- Practice
- 15 practice questions
Final self-assessment: Pressure practice
Test yourself on the whole course: 15 questions with answers explained.
If something looks wrong, please tell us.
Attempt all 15 questions on pressure practice first, then check your answers and read each explanation. The questions follow the lessons in order - questions 1-3: lesson 1 (Pressure and its units); questions 4-6: lesson 2 (Pressure in liquids); questions 7-9: lesson 3 (Pascal's law and hydraulic machines); questions 10-12: lesson 4 (Buoyancy and Archimedes' principle); questions 13-15: lesson 5 (Atmospheric pressure, manometers and Bernoulli's principle). Revisit a lesson for any question you missed.
Final self-assessment
-
1. A force of 20 N presses a pin onto a board through a contact area of 0.5 cm². What is the pressure?
- 40 Pa
- 4 × 10³ Pa
- 4 × 10⁵ Pa
- 1 × 10⁻⁴ Pa
Show answer
Answer: C. 0.5 cm² = 0.5 × 10⁻⁴ m². P = 20 ÷ (0.5 × 10⁻⁴) = 4 × 10⁵ Pa.
-
2. Which of these pressures is the largest? (1 atm = 1.013 × 10⁵ Pa = 760 mm of mercury, 1 bar = 10⁵ Pa)
- 2 bar
- 2 atm
- 150 kPa
- 1400 mm of mercury
Show answer
Answer: B. 2 atm = 2.026 × 10⁵ Pa; 2 bar = 2.000 × 10⁵ Pa; 150 kPa = 1.5 × 10⁵ Pa; 1400 mm Hg = (1400 ÷ 760) × 1.013 × 10⁵ ≈ 1.87 × 10⁵ Pa. The largest is 2 atm.
-
3. Why are railway tracks laid on wide sleepers?
- To spread the weight over a larger area and reduce the pressure on the ground
- To increase the pressure on the ground for a better grip
- To make the train lighter
- To raise the force the rails exert on the ground
Show answer
Answer: A. For the same force, a larger area gives a smaller pressure, so the ground below does not sink.
-
4. At what depth in water is the absolute pressure 3 × 10⁵ Pa? (P_atm = 10⁵ Pa, water 1000 kg/m³, g = 10 m/s²)
- 20 m
- 30 m
- 10 m
- 3 m
Show answer
Answer: A. Gauge pressure = 3 × 10⁵ − 10⁵ = 2 × 10⁵ Pa = h × 1000 × 10, so h = 20 m.
-
5. A tank holds 0.3 m of water with a 0.5 m layer of oil (density 800 kg/m³) floating on top. What is the pressure due to the liquids at the bottom? (water 1000 kg/m³, g = 10 m/s²)
- 4000 Pa
- 7000 Pa
- 8000 Pa
- 6400 Pa
Show answer
Answer: B. Each layer adds hρg: oil 0.5 × 800 × 10 = 4000 Pa, water 0.3 × 1000 × 10 = 3000 Pa. Total = 7000 Pa.
-
6. A conical flask that narrows upwards and a cylinder both have a base of 0.1 m² and hold water to a height of 0.5 m. What force does the water exert on the base of the conical flask? (water 1000 kg/m³, g = 10 m/s²)
- Less than 500 N, because it holds less water
- More than 500 N, because it is narrow at the top
- 500 N
- 5000 N
Show answer
Answer: C. The pressure at the base is hρg = 0.5 × 1000 × 10 = 5000 Pa in both, whatever the shape. Force = 5000 × 0.1 = 500 N, the same as for the cylinder.
-
7. The small piston of a hydraulic press has a diameter of 2 cm and the large piston 12 cm. A force of 50 N acts on the small piston. What force acts on the large piston?
- 300 N
- 600 N
- 50 N
- 1800 N
Show answer
Answer: D. Area ratio = (12 ÷ 2)² = 36. F₂ = 50 × 36 = 1800 N.
-
8. A press with pistons of 10 cm² and 500 cm² lifts a 5000 N load. The small piston moves down 25 cm. How much work is done on the small piston?
- 1250 J
- 2500 J
- 25 J
- 0.5 J
Show answer
Answer: C. F₁ = 5000 × 10 ÷ 500 = 100 N; work = 100 × 0.25 = 25 J. Check: the load rises 25 ÷ 50 = 0.5 cm, and 5000 × 0.005 = 25 J.
-
9. A piston increases the pressure on a liquid enclosed in a vessel by 3 × 10⁴ Pa. By how much does the pressure increase at the bottom of the vessel, far from the piston?
- 3 × 10⁴ Pa
- Less than 3 × 10⁴ Pa, as it weakens with distance
- Zero, as only the piston face is affected
- More than 3 × 10⁴ Pa, as depth adds to it
Show answer
Answer: A. By Pascal's law a pressure change is transmitted undiminished to every point of the enclosed liquid, so the increase is 3 × 10⁴ Pa everywhere.
-
10. A cork of density 200 kg/m³ is held completely under water (1000 kg/m³). How does the upthrust compare with its weight?
- 4 times its weight
- One-fifth of its weight
- Equal to its weight
- 5 times its weight
Show answer
Answer: D. Fully submerged, upthrust = Vρ_water g and weight = Vρ_cork g. Ratio = 1000 ÷ 200 = 5.
-
11. A block of mass 5 kg and density 2500 kg/m³ is fully immersed in water. What is its apparent weight? (water 1000 kg/m³, g = 10 m/s²)
- 20 N
- 30 N
- 50 N
- 70 N
Show answer
Answer: B. Volume = 5 ÷ 2500 = 0.002 m³. Upthrust = 0.002 × 1000 × 10 = 20 N. Apparent weight = 50 − 20 = 30 N.
-
12. A body of density 800 kg/m³ floats in water (1000 kg/m³). What fraction of its volume is above the surface?
- 80%
- 20%
- 25%
- 8%
Show answer
Answer: B. Fraction submerged = 800 ÷ 1000 = 80%, so 100% − 80% = 20% is above the surface.
-
13. Water flows at 0.5 m/s in a pipe of radius 3 cm that narrows to radius 1 cm. What is the speed in the narrow part?
- 1.5 m/s
- 0.17 m/s
- 9 m/s
- 4.5 m/s
Show answer
Answer: D. Area ∝ r², so the area ratio = (3 ÷ 1)² = 9. v₂ = 0.5 × 9 = 4.5 m/s.
-
14. In a horizontal pipe, water speeds up from 2 m/s to 6 m/s. What is the pressure difference between the two parts? (water 1000 kg/m³)
- 16 000 Pa
- 8000 Pa
- 32 000 Pa
- 18 000 Pa
Show answer
Answer: A. P₁ − P₂ = ½ρ(v₂² − v₁²) = ½ × 1000 × (36 − 4) = 500 × 32 = 16 000 Pa.
-
15. A hole is made 0.45 m below the water surface of a wide open tank. What is the speed of the water leaving it? (g = 10 m/s²)
- 9 m/s
- 0.9 m/s
- 3 m/s
- 4.5 m/s
Show answer
Answer: C. v = √(2gh) = √(2 × 10 × 0.45) = √9 = 3 m/s.
Sign in to keep track of the lessons you finish.