- Practice
- About 30 min
- 15 practice questions
Final self-assessment: Magnetism and magnetic effects of electric current
Test yourself on the whole course: 15 questions with answers explained.
If something looks wrong, please tell us.
Attempt all 15 questions first, writing down your working, then check the answers and explanations. Use μ₀ = 4π × 10⁻⁷ T m A⁻¹, so μ₀/4π = 10⁻⁷ and μ₀/2π = 2 × 10⁻⁷.
Final self-assessment
-
1. At a certain place the horizontal and vertical components of the Earth's field are equal. The angle of dip there is:
- 0°
- 30°
- 90°
- 45°
Show answer
Answer: D. tan I = B_V/B_H = 1, so I = 45°.
-
2. A short bar magnet of moment 4.0 A m² is 0.20 m from a point on its axis. The field there is:
- 1.0 × 10⁻⁴ T
- 5.0 × 10⁻⁵ T
- 2.0 × 10⁻⁵ T
- 1.0 × 10⁻⁵ T
Show answer
Answer: A. B_axial = (μ₀/4π)(2p_m/r³) = 10⁻⁷ × 8.0/(0.20)³ = (8.0 × 10⁻⁷)/0.008 = 1.0 × 10⁻⁴ T.
-
3. A magnet of moment 3.0 A m² lies along a uniform field of 0.040 T. The work needed to turn it until it is perpendicular to the field is:
- 0.24 J
- 0.12 J
- zero
- 0.060 J
Show answer
Answer: B. U = −p_mB cos θ. W = U(90°) − U(0°) = 0 − (−p_mB) = p_mB = 3.0 × 0.040 = 0.12 J.
-
4. A material has relative permeability 0.99998. It is:
- ferromagnetic
- paramagnetic
- diamagnetic
- a superconductor above its transition temperature
Show answer
Answer: C. χ_m = μ_r − 1 = −2 × 10⁻⁵, small and negative, so the material is diamagnetic. Paramagnets have μ_r slightly above 1 and ferromagnets very large μ_r.
-
5. When a ferromagnetic material is heated above its Curie temperature, it:
- becomes diamagnetic
- becomes a superconductor
- keeps its domains aligned
- becomes paramagnetic
Show answer
Answer: D. Thermal agitation destroys the spontaneous alignment within domains above T_C, and the material becomes paramagnetic, with χ_m = C/(T − T_C).
-
6. Soft iron is preferred for the core of a transformer because it has:
- high retentivity and a large hysteresis loop
- high permeability and a thin hysteresis loop of small area
- high coercivity
- negative susceptibility
Show answer
Answer: B. A transformer core is taken round the hysteresis loop every cycle, so it needs a thin loop of small area (little energy lost) and high permeability (large induction). Soft iron has these properties.
-
7. A circular coil of 10 turns and radius 0.10 m carries 1.0 A. The field at its centre is about:
- 6.3 × 10⁻⁵ T
- 2.0 × 10⁻⁶ T
- 6.3 × 10⁻⁶ T
- 1.3 × 10⁻⁴ T
Show answer
Answer: A. B = μ₀NI/(2R) = (4π × 10⁻⁷ × 10 × 1.0)/(0.20) = 2π × 10⁻⁵ ≈ 6.3 × 10⁻⁵ T.
-
8. Two long parallel wires 10 cm apart each carry 5 A in the same direction. The magnetic field at the point midway between them is:
- 4 × 10⁻⁵ T
- 2 × 10⁻⁵ T
- zero
- 1 × 10⁻⁵ T
Show answer
Answer: C. Each wire gives μ₀I/(2πr) = 2 × 10⁻⁷ × 5/0.05 = 2 × 10⁻⁵ T at the midpoint, but by the right-hand rule the two fields there point in opposite directions, so they cancel.
-
9. In a tangent galvanometer a current I gives a deflection of 30°. The current needed for a deflection of 60° is:
- 2I
- √3 I
- I/3
- 3I
Show answer
Answer: D. I ∝ tan θ. I₂/I₁ = tan 60°/tan 30° = √3/(1/√3) = 3, so I₂ = 3I.
-
10. An electron and a proton enter the same uniform magnetic field perpendicular to it with the same speed. Which statement is correct?
- The electron moves in the smaller circle
- They move in circles of equal radius
- The proton moves in the smaller circle
- Neither is deflected
Show answer
Answer: A. r = mv/(qB). Both have charge of size e and the same v, so r ∝ m. The electron's mass is far smaller, so its circle is far smaller (and it curves the opposite way).
-
11. In a cyclotron, the time a particle takes to complete each semicircle inside a dee:
- increases as it speeds up
- decreases as it speeds up
- is the same on every turn
- depends on the radius of the dees
Show answer
Answer: C. The time for a semicircle is πm/(qB), which does not depend on the speed or radius. That is why a fixed oscillator frequency f = qB/(2πm) keeps in step with the particle.
-
12. A solenoid 50 cm long has 500 turns and carries 2.0 A. The field inside it is about:
- 1.3 × 10⁻³ T
- 2.5 × 10⁻³ T
- 5.0 × 10⁻³ T
- 2.5 × 10⁻⁵ T
Show answer
Answer: B. n = 500/0.50 = 1000 m⁻¹. B = μ₀nI = 4π × 10⁻⁷ × 1000 × 2.0 = 8π × 10⁻⁴ ≈ 2.5 × 10⁻³ T.
-
13. A coil of 50 turns and area 0.020 m² carries 2.0 A in a 0.50 T field, with its plane parallel to the field. The torque on it is:
- 0.50 N m
- zero
- 2.0 N m
- 1.0 N m
Show answer
Answer: D. With the plane parallel to B, the normal is at 90° to B, so τ = NIAB = 50 × 2.0 × 0.020 × 0.50 = 1.0 N m.
-
14. A galvanometer of resistance 20 Ω gives full-scale deflection for 2.0 mA. To use it as a voltmeter reading up to 5.0 V, the resistance to be connected is:
- 2480 Ω in series
- 2500 Ω in parallel
- 0.008 Ω in parallel
- 2520 Ω in series
Show answer
Answer: A. R_h = V/I_g − R_g = 5.0/0.0020 − 20 = 2500 − 20 = 2480 Ω, connected in series.
-
15. A charged particle moves exactly along the direction of a uniform magnetic field. Its path is:
- a circle
- a straight line, because the magnetic force on it is zero
- a helix
- a parabola
Show answer
Answer: B. F = qvB sin θ with θ = 0° gives F = 0. With no force, the particle keeps moving in a straight line along the field at constant speed.
Questions 1-3: lesson 1 (Earth's field and bar magnets). Questions 4-6: lesson 2 (magnetic materials and hysteresis). Questions 7-9: lesson 3 (Biot-Savart law, coils, tangent galvanometer). Questions 10-12: lesson 4 (Ampere's law, Lorentz force, cyclotron). Questions 13-15: lesson 5 (force and torque on conductors, galvanometer).
Sign in to keep track of the lessons you finish.