• Practice
  • About 25 min
  • 15 practice questions

Final self-assessment: Towards green energy

Test yourself on the whole course: 15 questions with answers explained.

If something looks wrong, please tell us.

Attempt all 15 questions in one sitting of about 25 minutes. Keep a rough page ready for the calculations. The questions mix all five lessons and are a little harder than the lesson checks. Check your answers only at the end and read every explanation.

Final self-assessment

  1. 1. In a large commercial generator, electricity is produced because

    1. the coil is heated
    2. a rotating magnet changes the magnetic field around fixed coils
    3. steam flows through the coils
    4. the coils store charge
    Show answer

    Answer: B. Rotating the magnet keeps changing the magnetic field around the coils, inducing a potential difference by electromagnetic induction.

  2. 2. Which part is common to thermal, nuclear, natural gas, hydroelectric and wind power stations?

    1. Boiler
    2. Penstock
    3. Nuclear reactor
    4. Turbine and generator
    Show answer

    Answer: D. All of these drive a turbine that turns a generator; only the energy source and turbine design differ.

  3. 3. The tall stack of a thermal power plant

    1. releases combustion gases from the boiler
    2. cools the condenser water
    3. stores coal
    4. produces steam
    Show answer

    Answer: A. The stack carries flue gases from burning coal high into the atmosphere. The cooling tower cools the condenser water.

  4. 4. A gas plant converts chemical energy → kinetic energy of gases → kinetic energy of turbine → electrical energy. How many energy conversions is that?

    1. 2
    2. 4
    3. 3
    4. 5
    Show answer

    Answer: C. There are four forms in the chain, so there are 3 conversions between them.

  5. 5. Which statement about natural gas plants is correct?

    1. They produce radioactive waste
    2. They are more efficient than coal plants and emit no sulphur oxides
    3. They use a steam turbine
    4. They need no fuel
    Show answer

    Answer: B. Gas plants burn natural gas, which has no sulphur, in a combustion chamber driving a gas turbine; they are more efficient than coal plants.

  6. 6. U-235 + neutron → U-236 → Ba-141 + Kr-92 + x neutrons. Using the mass numbers, x is

    1. 1
    2. 2
    3. 4
    4. 3
    Show answer

    Answer: D. Left: 235 + 1 = 236. Right: 141 + 92 = 233, so 236 − 233 = 3 neutrons.

  7. 7. Which energy change is correct for a nuclear power plant?

    1. Nuclear → thermal → kinetic → electrical
    2. Chemical → thermal → kinetic → electrical
    3. Potential → kinetic → electrical
    4. Light → electrical
    Show answer

    Answer: A. Fission releases nuclear energy as heat, which makes steam; the steam turns the turbine and the generator gives electricity.

  8. 8. Why is electricity from coal NOT called green energy?

    1. Coal is renewable
    2. Coal plants use turbines
    3. Burning coal pollutes the air and coal reserves are limited
    4. Coal gives DC
    Show answer

    Answer: C. Coal emits CO2, sulphur and nitrogen oxides and soot, and its reserves are limited, so it is not environment friendly.

  9. 9. Water is taken to the turbine from about the middle of a dam's height mainly because

    1. it gives a good drop while keeping a dependable supply as the level changes
    2. water at the top is too heavy
    3. the generator is there
    4. it avoids electromagnetic induction
    Show answer

    Answer: A. A middle intake gives a useful height of fall and still draws water when the level drops, while avoiding silt at the very bottom.

  10. 10. 500 kg of water falls 40 m (g = 10 m/s²). The potential energy released is

    1. 20,000 J
    2. 2,00,000 J
    3. 2,000 J
    4. 20,00,000 J
    Show answer

    Answer: B. PE = mgh = 500 × 10 × 40 = 2,00,000 J.

  11. 11. A wind farm needs 7 MW from turbines of 3,500 kW each at full capacity. How many turbines are needed?

    1. 7
    2. 3
    3. 2
    4. 35
    Show answer

    Answer: C. 7 MW = 7,000 kW; 7,000 ÷ 3,500 = 2 turbines.

  12. 12. Ten 100 cm² cells (0.5 V, 3 A each) are joined in series. The output is

    1. 5 V and 3 A
    2. 0.5 V and 30 A
    3. 5 V and 30 A
    4. 50 V and 3 A
    Show answer

    Answer: A. In series the voltages add: 10 × 0.5 = 5 V; the current remains that of one cell, 3 A.

  13. 13. Panels give 18 V and 3 A each. How many panels are needed for an array giving 54 V and 6 A?

    1. 3
    2. 6
    3. 9
    4. 18
    Show answer

    Answer: B. 54 ÷ 18 = 3 panels in series per string; 6 ÷ 3 = 2 strings in parallel; 3 × 2 = 6 panels.

  14. 14. A solar panel receives 400 W of sunlight and is 15% efficient. Its electrical output is

    1. 15 W
    2. 40 W
    3. 85 W
    4. 60 W
    Show answer

    Answer: D. 15% of 400 W = 0.15 × 400 = 60 W.

  15. 15. In a solar thermal power plant, sunlight is first converted into

    1. DC electricity
    2. heat at an absorber
    3. chemical energy in batteries
    4. nuclear energy
    Show answer

    Answer: B. Reflectors focus sunlight onto an absorber where it becomes heat; the heat makes steam for the turbine.

Questions 1-2: lesson 1 (induction and the generator). Questions 3-5: lesson 2 (thermal and gas plants). Questions 6-8: lesson 3 (nuclear power and environment). Questions 9-11: lesson 4 (hydro and wind). Questions 12-15: lesson 5 (solar energy).

Sign in to keep track of the lessons you finish.

Privacy · Terms · Refunds · Delivery