- Practice
- About 25 min
- 5 practice questions
Real gases: compressibility factor and the van der Waals equation
Explain why real gases deviate from PV = nRT, use the compressibility factor Z and the Boyle temperature to describe the deviations, and derive and use the van der Waals equation with its pressure and volume corrections.
If something looks wrong, please tell us.
By the end of this lesson you can
- Name the two assumptions of the ideal gas model that real gases break.
- Calculate the compressibility factor Z = PV/nRT and say what Z < 1 and Z > 1 mean.
- Explain the Boyle temperature and the conditions under which real gases behave almost ideally.
- Derive the pressure and volume corrections and use the van der Waals equation (P + an²/V²)(V − nb) = nRT.
The ideal gas equation comes from the kinetic theory of gases, which assumes that (i) the molecules themselves take up negligible volume and (ii) there are no forces of attraction between them. A gas that obeyed these assumptions at all temperatures and pressures would be an ideal gas. But gases can be liquefied, which proves that their molecules do attract one another, and liquids are hard to compress, which proves that molecules do take up space. So every real gas deviates from PV = nRT, at least under some conditions.
Compressibility factor Z
The deviation is measured by the compressibility factor, Z = PV/nRT. Because the ideal molar volume is V(ideal) = RT/P, Z can also be written as Z = V(real)/V(ideal) for one mole.
- Z = 1: ideal behaviour; a graph of Z against P is a horizontal line.
- Z < 1 (negative deviation): the gas is more compressible than an ideal gas, because attractions pull the molecules together (CH₄ and CO₂ at moderate pressures).
- Z > 1 (positive deviation): the gas is harder to compress, because the molecules' own volume matters more (H₂ and He at room temperature, and every gas at very high pressure).
At low pressure the container is huge compared with the molecules and the molecules are far apart, so their volume and attractions are negligible. At high temperature the molecules move so fast that attractions hardly matter. So real gases behave most nearly ideally at low pressure and high temperature. As pressure rises or temperature falls, the deviations grow.
The temperature at which a real gas obeys the ideal gas law over a large range of pressure is the Boyle temperature (Boyle point); it differs from gas to gas. Above it, Z > 1 at all pressures. Below it, Z first falls below 1 as pressure increases, passes through a minimum and then rises above 1.
Worked example 1: finding Z
One mole of a gas at 273 K and 100 atm is found to occupy 0.200 dm³. Find Z and say which effect dominates. Working: Z = PV/nRT = (100 × 0.200) ÷ (1 × 0.0821 × 273) = 20.0 ÷ 22.41 = 0.892. Z < 1, so the gas takes up less volume than an ideal gas would (an ideal gas would occupy 22.41/100 = 0.224 dm³): attractive forces dominate.
The van der Waals equation
J. D. van der Waals made the first mathematical treatment of real gases by adding two corrections to PV = nRT.
Pressure correction
A molecule in the middle of the gas is pulled equally in all directions, but a molecule about to hit the wall is pulled back inwards by its neighbours. It hits the wall less hard, so the measured pressure P is lower than the ideal pressure. The inward pull depends on how many molecules are pulling and how many are being pulled, so it is proportional to the square of the density, that is to (n/V)². Writing this lost pressure as p′ = an²/V², the ideal pressure is P(ideal) = P + an²/V², where a depends on the strength of attraction in that gas.
Volume correction
Molecules are not points, so the volume free for them to move in is less than the container's volume V. Treat each molecule as a hard sphere of radius r. Two molecules cannot come closer than 2r between centres, so a pair shuts out a sphere of radius 2r: (4/3)π(2r)³ = 8 × (4/3)πr³ = 8V(m), where V(m) is the volume of one molecule. Per molecule this is 4V(m). For n moles the excluded volume is nb, with b = 4 × (Avogadro number) × V(m). So the free volume is V(ideal) = V − nb.
Van der Waals equation: (P + an²/V²)(V − nb) = nRT. For 1 mole: (P + a/V²)(V − b) = RT.
