- Foundation
- 15 practice questions
Final self-assessment: properties of matter
Test yourself on the whole course: 15 questions with answers explained.
If something looks wrong, please tell us.
Attempt all 15 questions before you check any answer. They are a little harder than the checks after each lesson. Which lesson each question comes from - questions 1-3: lesson 1, "States of matter and intermolecular forces"; questions 4-6: lesson 2, "Density and relative density"; questions 7-9: lesson 3, "Elasticity, stress and strain"; questions 10-12: lesson 4, "Surface tension and viscosity"; questions 13-15: lesson 5, "Properties of matter: mixed practice". Revisit that lesson for any question you missed.
Final self-assessment
-
1. Two sealed syringes, one full of water and one full of air, are pushed with the same force. What happens?
- The air is compressed noticeably but the water hardly at all, because gas particles are far apart
- The water is compressed more, because its particles can slide past each other
- Both are compressed by the same amount
- Neither is compressed, because both have a fixed volume
Show answer
Answer: A. Gases have particles far apart with much empty space, so they compress easily. A liquid's particles are already close together, so its compressibility is very small.
-
2. A drop of water spreads on clean glass, while a drop of mercury stays as a ball. What explains this?
- For water, cohesion is stronger than adhesion; for mercury, adhesion is stronger
- Both are caused only by viscosity
- Both are caused only by gravity
- For water, adhesion to glass is stronger than cohesion; for mercury, cohesion is stronger than adhesion
Show answer
Answer: D. Water's attraction to glass (adhesion) beats its own cohesion, so it wets and spreads. Mercury's cohesion is stronger than its adhesion to glass, so it pulls into a ball.
-
3. Which of these is an example of sublimation?
- Ice melting in a glass
- Naphthalene balls slowly disappearing in a cupboard
- Dew forming on grass
- Wet clothes drying in the sun
Show answer
Answer: B. Naphthalene changes directly from solid to gas: sublimation. Melting is solid to liquid, dew is condensation, and drying clothes is evaporation.
-
4. A block has a mass of 1.8 kg and a volume of 2000 cm³. What is its density, and does it float in water?
- 900 kg/m³; it floats
- 900 kg/m³; it sinks
- 0.9 kg/m³; it floats
- 9000 kg/m³; it sinks
Show answer
Answer: A. 2000 cm³ = 2000 ÷ 10⁶ = 2 × 10⁻³ m³. Density = 1.8 ÷ 0.002 = 900 kg/m³. Relative density = 0.9, less than 1, so it floats.
-
5. A liquid has a relative density of 0.8. What is the mass of 2000 cm³ of it?
- 2.5 kg
- 16 kg
- 1.6 kg
- 0.4 kg
Show answer
Answer: C. Density = 0.8 × 1 g/cm³ = 0.8 g/cm³. Mass = 0.8 × 2000 = 1600 g = 1.6 kg.
-
6. A body of mass 300 g has a density of 3 g/cm³. What is its volume in m³?
- 10⁻² m³
- 10⁻⁴ m³
- 10⁻⁶ m³
- 100 m³
Show answer
Answer: B. V = m ÷ ρ = 300 ÷ 3 = 100 cm³. Since 1 m³ = 10⁶ cm³, 100 cm³ = 100 ÷ 10⁶ = 10⁻⁴ m³.
-
7. A wire 2 m long with cross-sectional area 4 × 10⁻⁶ m² stretches by 2 mm under a force of 200 N. What is its Young's modulus?
- 5 × 10⁷ Pa
- 5 × 10⁴ Pa
- 2 × 10¹¹ Pa
- 5 × 10¹⁰ Pa
Show answer
Answer: D. Stress = 200 ÷ (4 × 10⁻⁶) = 5 × 10⁷ Pa. Strain = 0.002 ÷ 2 = 10⁻³. Y = stress ÷ strain = 5 × 10⁷ ÷ 10⁻³ = 5 × 10¹⁰ Pa.
-
8. Which of these quantities has no unit?
- Stress
- Young's modulus
- Spring constant
- Strain
Show answer
Answer: D. Strain is a change in length divided by the original length, so the units cancel. Stress and Young's modulus are in N/m² (Pa), and the spring constant is in N/m.
-
9. A spring has a spring constant of 200 N/m. By how much does it stretch under a force of 10 N?
- 20 cm
- 5 cm
- 0.5 cm
- 50 cm
Show answer
Answer: B. x = F ÷ k = 10 ÷ 200 = 0.05 m = 5 cm.
-
10. Why does adding detergent to water help in washing clothes?
- It raises the surface tension of water, so the water holds dirt more tightly
- It raises the viscosity of water, so the water stays on the fabric longer
- It lowers the surface tension of water, so the water spreads and wets the fabric better
- It increases the density of water, so the water sinks into the fabric
Show answer
Answer: C. Soaps and detergents lower the surface tension of water. Water then spreads more easily into the fabric and cleans it better.
-
11. A liquid is heated. What happens to its surface tension and its viscosity?
- Both decrease
- Both increase
- Surface tension decreases but viscosity increases
- Surface tension increases but viscosity decreases
Show answer
Answer: A. A rise in temperature lowers the surface tension of a liquid, and it also lowers the viscosity of a liquid (heated oil flows easily).
-
12. How does the viscosity of a gas change when the gas is heated?
- It decreases
- It stays the same
- It increases
- It becomes zero
Show answer
Answer: C. Unlike liquids, whose viscosity falls on heating, the viscosity of gases increases with temperature.
-
13. A 5 kg mass hangs from a wire 1.5 m long with cross-sectional area 1 × 10⁻⁶ m². The wire extends by 0.75 mm. Taking g = 10 m/s², what is the Young's modulus?
- 10¹⁰ Pa
- 5 × 10⁷ Pa
- 10⁸ Pa
- 10¹¹ Pa
Show answer
Answer: D. F = 5 × 10 = 50 N. Stress = 50 ÷ 10⁻⁶ = 5 × 10⁷ Pa. Strain = 0.00075 ÷ 1.5 = 5 × 10⁻⁴. Y = 5 × 10⁷ ÷ 5 × 10⁻⁴ = 10¹¹ Pa.
-
14. 200 cm³ of a liquid of density 0.8 g/cm³ is mixed with 300 cm³ of water (density 1 g/cm³). Assuming the volumes add, what is the density of the mixture?
- 0.92 g/cm³
- 0.90 g/cm³
- 0.88 g/cm³
- 1.8 g/cm³
Show answer
Answer: A. Total mass = 200 × 0.8 + 300 × 1 = 160 + 300 = 460 g. Total volume = 500 cm³. Density = 460 ÷ 500 = 0.92 g/cm³. The simple average of the densities (0.90) is wrong because the volumes differ.
-
15. A 3 kg block hung from a spring stretches it by 6 cm. Taking g = 10 m/s², what is the spring constant?
- 50 N/m
- 500 N/m
- 5 N/m
- 1.8 N/m
Show answer
Answer: B. F = mg = 3 × 10 = 30 N. x = 6 cm = 0.06 m. k = F ÷ x = 30 ÷ 0.06 = 500 N/m.
Sign in to keep track of the lessons you finish.