• Practice
  • About 15 min
  • 5 practice questions

Potential difference, free electrons and electric current

Explain electric potential and potential difference, describe how free electrons carry charge in a metal wire, and calculate potential difference (V = W/Q) and current (I = Q/t) with their units.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Compare the flow of charge with the flow of water between two levels.
  • Define potential difference and the volt, and use V = W/Q.
  • Explain what free electrons are and how they move when a cell is connected.
  • Define electric current and the ampere, use I = Q/t, and state the direction of conventional current.

Fans, pumps, mixers, hospital machines and factory motors all run on electricity, and a power cut shows how much we depend on it. Even some animals, such as eels, use electricity to stun prey. To understand how electricity flows through a wire, we start with an idea we already know from water.

Electric potential and potential difference

Water flows from a higher level to a lower level, as when water released from a dam falls to turn a turbine. Connect two bottles at different heights with a tube and water flows until the levels are equal. Electric charge behaves in a similar way: the flow of charge between two points depends on a kind of electric level at those points, called the electric potential.

Positive charge flows from higher potential to lower potential. Work has to be done to carry a positive charge from lower to higher potential, just as work is needed to lift water. The work done to carry a unit positive charge from one point to another is the potential difference (V) between them: V = W/Q, where W is the work and Q the charge.

The SI unit of potential difference is the volt (V), named after Alessandro Volta, who built the first electric cell. 1 volt = 1 joule per coulomb: if 1 J of work is needed to move 1 C of charge between two points, their potential difference is 1 V. Small values are written in millivolts (1 mV = 10⁻³ V) or microvolts (1 μV = 10⁻⁶ V), and large ones in kilovolts (1 kV = 10³ V) or megavolts (1 MV = 10⁶ V).

In a cell, chemical reactions keep one terminal at a higher potential than the other. This potential difference of the cell sets electrons moving through a wire joined across its terminals. If two charged conductors at different potentials are joined by a wire, electrons flow until both reach the same potential; then the flow stops. A lightning strike is a huge flow of electrons from a cloud at negative potential to the earth.

Worked example 1: work and potential difference

Question: (a) 18 J of work is done to move 3 C of charge between two points. Find the potential difference. (b) How much work is needed to move 2 C across the terminals of a 9 V battery?

Working: (a) V = W/Q = 18 J ÷ 3 C = 6 V. (b) W = V × Q = 9 V × 2 C = 18 J.

Free electrons

In each atom of a metal, one or more outermost electrons are only weakly held by the nucleus. These free electrons can move easily from atom to atom through the metal, carrying their negative charge with them. Without a cell, they wander randomly in all directions, so there is no overall flow. When the ends of the wire are joined to a cell, an electric force acts on them and they drift from the negative terminal (lower potential) towards the positive terminal (higher potential). Their motion is still irregular, but their average velocity is now a definite, non-zero value in one direction, and this drift is the electric current.

How a cell makes current flow in a wire

  1. Chemical reactions in the cell Create a potential difference between its terminals.
  2. Wire joined across the cell An electric force now acts on the free electrons.
  3. Electrons drift From the negative terminal, through the wire, towards the positive terminal.
  4. Current flows Charge passes every cross-section of the wire.

Electric current

Electric current (I) is the charge passing through a cross-section of a conductor in unit time: I = Q/t. The SI unit of charge is the coulomb (C) and of current the ampere (A), named after the French scientist André-Marie Ampère. One ampere flows when one coulomb of charge passes in one second. Smaller currents are written in milliamperes (1 mA = 10⁻³ A) and microamperes (1 μA = 10⁻⁶ A). The charge of one electron is 1.6 × 10⁻¹⁹ C, so one coulomb is the charge of about 6.25 × 10¹⁸ electrons.

By convention, the direction of current is taken from the positive terminal to the negative terminal through the outer circuit, which is opposite to the direction in which electrons actually move. This convention was fixed before electrons were discovered, and it is still used in all circuit diagrams.

Worked example 2: charge from current

Question: A current of 1.5 A flows through a lamp for 2 minutes. How much charge passes, and about how many electrons is that?

Working: t = 2 × 60 = 120 s. Q = I × t = 1.5 × 120 = 180 C. Number of electrons = 180 ÷ (1.6 × 10⁻¹⁹) = 1.125 × 10²¹.

Potential difference V = W/Q (1 V = 1 J/C). Current I = Q/t (1 A = 1 C/s). Electrons move from − to +; conventional current is taken from + to −.

Key takeaways: charge flows because of a potential difference, just as water flows because of a difference in level. Free electrons carry the charge in metals. Current is charge per second; potential difference is work per unit charge.

Check your understanding

  1. 1. What is the SI unit of potential difference?

    1. Ampere
    2. Volt
    3. Coulomb
    4. Ohm
    Show answer

    Answer: B. Potential difference is work per unit charge (joule per coulomb), and this unit is called the volt. The ampere measures current, the coulomb charge and the ohm resistance.

  2. 2. 60 J of work is done in moving 5 C of charge between two points. What is the potential difference between them?

    1. 300 V
    2. 12 V
    3. 0.083 V
    4. 65 V
    Show answer

    Answer: B. V = W/Q = 60 J ÷ 5 C = 12 V. Multiplying work by charge gives the wrong 300.

  3. 3. Free electrons in a metal are

    1. electrons tightly bound inside the nucleus
    2. electrons that have left the metal for the air
    3. weakly bound outermost electrons that can move from atom to atom
    4. positive particles that carry current
    Show answer

    Answer: C. In a metal, the outermost electrons of each atom are only weakly held, so they can move freely between atoms. These free electrons carry the negative charge when a current flows.

  4. 4. In the wire outside a cell, the conventional current flows

    1. from the positive terminal to the negative terminal, opposite to the electrons
    2. from the negative terminal to the positive terminal, along with the electrons
    3. in both directions at once
    4. only inside the cell
    Show answer

    Answer: A. Electrons drift from the negative terminal to the positive terminal, but conventional current is taken in the opposite direction, from positive to negative in the outer circuit.

  5. 5. A current of 0.5 A flows through a wire for 4 minutes. How much charge passes through it?

    1. 2 C
    2. 8 C
    3. 480 C
    4. 120 C
    Show answer

    Answer: D. Convert time to seconds: 4 × 60 = 240 s. Q = I × t = 0.5 A × 240 s = 120 C.

Sign in to keep track of the lessons you finish.

Next lesson → Electric circuits and Ohm's law

Privacy · Terms · Refunds · Delivery