The two van der Waals corrections
-
Pressure correction (a)
- Cause: attraction between molecules
- Measured P is lower than ideal
- Add an²/V² to P
- Larger a means stronger attraction, easier to liquefy
- Units of a: dm⁶ atm mol⁻² (atm L² mol⁻²)
-
Volume correction (b)
- Cause: molecules have their own volume
- Free volume is less than V
- Subtract nb from V
- b is four times the actual volume of a mole of molecules
- Units of b: dm³ mol⁻¹ (L mol⁻¹)
Worked example 2: ideal and van der Waals pressures
One mole of CO₂ is held in 1.00 dm³ at 300 K. Take a = 3.59 dm⁶ atm mol⁻² and b = 0.0427 dm³ mol⁻¹ (typical values for CO₂) and R = 0.0821 dm³ atm mol⁻¹ K⁻¹. Working: ideal: P = RT/V = 0.0821 × 300 ÷ 1.00 = 24.6 atm. Van der Waals: P = RT/(V − b) − a/V² = 24.63 ÷ (1.00 − 0.0427) − 3.59 ÷ 1.00² = 24.63 ÷ 0.9573 − 3.59 = 25.73 − 3.59 = 22.1 atm. The volume correction alone would raise the pressure, but the attraction term lowers it more, so the real pressure is about 10% below the ideal value.
Key takeaways: real gases deviate because molecules attract and occupy space. Z = PV/nRT measures the deviation (Z < 1 attraction wins, Z > 1 size wins); gases are nearly ideal at low P and high T. Van der Waals: add an²/V² to the pressure and subtract nb from the volume.
Check your understanding
-
1. Under which conditions does a real gas behave most like an ideal gas?
- High pressure and low temperature
- Low pressure and low temperature
- Low pressure and high temperature
- High pressure and high temperature
Show answer
Answer: C. At low pressure the molecules are far apart, so their own volume and attractions are negligible; at high temperature their fast motion overcomes attractions. Both conditions make the ideal assumptions nearly true.
-
2. The compressibility factor of CO₂ at 400 K and 71.0 bar is 0.8697. What is its molar volume? (R = 0.08314 dm³ bar K⁻¹ mol⁻¹)
- 0.468 dm³
- 0.538 dm³
- 0.407 dm³
- 2.24 dm³
Show answer
Answer: C. V(ideal) = RT/P = 0.08314 × 400 ÷ 71.0 = 33.256 ÷ 71.0 = 0.4684 dm³. V(real) = Z × V(ideal) = 0.8697 × 0.4684 = 0.407 dm³. 0.468 dm³ is the ideal volume, before applying Z.
-
3. Why is the measured pressure of a real gas lower than the pressure an ideal gas would exert?
- Real gas molecules move more slowly at the same temperature.
- Molecules near the wall are pulled back by attractions from the molecules behind them.
- Real gas molecules have zero volume.
- Real gas molecules collide less often with each other.
Show answer
Answer: B. A molecule about to strike the wall feels a net inward pull from its neighbours, so it hits the wall with less force. That is why van der Waals adds an²/V² to the measured pressure to get the ideal pressure.
-
4. In the van der Waals equation, the constant b is
- equal to the actual volume of one mole of molecules
- a measure of the attraction between molecules
- the same for all gases
- about four times the actual volume of one mole of molecules
Show answer
Answer: D. A pair of spheres of radius r excludes a sphere of radius 2r, which is 8 times the volume of one molecule, or 4 times per molecule. So b = 4 × (Avogadro number) × volume of one molecule. Attraction is measured by a.
-
5. Assertion (A): At high pressures Z is greater than 1 for all gases. Reason (R): At high pressures the volume of the molecules themselves becomes significant compared with the volume of the container.
- Both A and R are true, and R is the correct explanation of A.
- Both A and R are true, but R is not the correct explanation of A.
- A is true, but R is false.
- A is false, but R is true.
Show answer
Answer: A. At very high pressure the gas is squeezed so much that the molecules' own volume is a large part of the total. The gas resists further compression, so V(real) > V(ideal) and Z > 1. R is the reason for A.
Sign in to keep track of the lessons you finish.