• Foundation
  • About 13 min
  • 5 practice questions

Everyday solar devices: cookers, water heaters, lanterns and pumps

See how simple solar devices work, how much heat or electricity they give, and how to work out the energy for heating water, running a lantern and lifting water.

If something looks wrong, please tell us.

Large solar plants get the headlines, but many of the most useful solar devices are small. A cooker, a rooftop water heater, a lantern and a pump change daily life where electricity is scarce or fuel is costly. They also provide easy examples for exams, because the calculations use only a few ideas: heat, power and time. This lesson goes through four devices and one worked calculation for each.

How the devices work

DeviceMain partsHow it works
Box-type solar cookerInsulated box, glass lid, reflector, black cooking potsGlass and insulation trap heat, the reflector sends in extra sunlight, black surfaces absorb it
Solar water heaterCollector with black tubes or plate, insulated tankSunlight heats the water; hot water rises to the tank, often by natural circulation
Solar lanternSmall PV panel, battery, LED lampThe panel charges the battery by day; the LED runs on it at night
Solar water pumpPV panels, controller, pumpPanels power the pump during sunny hours; water is stored in a tank for later

Dark surfaces absorb more sunlight than light surfaces, and glass lets sunlight in but keeps the heat from leaving, much like the glass of a greenhouse. Insulation reduces loss of heat. These three ideas explain cookers and water heaters.

Useful formulas

  • Heat needed to warm water: Q = m × c × ΔT, where m is the mass in kg, c is about 4.2 kJ per kg per °C for water, and ΔT is the rise in temperature in °C.
  • Convert: 1 kWh = 3,600 kJ.
  • Electrical energy = power × time. A panel rated at 10 W working the equivalent of 5 full-sun hours gives 50 Wh.
  • Energy to lift water: E = m × g × h, with g about 9.8 m/s² and h in metres, in joules; 3.6 million J = 1 kWh.

Worked example 1: water heater

Example 1. How much heat is needed to warm 100 litres (100 kg) of water from 25 °C to 55 °C, and how large a collector is needed if each square metre delivers 2.5 kWh a day (illustrative)? Working: ΔT = 55 − 25 = 30 °C. Q = 100 × 4.2 × 30 = 12,600 kJ. In kWh: 12,600 ÷ 3,600 = 3.5 kWh. Area = 3.5 ÷ 2.5 = 1.4 m². A larger area gives more hot water or a faster rise.

Worked example 2: lantern

Example 2. A lantern has a 10 W panel and a 3 W LED. The panel gets the equivalent of 5 hours of full sun. How long can the lamp run? Working: energy collected = 10 × 5 = 50 Wh. With 80% of this reaching the lamp after battery losses (illustrative), usable energy = 50 × 0.80 = 40 Wh. Run time = 40 ÷ 3 = 13.3 hours. Without losses it would be 50 ÷ 3 = 16.7 hours. Real devices lose some energy in charging, so the lower figure is more realistic.

Worked example 3: pump

Example 3. A pump lifts 10,000 litres (10,000 kg) of water by 20 m. If the pump and motor are 40% efficient, how much electrical energy is needed, and is a 400 W panel enough with 5 full-sun hours? Working: useful energy = 10,000 × 9.8 × 20 = 1,960,000 J. In kWh: 1,960,000 ÷ 3,600,000 = 0.544 kWh. Electrical energy = 0.544 ÷ 0.40 = 1.36 kWh. The panel supplies 400 × 5 = 2,000 Wh = 2.0 kWh, which is more than 1.36 kWh, so it is enough, with some margin for losses in the wiring and controller.

Q = m × c × ΔT, with c = 4.2 kJ/kg°C. Energy = power × time. Lifting water: E = m g h. Convert kJ to kWh by dividing by 3,600.

Key takeaways: solar cookers and water heaters use heat-trapping boxes or collectors with black absorbers and insulation; lanterns and pumps use photovoltaic panels; heat for water is m × c × ΔT; and always convert units, then compare the energy needed with the energy available.

Check your understanding

  1. 1. Why are the inner surfaces of a solar cooker painted black?

    1. To make the box look neat
    2. To absorb more sunlight
    3. To reflect all the light
    4. To keep the food cold
    Show answer

    Answer: B. Black surfaces absorb sunlight well and turn it into heat.

  2. 2. How much heat is needed to warm 50 kg of water by 20 °C? Use c = 4.2 kJ per kg per °C.

    1. 210 kJ
    2. 1,000 kJ
    3. 4,200 kJ
    4. 8,400 kJ
    Show answer

    Answer: C. Q = 50 × 4.2 × 20 = 4,200 kJ.

  3. 3. A 10 W solar panel gets 5 full-sun hours. How much energy does it collect, ignoring losses?

    1. 2 Wh
    2. 15 Wh
    3. 5 Wh
    4. 50 Wh
    Show answer

    Answer: D. Energy = 10 W × 5 h = 50 Wh.

  4. 4. A 5 W LED runs from 60 Wh of stored energy. For how long?

    1. 12 hours
    2. 300 hours
    3. 55 hours
    4. 0.08 hours
    Show answer

    Answer: A. Time = 60 ÷ 5 = 12 hours.

  5. 5. What is the job of the battery in a solar lantern?

    1. To make the panel much larger
    2. To store energy for use at night
    3. To cool the lamp while it burns
    4. To produce sunlight at night
    Show answer

    Answer: B. The battery stores the electricity from the panel during the day, so the lamp can be used after dark.

Privacy · Terms · Refunds · Delivery