the power in a wave is P ≈ 0.5 × H² × T kilowatts per metre of wave front, where H is the wave height in metres and T the period in seconds. Doubling the height gives four times the power.
| Device | How it works |
|---|---|
| Oscillating water column | A chamber open under the water; waves make the water inside rise and fall and push air in and out through a turbine |
| Point absorber | A buoy that moves up and down with the waves and drives a generator |
| Attenuator | A long floating chain of sections that bend with the waves and drive pumps |
Waves are unpredictable and sometimes violent, and equipment is attacked by salt water and storms. So the cost is high and the devices must be strong. Even so, good wave sites are along exposed western coasts where long waves arrive from open ocean.
Ocean thermal energy conversion (OTEC)
In tropical seas the surface water is warm, about 25 to 28 °C, while the water at a depth of around 1,000 m is only a few degrees above freezing, about 5 °C. This difference can run a heat engine. In a closed-cycle plant, warm water boils a liquid such as ammonia, the vapour turns a turbine and cold water from the depth condenses it again. A rule of thumb is that a difference of about 20 °C or more is needed. But the maximum efficiency of any heat engine is 1 − T(cold) ÷ T(hot), with temperatures in kelvin, and a small temperature gap means a very low limit.
Wave power per metre ≈ 0.5 × H² × T kW/m. Maximum heat-engine efficiency = 1 − T(cold) ÷ T(hot), in kelvin (°C + 273).
Worked examples
Example 1. Waves have a height of 2 m and a period of 8 s. Estimate the power per metre of wave front. Working: P ≈ 0.5 × 2² × 8 = 0.5 × 4 × 8 = 16 kW/m. For waves of 3 m and 6 s the figure is 0.5 × 9 × 6 = 27 kW/m. A device that is 10 m wide in the first sea meets 16 × 10 = 160 kW, and if it converts 30% of this to electricity (illustrative), it delivers 48 kW.
Example 2. Find the greatest efficiency of an OTEC plant with surface water at 27 °C and deep water at 5 °C. Working: T(hot) = 27 + 273 = 300 K, T(cold) = 5 + 273 = 278 K. Efficiency = 1 − 278 ÷ 300 = 1 − 0.9267 = 0.0733, about 7.3%. Real plants do worse, and some power is used to pump huge amounts of water.
Example 3. Why does OTEC suit the tropics rather than a cooler sea? Working: if the surface is only 20 °C, T(hot) = 293 K and the maximum efficiency is 1 − 278 ÷ 293 = 0.051, or 5.1%. The smaller the temperature difference, the lower the limit. The tropical surface is warmer all year, so the difference is larger and steadier.
Key takeaways: waves come from wind and carry power that rises with the square of height and with the period; devices include oscillating water columns, buoys and chains; OTEC uses the temperature difference between warm surface water and cold deep water; and its efficiency is low because the difference is small.
Check your understanding
-
1. What mainly causes ocean waves?
- The Moon's pull
- The Earth's rotation
- Wind blowing over the sea
- Underwater volcanoes only
Show answer
Answer: C. Wind blowing across the sea surface raises waves. The Moon and Sun cause tides.
-
2. Using P ≈ 0.5 H² T kW/m, what is the power per metre for waves of 3 m height and 6 s period?
- 27 kW/m
- 9 kW/m
- 18 kW/m
- 54 kW/m
Show answer
Answer: A. P = 0.5 × 9 × 6 = 27 kW/m.
-
3. An oscillating water column uses:
- Tidal flow held behind a barrage wall
- Hot water from the deep sea floor
- Sunlight falling on a floating panel
- Air driven through a turbine by water
Show answer
Answer: D. In an oscillating water column the water level inside a chamber moves with the waves and drives air through a turbine.
-
4. Why is OTEC suited to tropical seas?
- The waves there are always bigger
- A large, steady temperature difference
- The air above is always very calm
- The sea water is much less salty
Show answer
Answer: B. The tropical surface is warm while deep water is cold, so a large and steady temperature difference is available.
-
5. Surface water is 27 °C and deep water 5 °C. What is the greatest possible efficiency?
- About 22%
- About 81%
- About 7%
- About 0.7%
Show answer
Answer: C. Efficiency = 1 − 278 ÷ 300 = 0.073, about 7%.
Sign in to keep track of the lessons you finish.