• Foundation
  • About 13 min
  • 5 practice questions

Wetting, the meniscus and capillary rise

Explain why some liquids wet a surface and others do not, read the meniscus, and compare capillary rise in tubes of different widths.

If something looks wrong, please tell us.

Pour water on a clean glass plate and it spreads out. Pour mercury and it forms beads. A towel soaks up water, but a raincoat does not. These everyday facts all come from the balance between two kinds of forces. In this lesson we meet that balance and use it to understand how liquids climb up narrow tubes.

Cohesion and adhesion

Cohesion is the attraction between molecules of the same substance. Adhesion is the attraction between molecules of different substances, such as water and glass. When a liquid touches a solid, the two forces compete. If adhesion is stronger than cohesion, the liquid is pulled towards the solid and spreads: we say the liquid wets the surface. If cohesion is stronger, the liquid pulls itself into beads and does not wet the surface.

Wetting and non-wetting
Liquid and solidWhich force winsWhat you see
Water on clean glassAdhesionWater spreads and wets the glass
Mercury on glassCohesionMercury forms round beads
Water on a waxed or oily surfaceCohesionWater forms drops and rolls off
Water on cotton clothAdhesionCloth soaks up water

The meniscus and the angle of contact

Where a liquid meets the wall of a glass tube, its surface curves. This curved surface is called the meniscus. For a wetting liquid like water the edge climbs up the wall, so the meniscus is concave (hollow, curving upwards at the edges). For a non-wetting liquid like mercury, the edges are pushed down, so the meniscus is convex (bulging upwards in the middle). The angle between the liquid surface and the wall, measured inside the liquid, is the angle of contact. It is less than 90° for liquids that wet the wall and more than 90° for liquids that do not.

A practical point follows. In a measuring cylinder with water, read the volume at the lowest point of the concave meniscus, with your eye at the same level. For mercury, the top of the convex meniscus is read.

Capillary rise

In a very narrow tube, called a capillary, a wetting liquid climbs above the level outside, and a non-wetting liquid is pushed below it. The narrower the tube, the larger the effect. For a given liquid and tube material, the height h is inversely proportional to the radius r, so h × r stays the same. (The full formula is h = 2T cosθ ÷ (rρg).) The length of the tube does not matter as long as it is longer than the height reached.

Worked examples

Example 1. Water rises 3 cm in a capillary tube. A second tube of the same glass has one-third of the radius. Since h is inversely proportional to r, the water rises 3 × 3 = 9 cm.

Example 2. Tube A has a radius of 1 mm and tube B a radius of 0.5 mm. Water rises 1.4 cm in A. Tube B is half as wide, so the rise doubles to 2.8 cm. Check: h × r = 1.4 × 1 = 1.4 and 2.8 × 0.5 = 1.4. The product is constant.

Example 3. Why does a candle burn steadily? The wax melts and the liquid wax climbs up the thin gaps in the wick by capillary action, bringing fuel to the flame.

Example 4. Why does a raincoat keep us dry? The cloth is treated with wax or a similar coating. Water does not wet it, so drops stay as beads on the outside and cannot soak through the tiny gaps between the fibres.

Adhesion greater than cohesion: the liquid wets and rises in a capillary. Cohesion greater: it does not wet and is pushed down. Rise is inversely proportional to the radius.

— Rule to remember

Key takeaways

  • Wetting depends on adhesion versus cohesion.
  • A wetting liquid has a concave meniscus and an angle of contact below 90°.
  • Narrower capillary: greater rise; h × r is constant for a given liquid and tube material.
  • Wicks, blotting paper, soil and plant stems all use capillary action.

Check your understanding

  1. 1. Water spreads on clean glass because:

    1. Cohesion is stronger than adhesion
    2. Adhesion is stronger than cohesion
    3. Glass is heavier than water
    4. Water has no cohesion
    Show answer

    Answer: B. When the pull between water and glass (adhesion) is greater than the pull between water molecules (cohesion), the water spreads and wets the glass.

  2. 2. Mercury in a glass tube has a meniscus that is:

    1. Convex
    2. Concave
    3. Flat
    4. Wavy
    Show answer

    Answer: A. Mercury does not wet glass, so its edges are pushed down and the middle bulges upwards. The meniscus is convex.

  3. 3. Water rises 2 cm in a capillary tube. In a tube of the same glass but half the radius, it will rise:

    1. 1 cm
    2. 2 cm
    3. 4 cm
    4. 8 cm
    Show answer

    Answer: C. Rise is inversely proportional to the radius. Half the radius gives double the rise: 4 cm.

  4. 4. The angle of contact between a wetting liquid and a solid is:

    1. Exactly 90°
    2. Greater than 90°
    3. Always 180°
    4. Less than 90°
    Show answer

    Answer: D. A liquid that wets a solid has its edges climbing the wall, which gives an angle of contact less than 90°.

  5. 5. Which of the following is NOT an example of capillary action?

    1. Oil rising in a lamp wick
    2. A towel soaking up spilt water
    3. Water moving up through soil
    4. A stone sinking in water
    Show answer

    Answer: D. A stone sinks because its density is greater than the water's. The other three are liquids moving through narrow gaps because of adhesion.

Privacy · Terms · Refunds · Delivery