• Practice
  • About 25 min
  • 15 practice questions

Final self-assessment: Effects of electric current

Test yourself on the whole course: 15 questions with answers explained.

If something looks wrong, please tell us.

Attempt all 15 questions without looking back at the lessons, then check each answer and read the explanation. Write the formula first in numerical questions, then substitute with units.

Final self-assessment

  1. 1. A 12 V battery sends a current of 0.5 A through a lamp for 2 minutes. How much energy does the lamp receive?

    1. 12 J
    2. 720 J
    3. 360 J
    4. 6 J
    Show answer

    Answer: B. Energy = V I t = 12 × 0.5 × (2 × 60) = 6 × 120 = 720 J.

  2. 2. Two resistors of 10 Ω and 20 Ω carry the same current for the same time. The heat produced in the 20 Ω resistor is:

    1. Half that in the 10 Ω resistor
    2. The same
    3. Four times that in the 10 Ω resistor
    4. Twice that in the 10 Ω resistor
    Show answer

    Answer: D. H = I² R t. With I and t the same, H is proportional to R, so the 20 Ω resistor produces twice the heat.

  3. 3. Heat is produced in a resistance at 100 W when a current of 5 A flows. What is the resistance?

    1. 4 Ω
    2. 20 Ω
    3. 500 Ω
    4. 0.25 Ω
    Show answer

    Answer: A. P = I² R, so R = P / I² = 100 / 25 = 4 Ω.

  4. 4. Which uses more electrical energy: an 800 W microwave oven in 15 minutes or a 1200 W heater in 12 minutes?

    1. The microwave oven
    2. Both use the same
    3. The heater
    4. Cannot be found
    Show answer

    Answer: C. Microwave: 800 W × 0.25 h = 200 Wh. Heater: 1200 W × 0.2 h = 240 Wh. The heater uses more energy.

  5. 5. A 1500 W geyser is used for 40 minutes daily for 30 days. At a made-up rate of ₹6 per unit, what is the cost?

    1. ₹180
    2. ₹270
    3. ₹30
    4. ₹1800
    Show answer

    Answer: A. Energy = 1.5 kW × (40/60) h × 30 = 1.5 × 2/3 × 30 = 30 kWh = 30 units. Cost = 30 × 6 = ₹180.

  6. 6. Bulbs of 40 W and 70 W are connected in parallel to a 220 V supply. What current flows in the main wire?

    1. 2 A
    2. 0.18 A
    3. 0.32 A
    4. 0.5 A
    Show answer

    Answer: D. Total power = 40 + 70 = 110 W. I = P / V = 110 / 220 = 0.5 A.

  7. 7. Why is an alloy such as nichrome, not pure copper, used in the heating coil of an electric iron?

    1. Nichrome is a better conductor than copper
    2. Nichrome has high resistivity and does not oxidise easily when red hot
    3. Nichrome is magnetic
    4. Copper cannot carry current
    Show answer

    Answer: B. A heating element needs high resistance to produce heat, and must survive being very hot in air. Nichrome has high resistivity and resists oxidation; copper has low resistivity.

  8. 8. A current flows vertically downwards through a wire passing through a horizontal card. Seen from above, the lines of force around the wire run:

    1. Anticlockwise
    2. Radially outwards
    3. Clockwise
    4. Parallel to the wire
    Show answer

    Answer: C. Point your right thumb downwards (away from you, as seen from above). Your fingers curl clockwise as seen from above.

  9. 9. Which change will NOT increase the magnetic field at the centre of a circular coil?

    1. Increasing the current
    2. Increasing the number of turns
    3. Reversing the direction of the current
    4. Using both more current and more turns
    Show answer

    Answer: C. Reversing the current only reverses the direction of the field; its strength stays the same. More current or more turns make the field stronger.

  10. 10. A straight wire carries current in a magnetic field. Which change will reverse the force on it?

    1. Doubling the current
    2. Reversing the direction of the current
    3. Using a thicker wire
    4. Increasing the field strength
    Show answer

    Answer: B. The force direction depends on the directions of the current and the field. Reversing either one reverses the force. Changing magnitudes changes only the size of the force.

  11. 11. In an electric motor, the carbon brushes:

    1. Rotate with the coil
    2. Produce the magnetic field
    3. Stay still and press on the split ring to carry current to the coil
    4. Reverse the magnetic poles
    Show answer

    Answer: C. The brushes are stationary contacts that press against the rotating split ring halves and carry current in and out of the coil.

  12. 12. Which device converts mechanical energy into electrical energy?

    1. Electric generator
    2. Electric motor
    3. Galvanometer
    4. Voltmeter
    Show answer

    Answer: A. A generator rotates a coil in a magnetic field using mechanical energy and produces an induced current. A motor does the reverse.

  13. 13. A magnet is pushed quickly into a coil connected to a galvanometer, then held still inside. The galvanometer shows:

    1. A steady deflection all the time
    2. No deflection at any time
    3. Deflection only while the magnet moves, then zero
    4. Deflection only while the magnet is still
    Show answer

    Answer: C. Current is induced only while the magnetic lines through the coil are changing, that is, while the magnet moves. When it is still, the current stops.

  14. 14. What is the main difference between an AC generator and a DC generator?

    1. An AC generator uses slip rings; a DC generator uses a split ring
    2. An AC generator has no magnet
    3. A DC generator has no coil
    4. An AC generator needs a battery
    Show answer

    Answer: A. With two full (slip) rings the outer current reverses every half turn (AC). A split ring keeps the outer current in one direction (DC).

  15. 15. Why is electric power transmitted over long distances as AC?

    1. AC cannot cause shocks
    2. AC needs no wires
    3. AC flows only one way
    4. Power loss during transmission can be kept small
    Show answer

    Answer: D. Transmitting power as AC allows the loss of power in long transmission lines to be kept small, which is why power stations supply AC.

Questions 1-3: lesson 1 (power and Joule's law). Questions 4-7: lesson 2 (uses of heating, kWh and safety). Questions 8-9: lesson 3 (magnetic field of a current). Questions 10-11: lesson 4 (force on a conductor and the motor). Questions 12-15: lesson 5 (induction, AC/DC and generators).

Sign in to keep track of the lessons you finish.

Privacy · Terms · Refunds · Delivery