• Practice
  • About 26 min
  • 5 practice questions

Ohm's law, resistivity, combinations of resistors and temperature dependence

Derive V = IR and R = ρl/A, classify materials by resistivity, combine resistors in series and parallel, read the carbon resistor colour code and use ρ_T = ρ₀[1 + α(T − T₀)], including superconductivity.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Obtain the macroscopic form of Ohm's law, V = IR, from J = σE.
  • Distinguish ohmic and non-ohmic behaviour from V-I graphs.
  • Use R = ρl/A, including for a stretched wire.
  • Find equivalent resistance in series and parallel combinations.
  • Read the colour code of a carbon resistor.
  • Use the temperature coefficient of resistivity and describe superconductivity.

Every wire, filament and heating element opposes the flow of charge to some extent. This opposition, resistance, decides how much current a given voltage drives, how much heat is produced and how circuits are designed. Ohm's law is the starting point.

Ohm's law

Take a wire of length l and cross-section A with a potential difference V between its ends. Assuming a uniform field, E = V/l. From J = σE, I/A = σV/l, so V = I × l/(σA). The quantity R = l/(σA) is the resistance of the wire. So V = IR: at constant temperature, the potential difference across a conductor is directly proportional to the current through it. Resistance is R = V/I and its SI unit is the ohm (Ω), 1 Ω = 1 V A⁻¹. For an ohmic conductor, the graph of I against V is a straight line through the origin with slope 1/R. Devices such as a diode are non-ohmic: their I-V graph is curved and they have no single constant resistance.

Resistivity

With ρ = 1/σ, R = ρl/A: resistance is directly proportional to length and inversely proportional to cross-sectional area. The resistivity ρ depends only on the material (and its temperature), not on its shape. It equals the resistance of a conductor of unit length and unit cross-section, and its unit is the ohm metre (Ω m). Conductors have the lowest resistivity, insulators the highest, and semiconductors lie between.

Resistivity at 20 °C, according to the Tamil Nadu textbook (Table 2.1)
ClassMaterialρ (Ω m)
ConductorSilver1.6 × 10⁻⁸
ConductorCopper1.7 × 10⁻⁸
ConductorAluminium2.7 × 10⁻⁸
ConductorTungsten5.6 × 10⁻⁸
ConductorIron10 × 10⁻⁸
SemiconductorGermanium0.46
SemiconductorSilicon640
InsulatorPure water2.5 × 10⁵
InsulatorGlass10¹⁰ to 10¹⁴
InsulatorHard rubber10¹³ to 10¹⁶
InsulatorFused quartz10¹⁶

The textbook also notes that the human body's internal fluids have a low resistance while dry skin has a high resistance, which falls sharply when the skin is wet. That is why touching electrical connections with wet hands is so dangerous.

Worked example 1: resistance of a wire, and stretching it

(a) Find the resistance of a copper wire 2.0 m long with cross-section 0.50 mm². R = ρl/A = (1.7 × 10⁻⁸ × 2.0)/(0.50 × 10⁻⁶) = (3.4 × 10⁻⁸)/(5.0 × 10⁻⁷) = 0.068 Ω. (b) A wire of resistance 5 Ω is stretched uniformly to 3 times its length. Its volume Al stays the same, so the area becomes A/3. Then R′ = ρ(3l)/(A/3) = 9ρl/A = 9 × 5 = 45 Ω. Stretching n times multiplies the resistance by n².

Resistors in series and in parallel

Series. Resistors joined end to end carry the same current, because charge cannot pile up anywhere. The voltages add: V = IR₁ + IR₂ + IR₃ = IR_S, so R_S = R₁ + R₂ + R₃, larger than any single resistance. Parallel. Resistors connected across the same two points have the same voltage. The currents add (conservation of charge): I = V/R₁ + V/R₂ + V/R₃ = V/R_P, so 1/R_P = 1/R₁ + 1/R₂ + 1/R₃, smaller than any single resistance. Household appliances are connected in parallel, so each gets the full supply voltage and can be switched on or off independently.

Series and parallel resistors

  • Series
    • Same current through each
    • Voltages add
    • R_S = R₁ + R₂ + …
    • R_S larger than the largest
  • Parallel
    • Same voltage across each
    • Currents add
    • 1/R_P = 1/R₁ + 1/R₂ + …
    • R_P smaller than the smallest

Worked example 2: series and parallel

(a) Series: 3 Ω and 5 Ω across 16 V. R_S = 8 Ω, I = 16/8 = 2.0 A; V₁ = 2.0 × 3 = 6 V and V₂ = 2.0 × 5 = 10 V; 6 + 10 = 16 V. (b) Parallel: 3 Ω and 6 Ω across 12 V. 1/R_P = 1/3 + 1/6 = 1/2, so R_P = 2 Ω. I₁ = 12/3 = 4 A, I₂ = 12/6 = 2 A, total I = 6 A, which agrees with 12/2 = 6 A. The smaller resistance takes the larger share of the current.

Colour code for carbon resistors

A carbon resistor is a ceramic core coated with a thin layer of crystalline carbon; it is cheap, stable and compact. Its value is shown by coloured rings. Hold it with the rings to your left (a metallic band is never the first ring). The first two rings give the two significant digits, the third ring the decimal multiplier, and the fourth ring the tolerance: gold 5%, silver 10%, and no fourth ring 20%.

