• Practice
  • About 25 min
  • 15 practice questions

Final self-assessment: Electricity

Test yourself on the whole course: 15 questions with answers explained.

If something looks wrong, please tell us.

Attempt all 15 questions before checking. Write the formula, put in the numbers with units, then calculate. Charge of an electron = 1.6 × 10⁻¹⁹ C.

Final self-assessment

  1. 1. A current of 0.25 A flows through a bulb for 2 minutes. The charge that passes is

    1. 0.5 C
    2. 30 C
    3. 480 C
    4. 0.125 C
    Show answer

    Answer: B. Q = It = 0.25 × 120 s = 30 C. Using 2 instead of 120 seconds gives the wrong 0.5 C.

  2. 2. A current of 0.8 A flows in a wire. How many electrons pass a point each second?

    1. 1.28 × 10⁻¹⁹
    2. 8 × 10¹⁸
    3. 1.6 × 10¹⁹
    4. 5 × 10¹⁸
    Show answer

    Answer: D. Charge per second = 0.8 C. Number = 0.8 ÷ 1.6 × 10⁻¹⁹ = 0.5 × 10¹⁹ = 5 × 10¹⁸.

  3. 3. Point A is at 15 V and point B at 5 V. The work done in moving 2 C of charge from B to A is

    1. 20 J
    2. 40 J
    3. 10 J
    4. 5 J
    Show answer

    Answer: A. Potential difference = 15 − 5 = 10 V. W = QV = 2 × 10 = 20 J.

  4. 4. A wire of resistance 12 Ω is cut into 4 equal pieces. The resistance of each piece is

    1. 48 Ω
    2. 12 Ω
    3. 3 Ω
    4. 0.75 Ω
    Show answer

    Answer: C. R ∝ L. Each piece is a quarter of the length, so its resistance is 12/4 = 3 Ω.

  5. 5. A wire 4 m long with cross-section 2 × 10⁻⁷ m² has a resistance of 5 Ω. Its resistivity is

    1. 2.5 × 10⁻⁷ Ω m
    2. 4 × 10⁻⁷ Ω m
    3. 1 × 10⁻⁷ Ω m
    4. 1 × 10⁸ Ω m
    Show answer

    Answer: A. ρ = RA/L = (5 × 2 × 10⁻⁷) ÷ 4 = 10 × 10⁻⁷ ÷ 4 = 2.5 × 10⁻⁷ Ω m.

  6. 6. A material has resistivity 2 × 10⁻⁸ Ω m. Its conductivity is

    1. 2 × 10⁸ mho m⁻¹
    2. 0.5 × 10⁻⁸ mho m⁻¹
    3. 2 × 10⁻⁸ mho m⁻¹
    4. 5 × 10⁷ mho m⁻¹
    Show answer

    Answer: D. σ = 1/ρ = 1 ÷ (2 × 10⁻⁸) = 0.5 × 10⁸ = 5 × 10⁷ mho m⁻¹.

  7. 7. Three 6 Ω resistors are connected first in series and then in parallel. The ratio of series resistance to parallel resistance is

    1. 3 : 1
    2. 9 : 1
    3. 1 : 9
    4. 6 : 1
    Show answer

    Answer: B. Series: 3 × 6 = 18 Ω. Parallel: 6/3 = 2 Ω. Ratio 18 : 2 = 9 : 1 (for n equal resistors the ratio is n²).

  8. 8. Two resistors give 10 Ω in series and 2.4 Ω in parallel. Their values are

    1. 5 Ω and 5 Ω
    2. 2 Ω and 8 Ω
    3. 4 Ω and 6 Ω
    4. 3 Ω and 7 Ω
    Show answer

    Answer: C. R₁ + R₂ = 10 and R₁R₂/(R₁ + R₂) = 2.4, so R₁R₂ = 24. The numbers adding to 10 and multiplying to 24 are 4 and 6. Check: 1/4 + 1/6 = 5/12, and 12/5 = 2.4 Ω.

  9. 9. Two 6 Ω resistors in parallel are joined in series with a 2 Ω resistor across a 10 V battery. The current from the battery is

    1. 2 A
    2. 0.71 A
    3. 1.25 A
    4. 5 A
    Show answer

    Answer: A. 6 ∥ 6 = 3 Ω. Total = 3 + 2 = 5 Ω. I = 10 ÷ 5 = 2 A.

  10. 10. A heater is rated 1000 W, 250 V. Its resistance is

    1. 4 Ω
    2. 0.25 Ω
    3. 250 000 Ω
    4. 62.5 Ω
    Show answer

    Answer: D. R = V²/P = 250² ÷ 1000 = 62 500 ÷ 1000 = 62.5 Ω. (I = 4 A, and 250/4 = 62.5 Ω too.)

  11. 11. A 4 Ω resistor carries 5 A for 1 minute. The heat produced is

    1. 1200 J
    2. 6000 J
    3. 100 J
    4. 20 J
    Show answer

    Answer: B. H = I²Rt = 25 × 4 × 60 = 6000 J.

  12. 12. Tungsten is used for bulb filaments, but not for fuse wires, because it

    1. has a low melting point
    2. is a poor conductor
    3. has a very high melting point
    4. oxidises quickly in air
    Show answer

    Answer: C. A filament must glow white hot without melting, so it needs a very high melting point. A fuse needs the opposite: a low melting point so it melts on excess current.

  13. 13. Three 60 W bulbs are used for 4 hours a day for 30 days. The energy used is

    1. 21.6 kWh
    2. 7.2 kWh
    3. 720 kWh
    4. 2.16 kWh
    Show answer

    Answer: A. Energy = 3 × 60 W × 4 h × 30 = 21 600 Wh = 21.6 kWh.

  14. 14. What does an MCB do?

    1. It records the energy used
    2. It earths the metal body of an appliance
    3. It raises the supply voltage
    4. It switches off automatically when excess current flows, and can also be switched by hand
    Show answer

    Answer: D. An MCB is a switching device. Excess current makes an electromagnet pull its spring-loaded switch, breaking the circuit; it can also be operated manually.

  15. 15. Which is a merit of an LED bulb over a filament bulb?

    1. It needs mercury to work
    2. It uses less power and wastes much less energy as heat
    3. It works only on direct current from a battery
    4. It gives only white light
    Show answer

    Answer: B. An LED has no filament, so it stays cool and turns more of its energy into light. It needs no mercury and comes in many colours.

Questions 1-3: lesson 1 (current, potential difference). Questions 4-6: lesson 2 (resistance, resistivity, conductivity). Questions 7-9: lesson 3 (series and parallel). Questions 10-12: lesson 4 (heating effect, power). Questions 13-15: lesson 5 (energy, domestic circuits, LEDs).

Sign in to keep track of the lessons you finish.

Privacy · Terms · Refunds · Delivery