• Practice
  • About 16 min
  • 5 practice questions

Mixed problem set: capillary rise, merging drops, Stokes and Poiseuille by ratios

Use the ratio method on mixed questions covering capillary rise, falling drops, tube flow, merging and liquids compared.

If something looks wrong, please tell us.

In competitive exams, properties-of-matter questions are mixed. The same formulas appear in disguise, and speed matters. The ratio method is the quickest approach: write down how the answer depends on each quantity, then put in the given ratios and ignore everything that stays constant. All values here are illustrative.

Here is the method in three steps. First, write the formula and underline the quantities that change. Second, write each changed quantity as a ratio, new over old. Third, multiply the ratios, raising each to the power it has in the formula. Everything that stays the same, such as g, the liquid or the material, cancels. Questions that look long and frightening often reduce to one line this way.

The dependence table

How each quantity depends on size
QuantityDepends onPattern
Capillary rise h1/r (and T cosθ ÷ ρ)Narrower tube, higher rise
Excess pressure in drop or bubble1/RSmaller drop, higher pressure
Terminal velocity vₜr² (ρ − σ) ÷ ηLarger drop, much faster
Poiseuille flow QP r⁴ ÷ (η l)Radius has the biggest effect
Wire extension ΔLF L ÷ (r² Y)Thicker wire, smaller stretch
Merging n dropsR = n^(1/3) rVolume is conserved

Worked examples

Example 1: raindrops merge. Eight equal drops, each falling at terminal speed v, merge into one. R = 8^(1/3) r = 2r. Terminal velocity ∝ r², so the new speed = 4v.

Example 2: two tubes. Water rises 7 cm in a tube of radius 0.2 mm. In a tube of radius 0.4 mm the rise is half: 3.5 cm. If both are dipped together, the difference in the water levels inside the tubes is 7 − 3.5 = 3.5 cm.

Example 3: two liquids. A liquid X has T = 0.03 N/m, density 800 kg/m³ and zero contact angle. Water has T = 0.07 N/m and density 1000 kg/m³. In the same tube, h ∝ T ÷ ρ, so h_X ÷ h_water = (0.03 ÷ 800) ÷ (0.07 ÷ 1000) = 0.536. In a tube of radius 0.5 mm, water rises 2.8 cm, and X rises 0.536 × 2.8 = 1.5 cm.

Example 4: tube flow. A pipe has its radius halved and its length halved, and the pressure difference doubled. Q ∝ P r⁴ ÷ l. The ratio is 2 × (1/2)⁴ ÷ (1/2) = 2 × (1/16) × 2 = 1/4. The flow falls to one-quarter.

Example 5: the same ball in two liquids. A ball of density 2700 kg/m³ falls in liquid 1 (density 900 kg/m³, viscosity 0.2 Pa s) and liquid 2 (density 1200 kg/m³, viscosity 0.6 Pa s). vₜ ∝ (ρ − σ) ÷ η. Liquid 1: 1800 ÷ 0.2 = 9000. Liquid 2: 1500 ÷ 0.6 = 2500. The speeds are in the ratio 9000 : 2500 = 3.6 : 1.

Example 6: splitting a drop. A drop of radius R splits into 8 equal drops. Each new drop has radius R ÷ 2 (volume conserved), so its excess pressure 2T ÷ r is twice that of the original drop.

Write the dependence, plug the ratios, cancel the constants. Capillary h ∝ 1/r. Terminal speed ∝ r². Flow ∝ r⁴.

— Rule to remember

Traps

  • Using diameters in a formula that needs radius is fine for ratios, but not for absolute numbers.
  • Forgetting the buoyancy term (ρ − σ) in a terminal velocity question.
  • Mixing up the power: r² for terminal speed, r⁴ for Poiseuille flow, 1/r² for wire extension.

Key takeaways

  • Learn the dependence of each quantity.
  • Substitute ratios, not actual values, to save time.
  • Check which factors stay constant before cancelling.

Check your understanding

  1. 1. Water rises 6 cm in a capillary of radius 0.1 mm. In a capillary of radius 0.3 mm, the rise is:

    1. 18 cm
    2. 12 cm
    3. 2 cm
    4. 0.67 cm
    Show answer

    Answer: C. The rise is inversely proportional to the radius. Three times the radius gives one-third of the rise: 2 cm.

  2. 2. Twenty-seven equal drops merge into one. The terminal velocity of the new drop compared with a small one is:

    1. 3 times
    2. 6 times
    3. 9 times
    4. 27 times
    Show answer

    Answer: C. R = 27^(1/3) r = 3r. Terminal velocity ∝ r², so it becomes 9 times as great.

  3. 3. The radius of a tube is doubled and the length is doubled, with the same pressure difference. The flow becomes:

    1. 8 times
    2. 16 times
    3. 4 times
    4. 2 times
    Show answer

    Answer: A. Q ∝ r⁴ ÷ l = 16 ÷ 2 = 8, so the flow increases 8 times.

  4. 4. Two wires of the same material and length carry the same load. Their radii are in the ratio 1 : 3. Their extensions are in the ratio:

    1. 1 : 3
    2. 3 : 1
    3. 9 : 1
    4. 1 : 9
    Show answer

    Answer: C. ΔL ∝ 1 ÷ r², so the thinner wire stretches 9 times as much: 9 : 1.

  5. 5. A drop of radius R has an excess pressure ΔP. A drop of radius R ÷ 2 of the same liquid has an excess pressure:

    1. ΔP ÷ 2
    2. 2ΔP
    3. 4ΔP
    4. ΔP
    Show answer

    Answer: B. ΔP = 2T ÷ R is inversely proportional to R. Half the radius gives double the pressure.

Privacy · Terms · Refunds · Delivery