• Foundation
  • About 12 min
  • 5 practice questions

Cells, batteries and circuit diagrams

Name common circuit components and symbols, tell a cell from a battery, and find the voltage of cells joined in series and in parallel.

If something looks wrong, please tell us.

Every torch, remote control and mobile phone is built round a simple circuit with a source of energy. Engineers draw circuits using symbols so that anyone can read them. In this lesson you will learn the common symbols, the difference between a cell and a battery, and how joining cells changes the voltage. The numbers are illustrative.

Cell and battery

A cell is a single unit that turns chemical energy into electrical energy. A common dry cell gives about 1.5 V. A battery is a group of two or more cells joined together, though in everyday speech, one cell is often called a battery. A car battery, for example, is a set of cells. When the chemical in a cell is used up, the cell is finished, unless it is a rechargeable type, which can be recharged by passing a current backward through it.

Circuit symbols

Common components
ComponentJobSymbol idea
CellSource of energyLong line (positive) and short line (negative)
BatterySeveral cellsPair or more of such lines
SwitchOpens or closes the circuitGap that can be closed
BulbGives lightCircle with a cross
ResistorOpposes currentRectangle
AmmeterMeasures currentCircle with A
VoltmeterMeasures potential differenceCircle with V

Drawing a circuit diagram means placing these symbols in order with straight lines for wires. A circuit works only if the loop is complete, with no gaps. A switch that is open breaks the loop. A short circuit occurs when a wire of very low resistance joins two points directly. A very large current flows, which can overheat wires and drain a cell quickly.

Cells in series

In a series connection, the positive end of one cell is joined to the negative end of the next. The voltages add up. Cells in series give a higher voltage, which is needed for devices that require more energy for each unit of charge.

Cells in parallel

In a parallel connection, all positive ends are joined together and all negative ends are joined together. The voltage stays the same as for one cell, but the cells share the work, so the set lasts longer.

Worked example 1: series

Four cells of 1.5 V each are joined in series. The total voltage = 4 × 1.5 = 6 V. A bulb that needs 6 V will therefore light at its normal brightness. How many cells would be needed for a 9 V device? 9 / 1.5 = 6 cells.

Worked example 2: parallel

Three cells of 1.5 V each are joined in parallel. The voltage across the set is still 1.5 V. Each cell supplies only one-third of the current, so the set lasts longer than one cell would. Joining cells in parallel does not raise the voltage.

Worked example 3: how long will it last?

A cell pack stores 2.4 ampere-hours of charge (2.4 Ah). A toy draws 0.3 A. Time = 2.4 / 0.3 = 8 hours. This is an approximation, because a real battery gives less when the current is large.

Series: voltages add. Parallel: voltage stays the same and the set lasts longer. A circuit works only when it is a complete loop.

— Rule to remember

Key takeaways

  • A battery is a group of cells.
  • Series raises the voltage; parallel raises the lifetime.
  • Circuits need a complete path.
  • A short circuit gives a dangerously large current.

Check your understanding

  1. 1. Three 1.5 V cells in series give a total of:

    1. 1.5 V
    2. 3.0 V
    3. 4.5 V
    4. 0.5 V
    Show answer

    Answer: C. Series voltages add: 3 × 1.5 = 4.5 V.

  2. 2. Three 1.5 V cells in parallel give a total of:

    1. 4.5 V
    2. 1.5 V
    3. 0.5 V
    4. 3 V
    Show answer

    Answer: B. Parallel cells keep the voltage of a single cell, which is 1.5 V.

  3. 3. Which symbol idea represents a switch?

    1. A circle with A
    2. A rectangle
    3. A circle with a cross
    4. A gap that can be closed
    Show answer

    Answer: D. A switch is shown as a gap in the wire that can be closed. A circle with A is an ammeter, a rectangle a resistor, and a circle with a cross a bulb.

  4. 4. A device needs 7.5 V. How many 1.5 V cells in series are needed?

    1. 5
    2. 4
    3. 6
    4. 3
    Show answer

    Answer: A. 7.5 / 1.5 = 5 cells.

  5. 5. A pack stores 3 Ah and the load draws 0.5 A. How long will it last?

    1. 1.5 hours
    2. 0.5 hours
    3. 6 hours
    4. 3 hours
    Show answer

    Answer: C. Time = 3 / 0.5 = 6 hours.

Privacy · Terms · Refunds · Delivery