• Practice
  • About 15 min
  • 5 practice questions

Magnetic effect of current: straight wire, loop and solenoid

Describe Oersted's discovery, draw the magnetic field around a straight wire, a circular loop and a solenoid, and use the right hand thumb rule to find the field's direction.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Describe Oersted's observation linking electricity and magnetism.
  • Draw the magnetic lines of force around a straight current-carrying wire and find their direction with the right hand thumb rule.
  • Compare the magnetic field of a solenoid with that of a bar magnet.

Place a magnetic needle next to a thick copper wire in a circuit. When the plug key is closed, the needle turns; reverse the cell connections and it turns the other way. An electric current produces a magnetic effect. This simple observation is the basis of motors, loudspeakers and generators.

Oersted's discovery

In 1820, the scientist Hans Christian Oersted (1777-1851) observed that a magnetic needle near a wire turns through an angle when current flows in the wire. He showed that electricity and magnetism are related. In his honour, a unit of magnetic field intensity is called the oersted.

Field around a straight conductor

Pass a thick wire vertically through a horizontal cardboard and send a large current (about 1 A or more) through it. Iron filings sprinkled on the card arrange themselves in concentric circles around the wire, and magnetic needles placed around it point along these circles.

  • The lines of force are concentric circles with the wire at the centre, in a plane perpendicular to the wire.
  • The field becomes weaker farther from the wire, so the circles are drawn bigger and more widely spaced.
  • A larger current gives a stronger field.
  • Reversing the current reverses the direction of the field.

Right hand thumb rule: hold the conductor in your right hand with the thumb pointing in the direction of the current. Your curled fingers show the direction of the magnetic lines of force. (Also called Maxwell's corkscrew rule.)

Worked example 1: using the thumb rule

A long straight wire lies in the plane of this page with the current flowing upwards (towards the top of the page). Point your right thumb upwards along the wire and curl your fingers. To the right of the wire your fingers go into the page; to the left of the wire they come out of the page. If the current is reversed, both directions reverse.

Field of a circular loop

Bend the wire into a circular loop. Every small part of the loop makes its own circular lines of force. Near the wire the circles are small; towards the centre of the loop they become so large that they look like straight lines. Using the thumb rule at each point, you find that all parts of the loop produce a field in the same direction at the centre, so the effects add up. With n turns, the field is n times that of a single loop.

Field of a solenoid

A solenoid is an insulated copper wire wound in many close loops, like a spring. When current flows through it:

Solenoid compared with a bar magnet

  • Solenoid carrying current
    • One end acts as a north pole, the other as a south pole
    • Lines of force inside are parallel to each other
    • Field inside is uniform
    • Field can be switched off and its strength changed with the current
  • Bar magnet
    • Has a north and a south pole
    • Field pattern outside looks the same as a solenoid's
    • Field is permanent
    • Strength cannot be changed easily

Worked example 2: stronger fields

A coil of 1 turn produces a certain field at its centre with a current of 1 A. With 50 turns and the same current, the field at the centre becomes 50 times stronger. If the current is also doubled to 2 A, the field doubles again, to 100 times the original. So the field of a coil can be increased by increasing the number of turns or the current.

Key takeaways: current produces a magnetic field (Oersted, 1820). Around a straight wire the lines are concentric circles, weaker farther away, stronger for larger current; their direction is given by the right hand thumb rule. A loop's field at the centre is strengthened by more turns. A solenoid behaves like a bar magnet with a uniform field inside.

Check your understanding

  1. 1. Who first observed that a current-carrying wire deflects a magnetic needle?

    1. Michael Faraday
    2. Hans Christian Oersted
    3. Isaac Newton
    4. James Joule
    Show answer

    Answer: B. In 1820 Oersted observed that a magnetic needle near a wire turns when current flows, showing that electricity and magnetism are related.

  2. 2. Which statement correctly describes the magnetic field near a long straight current-carrying wire?

    1. Straight lines parallel to the wire
    2. Straight lines going radially outward
    3. Concentric circles centred on the wire, in a plane perpendicular to it
    4. No field exists outside the wire
    Show answer

    Answer: C. Iron filings form concentric circles around the wire, in a plane perpendicular to it. Their direction is given by the right hand thumb rule.

  3. 3. In the right hand thumb rule, what does the thumb point along?

    1. The direction of the current
    2. The direction of the magnetic field
    3. The north pole
    4. The force on the wire
    Show answer

    Answer: A. The thumb points in the direction of the current; the curled fingers give the direction of the magnetic lines of force.

  4. 4. What happens to the magnetic field around a straight wire as you move farther from it?

    1. It becomes stronger
    2. It stays the same
    3. It reverses direction
    4. It becomes weaker
    Show answer

    Answer: D. For a given current, the field decreases with distance from the wire, which is why the circles are drawn bigger and more widely spaced.

  5. 5. Which is true of the magnetic field inside a long current-carrying solenoid?

    1. It is zero
    2. It is uniform, with parallel lines of force
    3. It forms circles around each turn only
    4. It points in random directions
    Show answer

    Answer: B. Inside a solenoid the lines of force are parallel to each other, which means the field is uniform.

Privacy · Terms · Refunds · Delivery