• Foundation
  • About 14 min
  • 5 practice questions

Fluids in motion: streamline flow, continuity and terminal velocity

Describe steady and turbulent flow, use the equation of continuity, and explain why a falling drop or ball reaches a constant speed.

If something looks wrong, please tell us.

Water in a river, air past a car and honey from a spoon are all fluids in motion. Describing them exactly is hard, so physics starts with a simple picture: a steady, smooth flow. This lesson introduces that picture, one simple equation that follows from it, and the idea of terminal velocity.

Streamline and turbulent flow

In streamline (steady) flow, every particle passing a given point follows the same path and has the same speed as the particles before it. The paths are called streamlines and never cross. At low speeds, smooth water in a narrow channel flows this way. At high speeds the flow breaks into swirling eddies and becomes turbulent; the speed and direction at a point change from moment to moment, as in a fast mountain stream.

The equation of continuity

When a liquid flows steadily through a pipe, the volume that enters per second must equal the volume that leaves per second, because the liquid cannot be squashed or collect inside. The volume per second is Q = A × v (area times speed). So at any two places A₁v₁ = A₂v₂. Where the pipe is narrower, the liquid moves faster.

Viscosity and terminal velocity

Real fluids have internal friction, called viscosity. Thick liquids like honey are more viscous than water. The coefficient of viscosity is measured in pascal second (Pa s); 1 Pa s equals 10 poise. When a small ball falls through a liquid, three forces act: its weight down, the buoyant force up and a viscous drag up. The drag grows with speed. The ball speeds up until the three forces balance; after that the net force is zero and it falls at a constant speed, the terminal velocity. For a small sphere of radius r, the terminal velocity is v = 2r²(ρ − σ)g ÷ 9η, where ρ is the ball's density, σ the liquid's density and η the viscosity. So a bigger ball falls faster, in proportion to r².

Worked examples

Example 1: a hose. Water moves at 1 m/s in a hose where the area is 2 cm². At the nozzle the area is 0.5 cm². From A₁v₁ = A₂v₂, v₂ = 1 × 2 ÷ 0.5 = 4 m/s. The nozzle is four times narrower, so the water is four times faster.

Example 2: filling a tank. Water flows at 2 m/s through a pipe of cross-section 5 × 10⁻⁴ m². Q = Av = 5 × 10⁻⁴ × 2 = 10⁻³ m³/s = 1 litre per second. A 600-litre tank therefore fills in 600 ÷ 1 = 600 s = 10 minutes.

Example 3: terminal velocity. A glass-like ball of radius 2 mm and density 2500 kg/m³ falls in an oil of density 1000 kg/m³ and viscosity 0.5 Pa s (g = 10 m/s²). v = 2 × (0.002)² × (2500 − 1000) × 10 ÷ (9 × 0.5) = 2 × 4 × 10⁻⁶ × 1500 × 10 ÷ 4.5 = 0.12 ÷ 4.5 ≈ 0.027 m/s, about 2.7 cm/s. If the radius were doubled, the speed would be four times as great.

Example 4: temperature. Why does cold honey pour slowly while warm honey flows freely? Viscosity of a liquid decreases when it is heated, so the internal friction is smaller.

Example 5: pressure and speed. Blow over the top of a strip of paper hanging from your lips and it rises. Fast-moving air has lower pressure, and the higher pressure of the still air below pushes the paper up. This is a gentle form of Bernoulli's principle: where a fluid moves faster, its pressure is lower.

Continuity: A₁v₁ = A₂v₂ (narrower means faster). At terminal velocity weight = buoyancy + drag, so the net force is zero.

— Rule to remember

Key takeaways

  • Streamline flow is smooth and steady; turbulent flow is swirling.
  • Volume per second Q = A × v is the same all along a pipe.
  • Viscosity is internal friction; it drops when a liquid is heated.
  • Terminal velocity increases with the square of the ball's radius.

Check your understanding

  1. 1. Water flowing through a pipe enters a part that is half as wide in area. Its speed there becomes:

    1. Half as much
    2. The same
    3. Four times
    4. Twice as much
    Show answer

    Answer: D. A₁v₁ = A₂v₂. If the area halves, the speed doubles.

  2. 2. Water moves at 3 m/s in a pipe of area 2 × 10⁻³ m². The volume flowing per second is:

    1. 6 × 10⁻³ m³
    2. 6 × 10⁻³ m³/s
    3. 1.5 × 10³ m³/s
    4. 6 m³/s
    Show answer

    Answer: B. Q = Av = 2 × 10⁻³ × 3 = 6 × 10⁻³ m³/s. The unit must be volume per second.

  3. 3. A ball falling in a liquid at terminal velocity has a net force that is:

    1. Equal to its weight
    2. Upwards and increasing
    3. Downwards and increasing
    4. Zero
    Show answer

    Answer: D. At terminal velocity, weight is balanced by buoyancy plus drag, so the net force is zero and the speed stays constant.

  4. 4. Which flow is turbulent?

    1. Slow flow of oil in a narrow tube
    2. A fast, swirling mountain stream
    3. Honey falling in a smooth thread
    4. Water drops falling from a slow tap
    Show answer

    Answer: B. Turbulent flow has eddies and unpredictable changes of speed and direction, as in a fast stream. The other examples are smooth.

  5. 5. The coefficient of viscosity of a liquid when heated:

    1. Decreases
    2. Increases
    3. Stays the same
    4. Becomes zero
    Show answer

    Answer: A. For liquids viscosity falls with temperature, which is why warm oil or honey flows more easily.

Privacy · Terms · Refunds · Delivery