Revision notes

Renewable Energy: Foundation

The key points, rules to remember, tables and diagrams from all 9 lessons, on one page for quick revision. To keep a copy, use your browser's Print and choose "Save as PDF".

Lesson 1

What renewable energy is and why it matters

Common energy sources
SourceRenewable?Where the energy comes from
SolarYesSunlight directly
WindYesSun heats air unevenly, air moves
Hydro (rivers, dams)YesSun lifts water as vapour, rain falls on high ground
Biomass and biogasYesPlants store sunlight by photosynthesis
GeothermalYesHeat from inside the Earth
TidalYesGravity of the Moon and Sun on the oceans
Coal, oil, natural gasNoAncient plants and animals (fossil fuels)
Nuclear (uranium)NoSplitting heavy atoms from a mined stock

Energy = Power × Time. A device of P kilowatts running for t hours uses P × t kilowatt-hours.

Renewable sources are refilled by nature: solar, wind, hydro, biomass, geothermal and tidal. Fossil fuels and nuclear fuel are non-renewable. All renewables except geothermal and tidal come from the Sun. Power is a rate (kW) and energy is an amount (kWh); multiply power by hours to get energy. Variability is the main challenge that renewables bring.

Read the full lesson

Lesson 2

Solar energy: photovoltaic panels and solar thermal

Electrical power out = Sunlight per square metre × Area × Efficiency.

PV and thermal compared
FeatureSolar PVSolar thermal
What it makesElectricity directlyHeat (hot water, steam)
Key partSemiconductor cellCollector or mirrors
Moving partsNone in the cellPumps; turbine in CSP
StorageBatteriesHot water or molten salt tanks

Solar PV uses the photovoltaic effect in a semiconductor to make DC electricity, which an inverter turns into AC. Output equals sunlight per square metre times area times efficiency, and energy equals that power times the hours of full sun. Solar thermal collects heat instead: water heaters for homes, and concentrated solar power, which uses mirrors to raise steam and can store heat for use after dark.

Read the full lesson

Lesson 3

Wind energy: how turbines work and the cube rule

Power in the wind P = ½ × ρ × A × v³, where ρ is air density, A is the swept area and v is the wind speed. Double the speed and the power becomes 2³ = 8 times.

A wind turbine turns moving air into rotation and then into electricity in its generator. Power in the wind is ½ρAv³, so it grows with the cube of wind speed and with the square of blade length. No turbine can capture more than 16/27, about 59.3%, of the wind's power: the Betz limit.

Read the full lesson

Lesson 4

Energy from water and the Earth: hydro, tidal and geothermal

Hydro power P = ρ × g × Q × h × η, where ρ is the density of water (1,000 kg/m³), g is gravity (about 9.8 m/s²), Q is the flow in m³/s, h is the head in metres and η is the efficiency. The answer is in watts.

Hydro power comes from falling water: P = ρgQhη, so power is proportional to both flow and head. Run-of-river plants follow the river's flow, while storage plants can choose when to generate. Tidal energy comes from the gravity of the Moon and Sun and is very predictable. Geothermal energy is the Earth's internal heat and works round the clock.

Read the full lesson

Lesson 5

Biomass, biogas, hydrogen and capacity factor

Capacity factor = Actual energy produced ÷ (Rated power × Hours in the period). A year has 365 × 24 = 8,760 hours.

Biomass releases energy plants stored by photosynthesis and is renewable only if regrown. Biogas, mostly methane, comes from anaerobic digestion of waste and leaves useful fertiliser. Hydrogen is an energy carrier made by electrolysis and used in fuel cells, which produce only water. Capacity factor is actual energy divided by rated power times hours, and it shows how much of the time a plant effectively works at full output.

Read the full lesson

Lesson 6

Biofuels: ethanol, biodiesel and blending

E10 = 10% ethanol by volume. Ethanol (made by fermentation) has less energy per litre than petrol, so a blend gives slightly fewer kilometres per litre.

Key takeaways: ethanol comes from fermenting sugars; biodiesel comes from oils and fats; blend names give the share by volume; and ethanol has less energy per litre than petrol. Yield comes from the balanced equation, volumes from the percentage.

Read the full lesson

Lesson 7

Wave and ocean thermal energy

DeviceHow it works
Oscillating water columnA chamber open under the water; waves make the water inside rise and fall and push air in and out through a turbine
Point absorberA buoy that moves up and down with the waves and drives a generator
AttenuatorA long floating chain of sections that bend with the waves and drive pumps

Wave power per metre ≈ 0.5 × H² × T kW/m. Maximum heat-engine efficiency = 1 − T(cold) ÷ T(hot), in kelvin (°C + 273).

Key takeaways: waves come from wind and carry power that rises with the square of height and with the period; devices include oscillating water columns, buoys and chains; OTEC uses the temperature difference between warm surface water and cold deep water; and its efficiency is low because the difference is small.

Read the full lesson

Lesson 8

Everyday solar devices: cookers, water heaters, lanterns and pumps

DeviceMain partsHow it works
Box-type solar cookerInsulated box, glass lid, reflector, black cooking potsGlass and insulation trap heat, the reflector sends in extra sunlight, black surfaces absorb it
Solar water heaterCollector with black tubes or plate, insulated tankSunlight heats the water; hot water rises to the tank, often by natural circulation
Solar lanternSmall PV panel, battery, LED lampThe panel charges the battery by day; the LED runs on it at night
Solar water pumpPV panels, controller, pumpPanels power the pump during sunny hours; water is stored in a tank for later

Q = m × c × ΔT, with c = 4.2 kJ/kg°C. Energy = power × time. Lifting water: E = m g h. Convert kJ to kWh by dividing by 3,600.

Key takeaways: solar cookers and water heaters use heat-trapping boxes or collectors with black absorbers and insulation; lanterns and pumps use photovoltaic panels; heat for water is m × c × ΔT; and always convert units, then compare the energy needed with the energy available.

Read the full lesson

Lesson 9

Using energy wisely: efficiency, payback and savings

DeviceUseful outputWasted as
Filament bulbLightMostly heat
LED lampLightLittle heat
Electric motorMotionSome heat and noise
Petrol engineMotionMostly heat
Solar panelElectricityHeat and reflection

Efficiency = useful output ÷ input. Payback (years) = cost ÷ annual saving. Energy saved = power saved × hours.

Key takeaways: efficiency is useful output divided by input; saving energy is often cheaper than producing it; energy saved is the difference in power times hours; and payback is cost divided by yearly saving. Any prices in an exam are given to you, never assumed.

Read the full lesson

Privacy · Terms · Refunds · Delivery