• Practice
  • About 15 min
  • 5 practice questions

Liquid pressure problems: layers, U-tubes and thrust on a wall

Find pressure under layered liquids, balance liquids in a U-tube from the common level, and calculate the thrust on a vertical wall.

If something looks wrong, please tell us.

Questions on liquid pressure move quickly from the single formula P = hρg to layered liquids, U-tubes and dam walls. The ideas are only a small extension, but each has a typical trap. Take g = 10 m/s² and the density of water as 1000 kg/m³ throughout.

Layered liquids

When immiscible liquids lie in layers, the gauge pressure at the bottom is the sum of the pressures of the layers: P = h₁ρ₁g + h₂ρ₂g + ... Each layer contributes its own thickness and its own density. If the top is open to air, the absolute pressure at the bottom is P_atm + this sum.

The U-tube with two liquids

In a U-tube containing two liquids that do not mix, draw a horizontal line through the lower boundary of the lighter liquid, which is where it meets the denser liquid. Points on that line in the two arms are at the same level in the same connected liquid, so their pressures are equal. The atmosphere presses on both open ends and cancels. Therefore h₁ρ₁ = h₂ρ₂, where each h is measured upwards from the common line to the free surface. The heavier liquid has the shorter column.

Thrust on a vertical wall

On a vertical dam wall the pressure increases from zero at the surface to ρgH at the bottom, where H is the depth. Because it increases uniformly, the average pressure is half of the bottom value: P_avg = ½ρgH. For a rectangular wall of width w and wetted height H, the thrust is F = P_avg × (H × w) = ½ρgH²w. If the depth doubles, the thrust becomes four times as large.

Worked examples

Example 1. A tank holds a 0.2 m layer of oil (density 800 kg/m³) floating on a 0.3 m layer of water. Gauge pressure at the bottom = 0.2 × 800 × 10 + 0.3 × 1000 × 10 = 1600 + 3000 = 4600 Pa.

Example 2. In a U-tube, water stands 16 cm above the common line in one arm. Oil of density 800 kg/m³ is poured into the other arm until the two surfaces balance. Then h_oil × 800 = 16 × 1000, so h_oil = 20 cm. The lighter oil needs the taller column.

Example 3. Mercury has a density of 13 600 kg/m³. A water column of 13.6 cm is balanced by a mercury column h where h × 13 600 = 13.6 × 1000, so h = 1 cm. This is why a small height of mercury is enough to measure large pressures.

Example 4. A rectangular wall holds back water 6 m deep and is 10 m wide. Average pressure = ½ × 1000 × 10 × 6 = 30 000 Pa. Wetted area = 6 × 10 = 60 m². Thrust = 30 000 × 60 = 1.8 × 10⁶ N. If the depth rose to 12 m, the thrust would be ½ × 1000 × 10 × 12² × 10 = 7.2 × 10⁶ N, four times larger. The depth and width here are illustrative numbers only.

Gauge pressure under layers = Σ hρg. U-tube: h₁ρ₁ = h₂ρ₂ from the common level. Wall thrust = ½ρgH² × width.

— Rule to remember

Traps

  • Measuring both columns from the bottom of the U-tube instead of from the common level.
  • Using the full bottom pressure ρgH as if it acted all over a vertical wall; use the average pressure for the thrust.
  • Adding atmospheric pressure when the question asks for gauge pressure.

Key takeaways

  • Add the layers; each uses its own density.
  • In a U-tube the denser liquid has the shorter column.
  • Thrust on a wall depends on the square of the depth.

Check your understanding

  1. 1. A tank has 0.5 m of water under 0.1 m of oil of density 900 kg/m³. The gauge pressure at the bottom is:

    1. 5900 Pa
    2. 4500 Pa
    3. 5000 Pa
    4. 9000 Pa
    Show answer

    Answer: A. P = 0.5 × 1000 × 10 + 0.1 × 900 × 10 = 5000 + 900 = 5900 Pa.

  2. 2. In a U-tube, a liquid of density 1200 kg/m³ stands 10 cm above the common level. Another liquid of density 800 kg/m³ balances it. Its height above the common level is:

    1. 6.7 cm
    2. 12 cm
    3. 8 cm
    4. 15 cm
    Show answer

    Answer: D. h × 800 = 10 × 1200, so h = 15 cm. The lighter liquid needs the taller column.

  3. 3. The depth of water behind a vertical wall is doubled. The total thrust on the wall becomes:

    1. Two times
    2. Eight times
    3. Three times
    4. Four times
    Show answer

    Answer: D. Thrust = ½ρgH² × width, so it varies as H². Doubling H gives four times the thrust.

  4. 4. The average gauge pressure on a vertical wall retaining 4 m of water is (g = 10 m/s²):

    1. 10 000 Pa
    2. 20 000 Pa
    3. 40 000 Pa
    4. 80 000 Pa
    Show answer

    Answer: B. Average = ½ρgH = ½ × 1000 × 10 × 4 = 20 000 Pa. The bottom value is 40 000 Pa.

  5. 5. In the U-tube method of equating pressures, the atmospheric pressure at the open ends:

    1. Adds to the lighter column only
    2. Adds to the heavier column only
    3. Cancels from both sides
    4. Doubles the column heights
    Show answer

    Answer: C. Both arms are open to the same atmosphere, so the same P_atm acts at both free surfaces and cancels from the equation.

Privacy · Terms · Refunds · Delivery