• Practice
  • About 16 min
  • 5 practice questions

Energy transfer in a circuit and Joule's law of heating

Explain where the energy in a resistor comes from, derive electrical power P = VI and Joule's law H = I²Rt, and calculate power, heat and resistance with the right units.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Explain how a cell transfers energy to a resistor through moving charge.
  • Use P = VI, P = I²R and P = V²/R, and define the watt.
  • Calculate heat produced using Joule's law, H = I²Rt.

An electric current can make a wire hot, make a magnetic needle turn, and make a motor spin. These are the heating and magnetic effects of electric current, and this chapter studies both. We begin with a basic question: when current flows through a resistor, where does the energy come from and where does it go?

Energy given by the cell

Connect a resistor between points A and B in a circuit with a cell, an ammeter and a voltmeter. Point A, joined to the positive terminal, is at a higher potential than B. If a charge Q moves from A to B across a potential difference V_AB, work equal to V_AB × Q is done on it (you met this in Std 9). The cell is the source of this energy. The resistor receives it and converts it into heat, so its temperature rises. If the resistor were replaced by a motor, the same energy would mostly become mechanical energy.

Electrical power

  1. Power = energy / time = V_AB Q / t.
  2. Since Q / t = I (current), P = V_AB × I.
  3. Unit: 1 volt × 1 ampere = (1 J / 1 C) × (1 C / 1 s) = 1 J/s = 1 watt (W).

Joule's law of heating

If a steady current I flows for time t, the heat produced in the resistor is H = P × t = V × I × t. Using Ohm's law, V = I × R, we get two more useful forms.

Joule's law of heating: H = I² R t. Equivalent forms: H = V I t = (V² / R) t. Power: P = V I = I² R = V² / R.

So the heat produced is proportional to the square of the current, to the resistance and to the time. Doubling the current through the same resistor produces four times the heat in the same time.

Where the energy goes

  1. Chemical energy in the cell The cell pushes charge round the circuit.
  2. Electrical energy carried by charge Each coulomb carries V joules across the resistor.
  3. Work done in the resistor Energy V Q is delivered in time t.
  4. Heat (and sometimes light) The resistor's temperature rises: H = I² R t.

Worked example 1: heat in a resistor

A current of 2 A flows through a 10 Ω resistor for 1 minute. Given: I = 2 A, R = 10 Ω, t = 60 s. H = I² R t = 2² × 10 × 60 = 4 × 10 × 60 = 2400 J.

Worked example 2: using V instead of I

A 6 Ω resistor is connected across 12 V for 5 minutes. P = V² / R = 12² / 6 = 144 / 6 = 24 W. H = P × t = 24 × (5 × 60) = 24 × 300 = 7200 J. Check with current: I = V / R = 12 / 6 = 2 A, so H = I² R t = 4 × 6 × 300 = 7200 J. Both agree.

Worked example 3: finding the voltage

A resistor of 4 Ω produces 100 J of heat every second. Find the potential difference across it. P = 100 W. P = V² / R, so V² = P × R = 100 × 4 = 400 and V = 20 V.

Key takeaways: the cell supplies energy V Q to the resistor, which becomes heat. Electrical power P = VI, measured in watts (1 W = 1 J/s). Joule's law: H = I²Rt = VIt = V²t/R. Heat depends on the square of the current.

Check your understanding

  1. 1. What is the source of the energy converted to heat in a resistor in a simple circuit?

    1. The resistor itself
    2. The connecting wires
    3. The cell
    4. The ammeter
    Show answer

    Answer: C. The cell does work on the charges. The energy V Q carried by the charge is delivered to the resistor, where it becomes heat.

  2. 2. Which unit is equal to 1 watt?

    1. 1 joule per second
    2. 1 joule × 1 second
    3. 1 coulomb per second
    4. 1 volt per ampere
    Show answer

    Answer: A. Power is energy per unit time: 1 W = 1 J/s. (1 C/s is an ampere and 1 V/A is an ohm.)

  3. 3. A current of 3 A flows through a 5 Ω resistor for 10 s. How much heat is produced?

    1. 150 J
    2. 45 J
    3. 75 J
    4. 450 J
    Show answer

    Answer: D. H = I² R t = 3² × 5 × 10 = 9 × 5 × 10 = 450 J.

  4. 4. If the current through a resistor is doubled, keeping everything else the same, the heat produced in the same time becomes:

    1. Double
    2. Four times
    3. Half
    4. Unchanged
    Show answer

    Answer: B. H = I² R t. Doubling I makes I² four times as large, so the heat becomes four times.

  5. 5. Heat is produced in a resistor at the rate of 200 W when a current of 2 A flows. What is its resistance?

    1. 100 Ω
    2. 400 Ω
    3. 50 Ω
    4. 25 Ω
    Show answer

    Answer: C. P = I² R, so R = P / I² = 200 / 2² = 200 / 4 = 50 Ω.

Privacy · Terms · Refunds · Delivery