- Practice
- About 16 min
- 5 practice questions
Hydro, pumped storage and tidal: solving for any quantity
Rearrange P = ρgQhη to find flow or head, calculate the round-trip efficiency of pumped storage, and compare tidal sites using the square of the tidal range.
If something looks wrong, please tell us.
Water-based questions look harder than they are, because one formula covers most of them. If you can rearrange P = ρgQhη to find any missing quantity and keep units in watts, cubic metres per second and metres, you can solve nearly every hydro question in under a minute. This lesson also covers pumped storage, a favourite conceptual question, and the one formula for tidal energy worth knowing.
Rearranging the hydro formula
Power is directly proportional to flow, head and efficiency. That makes rearranging simple: to find the flow, divide the power by ρgh η; to find the head, divide by ρgQη. Keep power in watts. A useful shortcut with g = 10 and ρ = 1,000 is that ρg = 10,000, so P = 10,000 × Q × h × η watts, or P = 10 × Q × h × η kilowatts.
Hydro shortcut (g = 10): P in kW = 10 × Q × h × η. Flow Q = P ÷ (ρ g h η); head h = P ÷ (ρ g Q η).
Worked example 1: finding flow
A site has a head of 25 m and the plant is 80% efficient. What flow is needed for 1 MW? Q = 1,000,000 ÷ (1,000 × 10 × 25 × 0.8) = 1,000,000 ÷ 200,000 = 5 m³/s. Check with the shortcut: 10 × 5 × 25 × 0.8 = 1,000 kW. Correct.
Worked example 2: finding head
A plant must give 2 MW from a flow of 4 m³/s at 80% efficiency. h = 2,000,000 ÷ (1,000 × 10 × 4 × 0.8) = 2,000,000 ÷ 32,000 = 62.5 m. Note that halving the efficiency would need double the head, since power is proportional to each factor.
Pumped storage
A pumped storage scheme has two reservoirs at different heights. When there is spare electricity, for example from solar plants at midday, pumps lift water from the lower reservoir to the upper one. When electricity is needed, the water flows back down through turbines. It works like a giant rechargeable battery. Because pumping and generating both lose some energy, a pumped storage plant always consumes more electricity than it returns: it is a net user of energy, valued for shifting energy to when it is needed, not for producing it.
Round-trip efficiency = Energy returned ÷ Energy used for pumping. It is always below 100%.
Example: a scheme uses 100 MWh to pump water uphill and later generates 75 MWh. Round-trip efficiency = 75 ÷ 100 = 75%. If the pumps are 90% efficient and the turbines 85% efficient, the round trip is 0.90 × 0.85 = 0.765, or 76.5%: efficiencies in a chain multiply. A statement claiming pumped storage is a net source of electricity is false.
Tidal energy and the tidal range
For a tidal barrage, the energy available from one emptying of the basin depends on the basin area A and the tidal range h, the difference between high and low water. Trapped water of mass ρAh falls through an average height of h/2, so the energy is ½ρgAh². The key point for questions is the square: double the range and the energy becomes four times as large.
Example: site X has a tidal range of 2 m and site Y a range of 3 m, with equal basin areas. Energy ratio Y : X = 3² : 2² = 9 : 4 = 2.25. So site Y offers 2.25 times the energy per tide. That is why tidal barrages are only worthwhile where the range is large.
Run-of-river, storage and environmental trade-offs
Questions also test the trade-offs. Large storage dams can flood forests and villages, block fish migration and trap silt, but they can supply power on demand. Run-of-river plants disturb less but follow the river's seasonal flow. Tidal barrages change the mixing of fresh and salt water in an estuary. Do not choose an option that calls any of these impact-free.
Key takeaways
Hydro power is proportional to flow, head and efficiency, so rearranging is a single division; with g = 10, P in kW = 10Qhη. Pumped storage stores energy and always returns less than it uses; chain efficiencies multiply. Tidal barrage energy grows with the square of the tidal range.
Check your understanding
-
1. What flow is needed for 600 kW at a head of 15 m with 80% efficiency? (g = 10 m/s²)
- 4 m³/s
- 50 m³/s
- 7.2 m³/s
- 5 m³/s
Show answer
Answer: D. Q = 600,000 ÷ (1,000 × 10 × 15 × 0.8) = 600,000 ÷ 120,000 = 5 m³/s.
-
2. A pumped storage plant uses 200 MWh to pump and later generates 150 MWh. What is its round-trip efficiency?
- 133%
- 25%
- 50%
- 75%
Show answer
Answer: D. Round-trip efficiency = 150 ÷ 200 = 0.75 = 75%.
-
3. Which statement about pumped storage is correct?
- It produces more electricity than it consumes
- It works only with tidal water
- It needs no height difference between reservoirs
- It returns less electricity than it uses, but shifts energy to times of need
Show answer
Answer: D. Losses in pumping and generating mean the plant returns less than it uses. Its value lies in storing spare energy and releasing it later.
-
4. Two tidal sites have the same basin area. Site P has a tidal range of 4 m and site Q of 2 m. The energy per tide at P is how many times that at Q?
- 2
- 4
- 8
- 16
Show answer
Answer: B. Energy ∝ h². (4 ÷ 2)² = 2² = 4.
-
5. Pumps are 80% efficient and turbines are 90% efficient. What is the round-trip efficiency?
- 85%
- 170%
- 10%
- 72%
Show answer
Answer: D. Efficiencies in a chain multiply: 0.80 × 0.90 = 0.72 = 72%. Averaging them (85%) is a common error.
Sign in to keep track of the lessons you finish.