Resistor colour code
ColourDigitMultiplierTolerance
Black01-
Brown110¹-
Red210²-
Orange310³-
Yellow410⁴-
Green510⁵-
Blue610⁶-
Violet710⁷-
Grey810⁸-
White910⁹-
Gold-10⁻¹5%
Silver-10⁻²10%
No colour--20%

Worked example 3: reading resistors

(a) Brown, black, red, gold: digits 1 and 0, multiplier 10², so 10 × 10² = 1000 Ω = 1 kΩ, tolerance ±5%, i.e. between 950 Ω and 1050 Ω. (b) Yellow, violet, orange, silver: 47 × 10³ Ω = 47 kΩ ± 10%. (c) To mark 220 Ω with ±20%: 22 × 10¹, so red, red, brown, with no fourth ring.

Temperature dependence of resistivity

Over a wide range of temperature, the resistivity of a conductor rises linearly: ρ_T = ρ₀[1 + α(T − T₀)], where ρ₀ is the resistivity at a reference temperature T₀ (usually 20 °C) and α, the temperature coefficient of resistivity, is the fractional increase in resistivity per degree rise: α = Δρ/(ρ₀ΔT), unit (°C)⁻¹. For a given wire the same form holds for resistance: R_T = R₀[1 + α(T − T₀)] and α = ΔR/(R₀ΔT).

Why? From ρ = m/(ne²τ), resistivity is inversely proportional to the number density n and to the mean free time τ. In metals n hardly changes, but hotter ions vibrate more, collisions become more frequent and τ falls, so ρ rises: α is positive. Very close to absolute zero the graph stops being linear and ρ levels off at a small finite value. In semiconductors a rise in temperature frees many more electrons, so n rises; this outweighs the fall in τ, and ρ decreases: α is negative. A semiconductor with a negative temperature coefficient, used to sense temperature, is a thermistor. Alloys such as nichrome have a very small α, so their resistance hardly changes with temperature.

Temperature coefficients of resistivity, according to the Tamil Nadu textbook (selected rows of Table 2.3)
Materialα ((°C)⁻¹)
Copper3.9 × 10⁻³
Silver3.8 × 10⁻³
Tungsten4.5 × 10⁻³
Iron5.0 × 10⁻³
Nichrome0.4 × 10⁻³
Carbon−0.5 × 10⁻³
Germanium−48 × 10⁻³
Silicon−75 × 10⁻³

Superconductivity. Below a certain critical (transition) temperature T_c, some materials lose all resistance. Heike Kamerlingh Onnes first observed this in 1911, with mercury at 4.2 K. Because R = 0, a current set up in a superconducting loop keeps flowing without any potential difference.

Worked example 4: resistance at another temperature

(a) A coil has R = 5.0 Ω at 20 °C and α = 0.0040 (°C)⁻¹. At 70 °C, R = 5.0[1 + 0.0040 × (70 − 20)] = 5.0 × (1 + 0.20) = 6.0 Ω. (b) A wire measures 40 Ω at 20 °C and 48 Ω at 70 °C. α = ΔR/(R₀ΔT) = (48 − 40)/(40 × 50) = 8/2000 = 0.0040 (°C)⁻¹.

V = IR; R = ρl/A; series R_S = ΣR; parallel 1/R_P = Σ(1/R); R_T = R₀[1 + α(T − T₀)].

Key takeaways

  • Ohm's law V = IR holds for ohmic conductors at constant temperature; the I-V graph is a straight line of slope 1/R.
  • R = ρl/A; resistivity is a property of the material; stretching a wire n times multiplies R by n².
  • Series: same current, R adds. Parallel: same voltage, 1/R adds.
  • Colour code: two digits, multiplier, tolerance (gold 5%, silver 10%, none 20%).
  • Metals: α > 0. Semiconductors: α < 0. Superconductors: R = 0 below T_c.

Check your understanding

  1. 1. A wire of resistance 4 Ω is stretched uniformly until its length is doubled. Its new resistance is:

    1. 8 Ω
    2. 2 Ω
    3. 16 Ω
    4. 4 Ω
    Show answer

    Answer: C. The volume stays constant, so doubling l halves A. R = ρl/A becomes ρ(2l)/(A/2) = 4ρl/A, four times the original: 4 × 4 = 16 Ω.

  2. 2. Resistors of 2 Ω, 3 Ω and 6 Ω are connected in parallel. The equivalent resistance is:

    1. 11 Ω
    2. 1 Ω
    3. 6 Ω
    4. 0.5 Ω
    Show answer

    Answer: B. 1/R_P = 1/2 + 1/3 + 1/6 = 3/6 + 2/6 + 1/6 = 6/6 = 1, so R_P = 1 Ω, smaller than the smallest resistor.

  3. 3. A carbon resistor has rings green, blue, red, gold. Its value is:

    1. 5.6 kΩ ± 5%
    2. 56 Ω ± 10%
    3. 562 Ω ± 5%
    4. 56 kΩ ± 5%
    Show answer

    Answer: A. Green = 5, blue = 6, red = multiplier 10², gold = ±5%. R = 56 × 10² = 5600 Ω = 5.6 kΩ ± 5%.

  4. 4. When the temperature of a germanium sample rises, its resistivity:

    1. rises, because ions vibrate more
    2. stays the same
    3. becomes zero
    4. falls, because many more charge carriers are freed
    Show answer

    Answer: D. In a semiconductor the number density n of carriers rises sharply with temperature, which outweighs the fall in τ, so ρ = m/(ne²τ) falls. Germanium has a negative α.

  5. 5. A wire has resistance 10 Ω at 20 °C and α = 0.004 (°C)⁻¹. Its resistance at 120 °C is:

    1. 10.4 Ω
    2. 14 Ω
    3. 4.8 Ω
    4. 12 Ω
    Show answer

    Answer: B. R = R₀[1 + α(T − T₀)] = 10[1 + 0.004 × 100] = 10 × 1.4 = 14 Ω.

Privacy · Terms · Refunds · Delivery