- Practice
- About 25 min
- 15 practice questions
Final self-assessment: Current Electricity
Test yourself on the whole course: 15 questions with answers explained.
If something looks wrong, please tell us.
Attempt all 15 questions before you look at any answer. Write your choice for each on paper, then check every explanation, including the ones you got right, and note which lessons you need to revisit.
Final self-assessment
-
1. A current of 2 mA flows through a circuit for 10 minutes. How much charge passes?
- 1.2 C
- 20 C
- 1200 C
- 0.012 C
Show answer
Answer: A. I = 2 mA = 2 × 10⁻³ A and t = 10 × 60 = 600 s. Q = I × t = 0.002 × 600 = 1.2 C. Forgetting to convert milliamperes gives 1200.
-
2. How many electrons make up a charge of 0.8 C? (Charge of an electron = 1.6 × 10⁻¹⁹ C)
- 1.28 × 10⁻¹⁹
- 2 × 10¹⁸
- 5 × 10¹⁸
- 5 × 10¹⁹
Show answer
Answer: C. Number of electrons = total charge ÷ charge of one electron = 0.8 ÷ (1.6 × 10⁻¹⁹) = 0.5 × 10¹⁹ = 5 × 10¹⁸.
-
3. How much work is done in moving 4 C of charge across a potential difference of 1.5 kV?
- 375 J
- 6000 J
- 6 J
- 0.375 J
Show answer
Answer: B. 1.5 kV = 1500 V. W = V × Q = 1500 × 4 = 6000 J. Using 1.5 instead of 1500 gives the wrong 6 J.
-
4. Which statement about a voltmeter is correct?
- It has a very low resistance and is connected in series
- It has a very low resistance and is connected in parallel
- It has a very high resistance and is connected in series
- It has a very high resistance and is connected in parallel
Show answer
Answer: D. A voltmeter measures the potential difference across a component, so it is connected in parallel. Its very high resistance means it draws only a tiny current and does not disturb the circuit.
-
5. A student records V = 2 V, I = 0.5 A; V = 4 V, I = 1.0 A; V = 6 V, I = 1.5 A for a wire. What is its resistance?
- 4 Ω
- 0.25 Ω
- 2 Ω
- 12 Ω
Show answer
Answer: A. V/I = 2/0.5 = 4/1.0 = 6/1.5 = 4 Ω every time, so the resistance is 4 Ω and the wire obeys Ohm's law. Taking I/V gives the wrong 0.25.
-
6. A component of resistance 0.25 kΩ carries a current of 0.2 A. What is the potential difference across it?
- 0.05 V
- 5 V
- 50 V
- 1250 V
Show answer
Answer: C. 0.25 kΩ = 250 Ω. V = IR = 0.2 × 250 = 50 V. Forgetting to convert kilo-ohms gives 0.05 V.
-
7. Wire A has length L and area of cross-section A. Wire B, of the same material, has length 2L and area 2A. How do their resistances compare?
- B has twice the resistance of A
- Both have the same resistance
- B has half the resistance of A
- B has four times the resistance of A
Show answer
Answer: B. R = ρL/A. For B: ρ(2L)/(2A) = ρL/A, the same as A. Doubling the length doubles R, and doubling the area halves it, so the effects cancel.
-
8. A 1.5 m length of nichrome wire has a resistance of 9 Ω. What length of the same wire has a resistance of 3 Ω?
- 0.5 m
- 4.5 m
- 3 m
- 0.33 m
Show answer
Answer: A. Resistance per metre = 9 ÷ 1.5 = 6 Ω/m. Length for 3 Ω = 3 ÷ 6 = 0.5 m. (R is proportional to L, so one third of the resistance needs one third of the length.)
-
9. Why is the heating coil of an electric iron made of nichrome while the connecting cord is made of copper?
- Nichrome is cheaper than copper
- Copper melts at a lower temperature than nichrome
- Nichrome is a better conductor than copper
- Nichrome has a high resistivity so it heats up; copper has a low resistivity so the cord stays cool
Show answer
Answer: D. A heating element needs high resistance to produce a lot of heat, so a high-resistivity alloy like nichrome is used. The cord should waste as little energy as possible, so low-resistivity copper is used.
-
10. Two resistors have an effective resistance of 50 Ω in series and 12 Ω in parallel. What are their values?
- 25 Ω and 25 Ω
- 20 Ω and 30 Ω
- 10 Ω and 40 Ω
- 15 Ω and 35 Ω
Show answer
Answer: B. R₁ + R₂ = 50. In parallel, Rp = R₁R₂/(R₁ + R₂) = 12, so R₁R₂ = 600. Two numbers adding to 50 and multiplying to 600 are 20 and 30. Check: 20 × 30 ÷ 50 = 12 Ω.
-
11. Two 6 Ω resistors are connected in parallel, and this pair is connected in series with a third 6 Ω resistor. What is the total resistance?
- 18 Ω
- 2 Ω
- 9 Ω
- 4 Ω
Show answer
Answer: C. The parallel pair: 6 ÷ 2 = 3 Ω. In series with 6 Ω: 3 + 6 = 9 Ω.
-
12. Resistors of 10 Ω and 15 Ω are connected in parallel across a 6 V battery. What current flows through the 15 Ω resistor?
- 1.0 A
- 0.6 A
- 2.5 A
- 0.4 A
Show answer
Answer: D. In parallel each resistor has the full 6 V across it. Through 15 Ω: I = 6 ÷ 15 = 0.4 A. (Through 10 Ω it is 0.6 A, and the total is 1.0 A.)
-
13. On a 220 V circuit protected by a 5 A fuse, a 55 Ω heater and a 1100 Ω lamp are on. A second 55 Ω heater is switched on. What happens?
- Nothing; the total current is 4.2 A
- The lamp goes dim but the fuse holds
- The fuse melts because the total current becomes 8.2 A
- The fuse melts because the current through the lamp becomes 5 A
Show answer
Answer: C. Each heater draws 220 ÷ 55 = 4 A and the lamp 220 ÷ 1100 = 0.2 A. With both heaters the total is 4 + 4 + 0.2 = 8.2 A, more than 5 A, so the fuse melts. The lamp still gets 220 V, so it is not dimmed.
-
14. What is the purpose of the earth wire in household wiring?
- To bring current into the house
- To carry the current back to the pole in normal use
- To increase the voltage of the supply
- Safety: it gives a path to the ground through a metal plate buried near the house
Show answer
Answer: D. The earth wire is joined to a metal plate buried deep in the ground. It is there for safety; in normal use the live wire brings current in and the neutral wire carries it back.
-
15. In a house, the TV stops working because of a fault inside it. What happens to the other appliances?
- They keep working, because each is connected in parallel with its own path
- They all stop, because the appliances are in series
- They all work at a lower voltage
- They all draw more current and their fuses melt
Show answer
Answer: A. Household appliances are connected in parallel between the live and neutral wires. A fault in one path does not break the others, which still get the full supply voltage.
Questions 1-3: lesson 1 (potential difference and current). Questions 4-6: lesson 2 (circuits and Ohm's law). Questions 7-9: lesson 3 (resistance and resistivity). Questions 10-12: lesson 4 (series and parallel). Questions 13-15: lesson 5 (household wiring and safety).
Sign in to keep track of the lessons you finish.