- Practice
- About 30 min
- 15 practice questions
Final self-assessment: Current Electricity
Test yourself on the whole course: 15 questions with answers explained.
If something looks wrong, please tell us.
Attempt all 15 questions first, writing down your working, then check the answers and explanations. Take e = 1.6 × 10⁻¹⁹ C.
Final self-assessment
-
1. A wire of cross-section 2.0 mm² carries 3.2 A. The free-electron density is 1.0 × 10²⁹ m⁻³. The drift speed of the electrons is:
- 1.0 × 10⁻⁴ m s⁻¹
- 2.0 × 10⁻⁴ m s⁻¹
- 1.0 × 10⁻² m s⁻¹
- 1.6 × 10⁻⁴ m s⁻¹
Show answer
Answer: A. v_d = I/(neA) = 3.2/(1.0 × 10²⁹ × 1.6 × 10⁻¹⁹ × 2.0 × 10⁻⁶) = 3.2/(3.2 × 10⁴) = 1.0 × 10⁻⁴ m s⁻¹.
-
2. In the relation J = σE, the conductivity σ of a metal is:
- m/(ne²τ)
- ne²τ/m
- eτ/m
- neτ/m
Show answer
Answer: B. v_d = eEτ/m and J = nev_d give J = (ne²τ/m)E, so σ = ne²τ/m. Its reciprocal m/(ne²τ) is the resistivity, and eτ/m is the mobility.
-
3. Which statement is correct?
- Current density is a scalar and current is a vector
- Both current and current density are vectors
- Current is a scalar and current density is a vector
- Both are scalars
Show answer
Answer: C. Current density J⃗ = nev⃗_d has a direction at each point. Current is I = J⃗·A⃗, a scalar product, so it is a scalar.
-
4. A wire of resistance R is cut into four equal pieces, which are then connected in parallel. The resistance of the combination is:
- R/4
- 4R
- R
- R/16
Show answer
Answer: D. Each piece has R/4. Four equal resistances R/4 in parallel give (R/4)/4 = R/16.
-
5. A carbon resistor of (330 ± 33) Ω is marked with which colour sequence?
- Orange, orange, brown, silver
- Orange, orange, red, silver
- Orange, orange, brown, gold
- Red, red, brown, silver
Show answer
Answer: A. 330 Ω = 33 × 10¹: orange (3), orange (3), brown (multiplier 10¹). The tolerance 33/330 = 10% is silver. Orange, orange, red would be 3.3 kΩ, and gold would mean 5%.
-
6. The resistance of a coil is 40 Ω at 20 °C and 44 Ω at 45 °C. Its temperature coefficient of resistance is:
- 0.1 (°C)⁻¹
- 4 × 10⁻³ (°C)⁻¹
- 2.2 × 10⁻³ (°C)⁻¹
- 1.6 × 10⁻² (°C)⁻¹
Show answer
Answer: B. α = ΔR/(R₀ΔT) = (44 − 40)/(40 × 25) = 4/1000 = 4 × 10⁻³ (°C)⁻¹.
-
7. One third of the length of a heater coil is cut off and the rest is used on the same supply voltage. The new power compared with the old is:
- the same
- 2/3 times
- 9/4 times
- 3/2 times
Show answer
Answer: D. R ∝ length, so the new resistance is (2/3)R. With V fixed, P = V²/R, so P_new/P_old = R/((2/3)R) = 3/2. A shorter coil draws more current and gives more power.
-
8. Six cells, each of emf 1.5 V and internal resistance 0.5 Ω, are in series with an external 6 Ω resistor. The current is:
- 1.0 A
- 1.5 A
- 0.25 A
- 9 A
Show answer
Answer: A. Total emf = 6 × 1.5 = 9 V; total resistance = 6 × 0.5 + 6 = 9 Ω; I = 9/9 = 1.0 A.
-
9. A cell of emf 12 V delivers 2.0 A to an external resistor, and its terminal voltage is 11 V. The power wasted inside the cell is:
- 24 W
- 22 W
- 4 W
- 2 W
Show answer
Answer: D. Ir = ε − V = 1 V, so r = 0.5 Ω. Power lost inside = I²r = 4 × 0.5 = 2 W (equivalently Iε − IV = 24 − 22 = 2 W).
-
10. In a closed loop, going through a cell from its positive terminal to its negative terminal, the emf term in Kirchhoff's voltage rule is taken as:
- +ε
- −ε
- zero
- +IR
Show answer
Answer: B. By the sign rule, going from − to + through a cell counts +ε, and going from + to − counts −ε.
-
11. In a Wheatstone network P = 300 Ω, Q = 200 Ω, S = 400 Ω, and the arm R is an unknown resistance x in series with 150 Ω. The bridge is balanced when x is:
- 600 Ω
- 450 Ω
- 150 Ω
- 267 Ω
Show answer
Answer: B. P/Q = R/S gives R = PS/Q = 300 × 400/200 = 600 Ω. Since R = x + 150, x = 450 Ω.
-
12. In a meter bridge with 20 Ω in the right gap, the balance point is at 60 cm from the left. If the two resistances are interchanged, the new balance point is at:
- 60 cm
- 50 cm
- 40 cm
- 30 cm
Show answer
Answer: C. First P = 20 × 60/40 = 30 Ω. After interchanging, 20/30 = l/(100 − l), so 2(100 − l) = 3l, 200 = 5l, l = 40 cm. Interchanging simply swaps l₁ and l₂.
-
13. A potentiometer is preferred to a voltmeter for measuring the emf of a cell because:
- it has a lower resistance
- it uses a stronger battery
- it can measure only small voltages
- at balance it draws no current from the cell
Show answer
Answer: D. A voltmeter draws some current, so it reads the terminal voltage ε − Ir, slightly less than ε. At the balance point a potentiometer draws no current, so it measures the emf itself.
-
14. A 1000 W immersion heater is used to heat 2.0 kg of water from 30 °C to 80 °C (s = 4200 J kg⁻¹ K⁻¹). Assuming no heat loss, the time taken is:
- 420 s
- 4.2 s
- 210 s
- 840 s
Show answer
Answer: A. Q = msΔT = 2.0 × 4200 × 50 = 4.2 × 10⁵ J. t = Q/P = 4.2 × 10⁵/1000 = 420 s (7 minutes).
-
15. When a current is passed through a copper-iron thermocouple with both junctions at the same temperature, one junction becomes hot and the other cold. This is the:
- Seebeck effect
- Thomson effect
- Peltier effect
- Joule effect
Show answer
Answer: C. Heat being evolved at one junction and absorbed at the other when a current passes is the Peltier effect, and reversing the current swaps the hot and cold junctions. Joule heating would warm both and does not reverse.
Questions 1-3: lesson 1 (current, drift velocity, current density). Questions 4-6: lesson 2 (Ohm's law, resistivity, combinations, colour code, temperature). Questions 7-9: lesson 3 (power, internal resistance, cells). Questions 10-12: lesson 4 (Kirchhoff's rules and bridges). Questions 13-15: lesson 5 (potentiometer, Joule heating, thermoelectric effects).
Sign in to keep track of the lessons you finish.