- Practice
- About 15 min
- 5 practice questions
Surface tension forces and work: frames, rings, needles and bubbles in liquid
Calculate the pull on a wire frame, a ring and a floating needle, the work in enlarging a film, and the pressure inside a bubble under water.
If something looks wrong, please tell us.
Surface tension questions come in a few set shapes. The key is to count the length of the line along which the surface pulls, and the number of surfaces. Once these are counted, the force is simply T × length. Take T = 0.07 N/m for water and T = 0.03 N/m for soap solution, as illustrative values.
How to count
- Soap film on a frame: the film has two surfaces, so a movable wire of length l is pulled by F = 2Tl.
- Ring or plate lifted from water: the extra pull is T times the total length of the contact line. For a thin ring with inner and outer radii r₁ and r₂, that is T × 2π(r₁ + r₂).
- Floating needle: the surface pulls up along both long sides, so the largest weight that can be held is 2Tl, for a needle of length l, when the surface is vertical at the edges.
- Work in enlarging a film: W = T × (increase in area), counting both surfaces of a soap film. This also equals force times distance.
- Air bubble inside a liquid: one surface, so the excess pressure is 2T ÷ r. The gauge pressure inside at depth h is hρg + 2T ÷ r.
Worked examples
Example 1: sliding wire. A soap film (T = 0.03 N/m) is stretched on a frame with a sliding wire of length 0.1 m. The pull is F = 2 × 0.03 × 0.1 = 0.006 N. Pulling the wire out a distance of 2 cm does the work W = F × x = 0.006 × 0.02 = 1.2 × 10⁻⁴ J. Check: area increase = 2 × 0.1 × 0.02 = 4 × 10⁻³ m² and T × area = 0.03 × 4 × 10⁻³ = 1.2 × 10⁻⁴ J.
Example 2: ring lifted from water. A thin ring has an inner radius of 3.0 cm and an outer radius of 3.2 cm. The total contact line = 2π(0.030 + 0.032) = 2π × 0.062 = 0.390 m. The extra pull from the water = 0.07 × 0.390 = 0.0273 N, which has to be added to the ring's weight when it is just being lifted out.
Example 3: floating needle. A needle 4 cm long is placed carefully on water. Largest weight supported = 2Tl = 2 × 0.07 × 0.04 = 5.6 × 10⁻³ N, which corresponds to a mass of about 0.56 g. A heavier needle would sink.
Example 4: bubble in a liquid. An air bubble of radius 1 mm lies 0.5 m below the surface of water. Excess pressure from surface tension = 2 × 0.07 ÷ 10⁻³ = 140 Pa. Pressure from the water column = 0.5 × 1000 × 10 = 5000 Pa. Gauge pressure inside the bubble = 5000 + 140 = 5140 Pa above the atmospheric pressure at the surface.
Example 5: bubble comparison. A soap bubble has twice the radius of another one of the same solution. Excess pressure is inversely proportional to the radius, so the larger bubble has half the excess pressure of the smaller one.
Force = T × length of contact line. Soap film: two surfaces, so 2Tl. Work = T × increase in area. Air bubble in liquid: 2T ÷ r.
Traps
- Using one surface for a soap film or two surfaces for a bubble in a liquid.
- Measuring the length of the line wrongly, for example using the area in place of the length.
- Converting cm to m only partly.
Key takeaways
- Count the contact line and the number of surfaces before using the formula.
- Work equals surface tension times the new area.
- Gauge pressure of a bubble in water adds hρg to 2T ÷ r.
Check your understanding
-
1. A soap film (T = 0.04 N/m) on a frame has a movable wire of length 0.05 m. The force on the wire is:
- 2 × 10⁻³ N
- 4 × 10⁻³ N
- 8 × 10⁻³ N
- 1 × 10⁻³ N
Show answer
Answer: B. F = 2Tl = 2 × 0.04 × 0.05 = 4 × 10⁻³ N.
-
2. Work done in increasing a soap film by an area of 10⁻³ m² on one side is (T = 0.03 N/m, two surfaces):
- 3 × 10⁻⁵ J
- 6 × 10⁻⁴ J
- 1.5 × 10⁻⁵ J
- 6 × 10⁻⁵ J
Show answer
Answer: D. Total new surface = 2 × 10⁻³ m². W = 0.03 × 2 × 10⁻³ = 6 × 10⁻⁵ J.
-
3. The largest weight a needle of length 5 cm can have to float on water (T = 0.07 N/m) is:
- 7 × 10⁻³ N
- 3.5 × 10⁻³ N
- 1.4 × 10⁻² N
- 7 × 10⁻² N
Show answer
Answer: A. Weight ≤ 2Tl = 2 × 0.07 × 0.05 = 7 × 10⁻³ N.
-
4. The excess pressure inside an air bubble of radius 0.5 mm in water (T = 0.07 N/m) is:
- 56 Pa
- 560 Pa
- 140 Pa
- 280 Pa
Show answer
Answer: D. A bubble in a liquid has one surface: ΔP = 2T ÷ r = 0.14 ÷ 5 × 10⁻⁴ = 280 Pa.
-
5. Soap bubble A has radius r and soap bubble B has radius 3r, both of the same solution. The ratio of their excess pressures A : B is:
- 1 : 3
- 3 : 1
- 9 : 1
- 1 : 9
Show answer
Answer: B. ΔP = 4T ÷ R is inversely proportional to R, so A has 3 times the excess pressure of B: 3 : 1.
Sign in to keep track of the lessons you finish.